Huffy 1310 - Manuals

Huffy 1310 – Manual in PDF format online.

Manuals:

Manual

Manual Huffy 1310

Summary

Page 2 - WARNING

2 P/N 214653B 05/03 WARNING FAILURE TO FOLLOW THESE WARNINGS MAY RESULT IN SERIOUS INJURY AND/OR PROPERTY DAMAGE. Owner must ensure that all players know and follow these rules for safe operation of the system. • DO NOT HANG on the rim or any part of the system including backboard, support braces or...

Page 3 - SAFETY INSTRUCTIONS; Use caution when using this system.; MOVING SYSTEM; HEIGHT ADJUSTMENT

05/03 P/N 214653B 3 SAFETY INSTRUCTIONS FAILURE TO FOLLOW THESE SAFETY INSTRUCTIONS MAY RESULT IN SERIOUS INJURY OR PROPERTY DAMAGE AND WILL VOID WARRANTY. Owner must ensure that all players know and follow these rules for safe operation of the system. To ensure safety, do not attempt to assemble th...

Page 4 - or

4 P/N 214653B 05/03 For more information on assembly, placement, properuse and maintenance, visit The American BasketballCouncil website at http://www.smarthoops.com. IMPORTANT! Remove all contents from boxes. Be sure to check inside pole sections; hardware and additional parts are packed inside. NO...

Page 5 - FRONT

05/03 P/N 214653B 5 Get to know the basic parts of your basketball system..... STRUTS BACKBOARD FRONT RIM WHEEL CARRIAGE ASSEMBLY BASE POLE

Page 7 - * You may have extra parts with this model.

05/03 P/N 214653B 7 HARDWARE IDENTIFIER (BOLTS & STEEL RODS) HARDWARE IDENTIFIER (NUTS & WASHERS) HARDWARE IDENTIFIER (PLASTIC SPACERS & CLIPS) Item #14 (1) Item #12 (6) Item #10 (1) Item #16 (2) Item #17 (6) Item #21 (4) Item #28 (2) Item #22 (4) Item #23 (2) Item #8 (1) Item #11 (1) It...

Page 8 - ASSEMBLE THE BASE

8 P/N 214653B 05/03 TOOLS REQUIRED FOR THIS SECTION HARDWARE USED IN THIS SECTION (not actual size) SECTION A: ASSEMBLE THE BASE 9/16” and 1/2” 9/16” and 1/2” AND/OR This is what your system will look likewhen you’ve finished this section: Item #14 (1) Item #12 (6) Item #10 (1) Item #16 (2) Item #17...

Page 9 - Remove contents from tank; TOP; While maintaining alignment,; MIDDLE

05/03 P/N 214653B 9 1. 1 Remove contents from tank 4 6 TOP BOTTOM 5” (13 cm) 2. Correctly identify each polesection and mark indicateddistance from ends with tape(not supplied) as shown. 3. IMPORTANT! Center the alignment slot of middle pole section (5) in thelower hole of top pole section (4) as sh...

Page 10 - While maintaining alignment, bounce

10 P/N 214653B 05/03 4 5 6 WOOD SCRAP 4. IMPORTANT! Center the alignment slot of lower pole section (6) in the lowerhole of middle pole section (4) as shown. While maintaining alignment, bounce top and middle pole assembly (4 & 5) onto bottom section of pole (6) using woodscrap as shown until th...

Page 13 - ASSEMBLE THE BACKBOARD; OR

05/03 P/N 214653B 13 TOOLS REQUIRED FOR THIS SECTION HARDWARE USED IN THIS SECTION SECTION B: ASSEMBLE THE BACKBOARD 1/2” 1/2” OR This is what your system will look likewhen you’ve finished this section: Item #17 (6) Item #21 (4) Item #22 (4) Item #23 (2) Item #19 (12)

Page 14 - Final adjustments will be made in Step 11

14 P/N 214653B 05/03 17 21 22 20 18 31 Refer To Instructions Included With Rim Hardware For Rim Assembly. Mount brackets (20) and rim (18) to backboard and finger tighten as shown. NOTE: Final adjustments will be made in Step 11 1.

Page 15 - DO NOT LEAVE

05/03 P/N 214653B 15 2. SAWHORSE OR SUPPORT TABLE 3. While still in the horizontal position, carefully slide backboard componentsonto pole. Secure hardware at desired position as shown and tighten allhardware completely at this time. Support pole and tank assembly over support table. Carefully slide...

Page 16 - Install net clips. Installez les pinces du filet.

16 P/N 214653B 05/03 WARNING: Use of this product without proper installation of net clips, or when all net clips are not present could result in bodily harm. Be sure to follow directions carefully. AVERTISSEMENT : L'utilisation de ce produit sans installercorrectement ou toutes les pinces du filet ...

Page 17 - Das Netz anbringen

05/03 P/N 214653B 17 Install net. Installez le filet. Das Netz anbringen Instale la red. Insert net into bottom of clip as shown. Insérez le filet dans la base de la pince, comme illustré. Das Netz wie gezeigt unten in den Clip stecken. Introduzca la red en la parte inferior del sujetador como se mu...

Page 18 - APPLY HEIGHT AND MOVING LABEL & SECURING SYSTEM

18 P/N 214653B 05/03 1. Carefully upright assembly. Apply moving system label (15) to front of pole asshown. Regulation rim height is 10 feet (3.05 m). TWO PEOPLEREQUIRED FOR THISPROCEDURE. FAILURETO FOLLOW THISWARNING COULDRESULT IN SERIOUSINJURY AND/ORPROPERTY DAMAGE. WARNING! DO NOT LEAVE ASSEMBL...

Page 19 - SICHERHEITSHINWEISE; ARNUNG; ragbares Basketball-System Benutzerhandbuch; Huffy steht zur Qualität seiner Produkte!; HINWEIS A

19 05/03 P/N 214653B Universelle gebührenfreie Telefonnummer (Deutschland, Schweiz): 00 800 555 85234 SICHERHEITSHINWEISE Die meisten Verletzungen werden durch einen unvorschriftsmäßigen Gebrauch und/oder ein Mißachten der Sicherheitshinweise verursacht. Beim Gebrauch dieser Vorrichtung Vorsicht wal...

Page 21 - ADVERTENCIA; INSTRUCCIONES DE SEGURIDAD; ESCRIBA SU NÚMERO DE MODELO:; Manual del propiet; VISO P

21 05/03 P/N 214653B 00 800 555 85234 SI NO SE OBSERVAN ESTAS ADVERTENCIAS SE PUEDEN OCASIONAR LESIONES GRAVES Y/O DAÑOS MATERIALES El propietario debe asegurarse de que todos los jugadores onozcan y sigan estas reglas para la operación segura del istema . • NO SE CUELGUE del borde ni de ninguna par...

Page 23 - AVERTISSEMENT; CONSIGNES DE SÉCURITÉ; Equipement de basketball port; VIS AUX

23 05/03 P/N 214653B Numéro d’appel gratuit du service après-vente. Etats-Unis et Canada uniquement: 1-800-284-8339 Numéro vert international (France, Suisse) : 00 800 555 85234 TUFF STUFF® et les marques associées de Mattel, Inc. sont utilisées avec sa permission. Les produits Huffy ne sont nulleme...