IBM IL1210 - Manuals

Les sikkerhetsinformasjonen (Safety Information) før du installerer detteproduktet. Antes de instalar este produto, leia as Informações sobre Segurança. Pred inštaláciou tohto zariadenia si pečítaje Bezpečnostné predpisy. Antes de instalar este producto lea la información de seguridad. Läs säkerhets...

About this book This manual contains instructions for setting up, using, maintaining, andtroubleshooting of the iL1210 IBM MicroPortable Projector. The manual isdivided into two parts: Part 1: Setup guide This guide contains the product description and expanded installationinstructions. Part 2: Appe...

viii iL1210 IBM MicroPortable Projector: User ’s Guide

Chapter 1. Installation and user’s guide Introduction The iL1210 IBM ® MicroPortable Projector is specifically designed for the mobile presenter. It generates crisp, clear images using Digital LightProcessing (DLP) technology and features an M1-DA connector. The projectoris easy to connect, use, tra...

Unpacking the projector The projector comes with the items shown in the following illustration. Checkto make sure that all items are included. Contact your dealer immediately ifanything is missing. If you are experienced in setting up presentation systems, use the Quick Start card that was included ...

1 Computer and video connectors 3 Zoom ring 5 Security lock 7 Power switch 2 Keypad 4 Focus ring 6 Power cord connector Usage guidelines Observe the following guidelines when using the projector. Caution: Do not look directly into the projection lens when the lamp is turned on. The bright light migh...

Setting up the projector Before turning on your projector, make sure all connections are made. Use thefollowing procedure to set up the projector: 1. Place the projector on a flat surface. v The projector must be within 3 meters (10 feet) of your power sourceand within 1.8 meters (6 feet) of your co...

DANGER Electrical current from power, telephone, and communication cables is hazardous. To avoid a shock hazard:— Do not connect or disconnect any cables or perform installation, maintenance, orreconfiguration of this product during an electrical storm.— Connect all power cords to a properly wired o...

Connecting a computer to the projector The projector comes with an analog computer cable. If your computer has adigital output port, you can use the optional digital computer cable, which issold separately. See “Accessories” on page 28 for ordering information. 1 To USB mouse 2 To computer video 3 T...

Connecting a video player Use the following procedure to connect a video player. v If your video player uses a round, one-prong composite video connector,use the composite video cable. v If your video player uses a round, four-prong S-video connector, use theS-video cable. S-video generates a higher...

DANGER Electrical current from power, telephone, and communication cables is hazardous. To avoid a shock hazard:— Do not connect or disconnect any cables or perform installation, maintenance, orreconfiguration of this product during an electrical storm.— Connect all power cords to a properly wired e...

3. Press the Power switch on the back of the projector. The fans start to run,and the LED on the top of the projector lights green until the startupscreen displays. It takes about one minute for the image to achieve fullbrightness. 4. If you connected a video player, turn it on. v The video image is...

Chapter 2. Using the projector This chapter describes how to use and make adjustments to the projector. Italso provides a reference to the keypad, remote control buttons and theoptions that are available from the on-screen menus. Basic image adjustment To adjust the image, do the following: v Make s...

The projector is equipped with a self-locking, quick-release elevator foot andbutton. To raise the projector: 1. Press and hold the elevator button 1 (see the following illustration). 2. Raise the projector to the height that you want, then release the button tolock the elevator foot 2 into position...

Using the remote control To use the Forward and Back buttons on the remote control to advance slidesin PowerPoint, you must connect the USB mouse connector on the computercable to the computer. See “Connecting a computer to the projector” on page 7for details. Point the remote control at the project...

Using the keypad and remote control buttons While the menus are displayed, the Source and Reset buttons on the keypadact as menu navigation and adjustment buttons, and the menu/select buttonacts as a select button. See “Using the on-screen menus” on page 18 fordetails. data video keystone forward ba...

Keystone (remote only) Use this feature to adjust the image vertically and make a square image. Pressthe Keystone + button to reduce the upper part of the image 1 , and press the Keystone - button to reduce the lower part 2 . You can also adjust the keystone from the Display menu. See “Display menu”...

