Huffy NT9110 - Manuals - manualsarea.com

Page 2 - WARNING

2 P/N 211550A 07/01 WARNING FAILURE TO FOLLOW THESE WARNINGS MAY RESULT IN SERIOUS INJURY AND/OR PROPERTY DAMAGE. Owner must ensure that all players know and follow these rules for safe operation of the unit. See instruction manual for proper installationand maintenance.Use caution when performing d...

Page 3 - BAC; DO NOT REMOVE; REMOVE AND; TWO PERSON MINIMUM

HERC01.EPS211291 W A R N IN G BAC KBO AR D Use a fork lift to remove unit from truckand carefully remove packing materials. Remove backboard, lower pad (1) andboth shroud covers (2 and 3). 1. IMPORTANT! WRITE DOWN MODEL NUMBER FROM BOX ON PAGE 1 OF THIS OWNERS MANUAL 1 3 07/01 P/N 211550A Remove the...

Page 4 - Raise main post upward into playing position.; Ballast Installation; CLEAR; SET BRAKE

4 P/N 211550A 07/01 Remove extension arm (4) from slide postbrackets as shown. 4. Cut stabilizing strap and set brake so unit willnot roll. Raise main post upward into playing position. 5. HERC05.EPS211291 HERC03.EPS 211291 K E E P H A N D S C L E A R WA RN ING Ballast Installation 6. HERC04.eps2112...

Page 5 - BALLAST; BALLAST; BALLAST; DO NOT USE UNIT

HERC08.EPS211291 WA R N IN G 5 07/01 P/N 211550A Attach lower front pad (1) to unit as shown. 8. 9. Install 640 lbs. (290 kg) of ballast. Securewith straps. NOTE: Equal weight on each siderequired. HERC09.EPS211291 WA R N IN G 80 LB (36 KG) BALLAST BALLAST 80 LB (36 KG) BALLAST 80 LB (36 KG) BALLAST...

Page 6 - Attach bracket (37) to backboard and support structure

6 P/N 211550A 07/01 12. 13. 11. Attach bracket (37) to backboard and support structure by inserting bolts (14) through washers (15) and top holes in bracket (37), Tighten nuts (16) completely. Peel and stick foam pad (12) to front of board, behind bracket (37) . Install carriage bolt (39) through ri...

Page 7 - BOTTOM VIEW; Do not over tighten as rim will not; NOTE

7 07/01 P/N 211550A 14. 11 41 36 36 40 31 37 38 Insert spacer (40) through rim assembly (11). Place rim assembly on bracket (37) so the cariage bolt (39) isinserted through hole on top of inner bracket (38). Install bolt (41), washers (36) and nut (31) through top holeson bracket (37) as shown.Tight...

Page 8 - RIM LEVELING INSTRUCTIONS:; NOTE ORIENTATION OF COVER PLATE; OUTSIDE VIEW

8 P/N 211550A 07/01 16. 17. 18. RIM LEVELING INSTRUCTIONS: Install cover plate (20) on rim (11) using selftapping screws (21) as shown. Place level on rim (11) and adjust nut (31) untillevel. Tighten nut (42) to set rim tension forplaying. Secure net (32) to rim (11). 1 2 3 32 11 NOTE ORIENTATION OF...

Page 10 - Position

10 P/N 211550A 07/01 Loosen nut located at top of postbehind pole mast (Refer to Steps 6and 7) and carefully lower pole mastas shown. Insert extension arm and backboardassembly into place and secure asshown. (Refer to Step 4) 21. 22. WA RNI NG 23. XHRC5405.EPS 211291 WA RNI NG Lift backboard upward ...

Page 11 - Raise pole mast into playing position.

11 07/01 P/N 211550A XVAR07.EPS211492 W A R N IN G 24. Raise pole mast into playing position. Re-tighten nut located at top of post behind mast. (Refer to Step 7) 25. 26. Remove bolt at end of postbrackets. Rotate extension armand up into playing position andre-insert bolt to secure. XVAR06.EPS21149...

Page 12 - Remove tagged bolt at top of slide post.; Height Adjustment

12 P/N 211550A 07/01 Remove tagged bolt at top of slide post. 27. Height Adjustment HERC13g.EPS211292 W A R N IN G RE-INSERT TAGGED BOLT FOR STORAGE! FAILURE TO DO SO MAY RESULT IN SERIOUS BODILY INJURY AND/OR PROPERTY DAMAGE. WARNNG.EPS WARNING AVERTISSEMENT ADVERTENCIA AVVERTENZA ATENÇÃO ADVARSEL ...

Page 13 - Ground Installation; INSTALLATION; Regulation Rim; FLOOR SCREW NOT

13 07/01 P/N 211550A Ground Installation Place unit in desired location. Secure unit toground or flat surface as shown. 29. HERC17.EPS211291 HERC16.EPS211291 35 IN-GROUND INSTALLATION FLAT SURFACE INSTALLATION 34 HERC18.EPS211291 35 10FT_VAR.EPS 211492 10 feet (3.05 m) Regulation Rim Height is 10 Fe...

Page 14 - PARTS LIST; HARDWARE IDENTIFIER

14 P/N 211550A 07/01 PARTS LIST Item #14 (4) Item #16 (6) Item Qty. Part No. Description 1 1 206597 Pad, Lower Front 2 1 206592 Shroud, Right Cover 3 1 206593 Shroud, Left Cover 4 1 206574 Extension Arm 5 1 206556 Flat Wrench 6 5 206572 Bolt, Slotted Pan Head, 1/4”-20 7 5 206143 Washer, Locking 1/4”...