Hotpoint SY23 - Manuals

The wires in the mains supply lead are coloured in accordance with the following code: Green and Yellow - E arth Blue - Neutral Brown – Live The connection must be made as follows:The wire colour ed Gr een and Yellow must be connected to the terminal marked ‘E’ or the earth symbol A or coloured gree...

CONNECTION TO THE GAS SUPPLY The supply system must be compliant with the current standards in the country of use. The type of gas for which the oven has been regulated is indicated on the serial number plate located on one of the side edges of the cavity (visible with the door open) and on the pack...

Adapting to the gas in use It is possible to use other types of gas by adapting the burner adjustment as follows:Make sure that the oven is not connected to the electric power supply. Open the oven door completely and remove the oven bottom unscrewing the screws.Remove the burner by unscrewing its s...

Adjusting the minimum The oven thermostat is equipped with a by-pass for the minimum.When the type of gas is changed, this adjustment must be adapted as follows: -if there is a glass front panel, it has to be removed by unscrewing the twofixing screws (fig. 4a) . -if there is a metal front panel, th...

BEFORE USING THE OVEN These instructions are only valid for the destination countries whose identificationsymbols are shown on the back cover of the appliance instruction booklet. To make the most of your new oven, read the users instructions carefully and keepthem on hand for consulting in the futu...

SWITCHING THE GAS GRILL ON To switch the gas grill on, proceed as follows: open the oven door; press the knob slightly and turn it clockwise to the end, to the grill position; the cooling fan starts; Please note that the electric ignition does not have to be pressed more than 15 seconds. If the burn...

ELECT R ONI C CLOCK The electronic clock has more than one function: - Displaying the time of day - Switching off the oven with the timer Se t t i ng t he t i m e o f day - Press button A- Set the right time using button B o C. The function is activated 7 seconds after your last action. Se t t i ng ...

CLEANING THE APPLIANCE Always allow the appliance to cool down before cleaning to avoida burn injury. Do not use caustic or abrasive agents, coarse wire wool or hardtools as these can damage the surface finishes. Normally, wiping with a soft cloth dampened with hot detergent issufficient, but for st...

REMOVING THE OVEN DOOR To facilitate cleaning inside the oven, the door can be removed as follows: Hinges “A” are provided with two movable bolts “B”. When bolt “B” is raised, the hinge is released from its housing.Having done this, the door must be lifted upwards and removed,sliding it towards the ...

REPLACING THE OVEN LIGHT (fig. 3) (Not covered by the appliancewarranty) Disconnect the appliance from theelectricity supply, remove the ovendoor (as described previously) aswell as the oven shelves. Remove the protective glass light-cover by twisting anti-clockwise. Unscrew the old bulb and discard...

INSTRUCTIONS FOR INSTALLING KNOB GUARD OPEN OVEN DOOR INSTALL KNOB GUARD IN SLOTS OF FRONT FASTEN KNOB GUARD ONTO FRONTBY MOVING IT TO THE RIGHT MAKE SURE THE KNOB GUARD IS ATTACHEDBY PULLING IT OUTWARDS CLOSE OVEN DOOR ATTENTION:During operation the knob guard gets very hot.Use kitchen gloves. GB 1...