Using the on-screen menus The projector has menus that enable you to make image adjustments andchange a variety of settings. These adjustments are not available directly fromthe keypad. Note: Some menu items might be unavailable at certain times (grayed out ordimmed). This indicates that the item is...

Display menu To access the Display menu settings, press the Menu/Select button to displaythe Main menu, press the down arrow to highlight Display, then pressMenu/Select again to access the Display menu. Keystone This option helps to keep the image square as the angle of projection. Use thisfeature t...

Use the up and down arrows to highlight Tint, press Menu/Select, use thearrows to adjust the tint, then press Menu/Select to accept your changes. Color The color setting adjusts a video image from black and white to fullysaturated color. Use the up and down arrows to highlight Color, pressMenu/Selec...

1. Turn Auto Image off. 2. Highlight Horizontal position , and then press Menu/Select, use the arrow buttons to adjust the Horizontal position, then press Menu/Select. Positioning adjustments are saved when you turn off the projector. Vertical position Follow these steps to manually adjust the verti...

Video standard (video sources only) When Video is set to Auto, the projector attempts to pick the video standard(NTSC, NTSC 4.43, PAL, or SECAM) automatically based on the input signalit receives. (The video standard options may vary depending on your regionof the world.) If the projector is unable ...

Advanced menu To access the Advanced menu settings, press the Menu/Select button todisplay the Main menu. Press the down arrow to highlight Advanced; thenpress Menu/Select again to access the Advanced menu. Rear projection When you turn Rear Projection on, the projector reverses the image so you can...

Status menu This is a read-only menu for informational purposes. To display the Statusmenu, highlight Status from the Main menu, then press Menu/Select. Lamp hours used Indicates how many hours the current lamp has been in use. The counterstarts at zero hours and counts each hour the lamp is in use....

Appendix A. Product specifications Specifications The iL1210 Projector must be operated and stored within the temperature andhumidity ranges specified. Temperature Operating 50 to 104° F (10 to 40° C) at sea level50 to 95° F (10 to 35° C) at 10,000 feet Non-operating -4 to 158° F (-20 to 70° C) Alti...

Accessories There are many accessories available for your projector and new ones areadded frequently. Please refer to http://www.infocus.com/ and select fromthe many accessories for you to purchase. 28 iL1210 IBM MicroPortable Projector: User ’s Guide

Appendix B. Maintenance and troubleshooting This section describes how to: v Clean the lens v Replace the projection lamp v Replace the batteries in the remote v Use the security lock feature v Troubleshoot the projector Cleaning the lens Follow these steps to clean the projection lens: 1. Apply a n...

Replacing the projection lamp WARNING: To avoid burns, allow the projector to cool for at least 30 minutes beforeyou open the lamp access grill. Never extract the lamp module while theprojector is operating. The lamp hour counter in the Status menu counts the number of hours thelamp has been in use....

5. Loosen the captive screw on the lamp module. WARNING: Never operate the projector with the lamp access grill removed.This disrupts the air flow and causes the projector to overheat. 32 iL1210 IBM MicroPortable Projector: User ’s Guide

Replacing the batteries in the remote control The life of the batteries depends on how often and how long you use theremote control. Symptoms of low battery charge include erratic responseswhen using the remote control and a reduced range of operation. Follow these steps to replace the batteries: 1....

Using the security lock The projector has a security connector to use with a computer lock system. Goto http://www.compu-lock.com for ordering information. Refer to theinformation that comes with the lock for instructions on how to secure it tothe projector. Note: The lamp cannot be removed while th...

Troubleshooting Problem: The projector is not running. v Make sure that the power cord is properly connected to a fully functionalac electrical outlet. Make sure that the power cord is also properlyconnected to the projector. v If the projector is plugged into a power strip, make sure the power stri...

Problem: Projected colors don’t match the computer or video player color . Just as there are differences in the displays of different monitors, there areoften differences between the computer image and the projected image. Adjustthe brightness, tint and/or contrast from the Display menu. See “Bright...

Appendix C. Portable and mobile computer activation Many mobile computers do not automatically turn on their external videoport when a projector is connected. Activation commands for some mobilecomputers are listed in the following table. (If your computer is not listed orthe given command does not ...

