IBM 65E - Manuals - manualsarea.com

Page 2 - 4 Avenue du Québec

The reproduction of this material, in part or whole, is strictly prohibited. Foradditional information, please contact: 14 Avenue du Québec Bât. K2 EVOLIC - BP 728 91962 Courtabœuf cedex - FRANCE Tel.: 33 1.69.28.27.27Fax: 33 1.69.28.82.04Email: [email protected] The information in this document is subj...

Page 4 - The AXEL AX3000 Terminal is based on a modular concept.; standard keyboard

The AXEL AX3000 Terminal is based on a modular concept. VGA / SVGAstandard monitor standard keyboard AX3000 The AX3000 is totally designed and manufactured by Axel. The terminal'selectronics is contained within a slim base unit which provides connectionsfor a VGA or SVGA monitor, keyboard, system pr...

Page 7 - Installation

Installation ________________________________________________________________Installation Guide - Model 65E 3 Make sure the AX3000 and monitor power switches are in the OFF (0) positionbefore connecting cables to the back panel. 1 : On 0 : Off 2.2.1 - Monitor and keyboard Plug in the VGA monitor cab...

Page 11 - Quick Installation; - QUICK INSTALLATION; The following command sequence is used to enter the AX3000 Set-Up:

Quick Installation ________________________________________________________________Installation Guide - Model 65E 7 3 - QUICK INSTALLATION This chapter describes the quick set-up procedure for the TCP/IP Platineterminal. The following command sequence is used to enter the AX3000 Set-Up: All the AX30...

Page 13 - Connector Pin Assignments; - CONNECTOR PIN ASSIGNMENTS; a - AX3000 Connected to a HUB

Connector Pin Assignments ________________________________________________________________Installation Guide - Model 65E 9 4 - CONNECTOR PIN ASSIGNMENTS This chapter describes the connector pin assignments for the different ports ofthe AX3000 Model 65E. 4.1 - ETHERNET PORT RJ45 (10BT) Recommended wi...

Page 14 - b - AX3000 Connected to an Ethernet Controller

Connector Pin Assignments ________________________________________________________________10 Installation Guide - Model 65E b - AX3000 Connected to an Ethernet Controller IMPORTANT: the cable is composed of two twisted pairs. The two wiresTX+ / TX- must belong to one pair and the two wires RX+ / RX-...

Page 19 - Problem Solving; - THE VGA MONITOR VERTICAL SYNC IS LOST; Check there is power at the wall outlet and power cord connections.; - CONTINUOUS TONE SOUNDS AFTER THE TERMINAL HAS BEEN

Problem Solving ________________________________________________________________Installation Guide - Model 65E 15 5 - PROBLEM SOLVING This chapter describes some of the problems, that may occur during installationof the AX3000 Model 65E, and offers possible solutions. - THE VGA MONITOR VERTICAL SYNC...

Page 20 - - AFTER THE TERMINAL HAS BEEN SWITCHED ON, THE MESSAGES

Problem Solving ________________________________________________________________16 Installation Guide - Model 65E - AFTER THE TERMINAL HAS BEEN SWITCHED ON, THE MESSAGES 'NO ETHERNET BOARD PRESENT' AND 'CANNOT ATTACHETHERNET BOARD' APPEAR This message indicates a hardware failure. Report the problem...

Page 21 - - INCORRECT APPEARANCE OF SOFTWARE DISPLAYED ON THE; Check that the; - THE CONNECTED PRINTER DOES NOT WORK

Problem Solving ________________________________________________________________Installation Guide - Model 65E 17 - NO LOGIN WHEN THE 'CONNECTING...' MESSAGE IS DISPLAYED Check the Ethernet cables are correctly connected and networked devices(hubs or servers) are switched on. No connection (and no l...