Page 2 - INDEX; Hardware Packing List; Instructions for Switches and LED Indicators on front panel; modules
ZZ17-W2001-B 2 INDEX 1. Introduction 2. Hardware Packing List 3. System Installation 3.1.Chassis Open 3.2.Motherboard Installation 3.3.Add-on Card Installation 3.4.CD–ROM Drive/FDD Installation. 3.5.Fixed HDD Cage , HDD Installation 3.6.Instructions for Switches and LED Indicators on front panel 3.7...
Page 3 - Operating Temperature:
ZZ17-W2001-B 3 1. INTRODUCTION YY-W2 series Server Chassis is designed in compliant with EEB3.0 specification (refer to www.ssiforum.org ) and ATXV2.1 (refer to www.formfactors.org) Mother Board: z YY-W2 is designed for extended ATX (12"x13"), in compliant with ATX spec, CEB and EEB3.0 spec....
Page 4 - Switches and LED Indicators on front panel; Power Fail LED [optional /reserved for Power Failure Signal]; Chassis Dimensions & Weight; Net Weight with Single Power Supply is 15Kg(33lbs)
ZZ17-W2001-B 4 Thermal Solution: z One(1) 120x120mm Cooling Fan is installed, rear mounted z Options of two (2) 60*60*25mm, rear mounted. Switches and LED Indicators on front panel z Power Switch (Push Switch) z Reset Button (Push Switch) z Power On LED (Green) z HDD LED (Orange flash) z FAN ALARM (...
Page 6 - System Installation; Motherboard Installation
ZZ17-W2001-B 6 3. System Installation 3.1 Chassis Open To release two (2) screws on the rear side of chassis, pull the side cover with handle. 3.2 Motherboard Installation Check mounting holes of motherboard, to screw the standoffs required to chassis. Put the Motherboard into the chassis, than scre...
Page 9 - How to use HDD brackets
ZZ17-W2001-B 9 To screw off four (4) screws in the front plate of chassis, the HDD cage could be removed from chassis, install HDD into cage. The cooling fan of HDD cage could be easy swap, release two thumb screws in the front of HDD cage, lift off the fan holder, swap fan and assembly again into c...
Page 10 - Instructions for Switches and LED Indicators on front panel
ZZ17-W2001-B 10 3.6 Instructions for Switches and LED Indicators on front panel The switches and led indicators on front panel have the functions as following: POWER SW: Push Switch, The system power on/off, connects to M/B. Reset SW: Push switch, connect to M/B x POWR LED: The system power LED (gre...
Page 14 - Slide into EIA cabinet