Ice-O-Matic CD300 - Manuals

Ice Machine Installation CD300 Page 5 All models: Place the dispenser in the location where it will be used. Level the top edge of thedispenser front to back and left to right with the adjustable legs. Place the ice machine on the dispenser and secure it to the dispenser with the hardware andstraps....

Utility Connections CD300 Page 6 Drain Connections -Follow all applicable codes. As ice melts in the dispenser, the water must be drained away. It is critical that a proper drain beconnected to the dispenser. Remember that this is a gravity drain system, the drain tubing mustslope down a minimum of ...

Initial Start Up and Use CD300 Page 7 Final Check List 1. Is the ice machine properly installed?2. Is the dispenser level?3. Has the water supply been connected to the ice machine?4. Has the proper power been connected to the ice machine and dispenser? Note: When electrical power is supplied to the ...

Sanitation / Maintenance CD300 Page 8 Schedule An ice system represents a sizable investment of time and money in any company’s business. Inorder to receive the best return on that investment, periodic maintenance is required. It is the userresponsibility to see that the machine is properly maintain...

Component Identification CD300 Page 9 View when sink assembly is removed. Rotor as seen from the top. Inside view of ice chute. Rotor shaft.

Maintenance CD300 Page 10 Regular inspection and maintenance will provide the best assurance of trouble free operation. Begin by removing the sink assembly. Check the action of the ice chute and return springs. Return Springs Check and Tighten Fasteners Clean out the lower drain pan. Pour hot water ...

Service Diagnosis CD300 Page 11 Symptom Probable Cause Possible Correction Does not dispense. No power to dispenser. Check for power. Ice chute not all the way up. Push ice chute up. No ice in hopper. Check ice machine, it maybe off or the dispenser’sstorage capacity may havebeen exceeded. Dispenser...

Adjustments CD300 Page 12 The gear motor cam must be properly adjusted to properly position the dispensing rotor. 1. Disconnect electrical power to the dispenser.2. Locate the sink key, unlock sink and remove it from the dispenser. 3. Observe the position of the rotor through the cube chute. The rot...

Removal and Replacement CD300 Page 13 Rotor 1. Disconnect electrical power to the dispenser and ice machine. 2. At the back, remove two bolts securing the ice machine to the dispenser. If a bin thermostat is being used, pullthe thermostat capillary tube up and out of the hopper. 3. Push the ice mach...

Wiring Diagram CD300 Page 14 Button Dispensing Model CD300P

Schematic Diagram CD300 Page 15 Button Dispensing Model CD300P

Before Calling For Service CD300 Page 20 Check these things. 1. Is the dispenser plugged in?2. Has the dispenser’s internal switch been switched to the ON position? 3. Is the ice machine plugged in?4. Has the ice machine’s internal switch been switched to the ON position? 5. Is there ice in the disp...