Appendix D. Using video mirroring Using video mirroring with a PowerBook computer When you turn on video mirroring (called SimulScan in newer PowerBookcomputers), the projector displays the same information that appears on aPowerBook built-in screen. When video mirroring is off, the projector operat...

Appendix E. Projected image size Use the following graph and table to help you determine projected imagesizes. 50 100 150 200 300 250 350 5 10 0 15 20 25 30 Diag onal Image Size (inches) Distance to Screen (feet) maximum image size minimum image size (106.7m) (91.4m) (76.2m) (45.7m) (15.2m) (1.5m) (...

Appendix F. Help and service information This section contains information on how to obtain online and telephonetechnical support. Online technical support Online technical support is available during the life of your product. Onlineassistance can be obtained through the Personal Computing Support W...

For the support telephone number and support hours by country, refer to thefollowing table or to the enclosed technical support insert. Support phonenumbers are also available by clicking HelpCenter phone list on the IBM support Web page at http://www.ibm.com/pc/support If the number is not provided...

Appendix G. Product warranties and notices This section contains the warranty period for your product and the IBMStatement of Limited Warranty. Machine - iL1210 IBM MicroPortable Projector Warranty period* - Three years * Contact your place of purchase for warranty service information. Some IBM Mach...

CRUs to you for replacement by you. You must return all defective CRUs toIBM within 30 days of your receipt of the replacement CRU. You areresponsible for downloading designated Machine Code and Licensed InternalCode updates from an IBM Internet Web site or from other electronic media,and following ...

regardless of the basis on which you are entitled to claim damages from IBM(including fundamental breach, negligence, misrepresentation, or othercontract or tort claim), except for any liability that cannot be waived orlimited by applicable laws, IBM is liable for no more than 1. damages for bodily ...

The following is added to this Section: Disputes and differences arising out of or in connection with this Agreementshall be finally settled by arbitration which shall be held in Singapore inaccordance with the rules of the International Chamber of Commerce (ICC).The arbitrator or arbitrators design...

JAPAN Governing Law: The following sentence is added to this Section: Any doubts concerning this Agreement will be initially resolved between usin good faith and in accordance with the principle of mutual trust. NEW ZEALAND The IBM Warranty for Machines: The following paragraph is added to this Sect...

EUROPE, MIDDLE EAST, AFRICA (EMEA) THE FOLLOWING TERMS APPLY TO ALL EMEA COUNTRIES: The terms of this Statement of Limited Warranty apply to Machines purchasedfrom IBM or an IBM reseller. Warranty Service: If you purchase an IBM Machine in Austria, Belgium, Denmark, Estonia,Finland, France, Germany,...

and the legal relations between the parties will be determined in accordancewith the French laws and all disputes arising out of this Agreement or relatedto its violation or execution, including summary proceedings, will be settledexclusively by the Commercial Court of Paris; 4) Angola, Bahrain, Bot...

1. (unchanged) 2. as to any other actual damage arising in all situations involvingnonperformance by IBM pursuant to, or in any way related to the subjectmatter of this Statement of Warranty, IBM’s liability, will be limited to thetotal amount you paid for the Machine that is the subject of the clai...

Trademarks The following terms are trademarks of the IBM Corporation in the UnitedStates or other countries or both: IBMHelpCenterPS/2 Microsoft, PowerPoint and Windows are trademarks or registeredtrademarks of Microsoft in the United States or other countries or both. Other company, product, and se...

Cet appareil numérique de la classe A est conform à la norme NMB-003 duCanada. Deutsche EMV-Direktive (electromagnetische Verträglichkeit) Dieses Gerät ist berechtigt in Übereinstimmung mit dem deutschen EMVGvom 9.Nov.92 das EG-Konformitätszeichen zu führen. Der Aussteller der Konformitätserklärung ...

Ce produit est conforme aux exigences de protection de la Directive89/336/EEC du Conseil de l’UE sur le rapprochement des lois des Étatsmembres en matière de compatibilité électromagnétique. IBM ne peut accepter aucune responsabilité pour le manquement auxexigences de protection résultant d’une modi...