Hoover Vacuum Cleaner- Manuals

13. Carpet height control: slide knob to correct setting for height of carpet being cleaned. 14. Headlight 15. ‘Dirt FINDER’ display*16. Embedded ‘Dirt FINDER’ sensitivity switch* 17. Check bag indicator18. Bag door19. Cord hooks: wrap cord around hooks for storage. The top hook can be rotated right...

BRUSH ROLL CARPET HARD ON OFF 2-9 Brush roll control Note: When handle is in uprightposition, brush roll is automaticallyOFF. Move the brush roll control only whenthe handle is in the upright position. Slide control to “Carpet” to turn brushroll ON for cleaning carpet or rugs. Slide control to “Hard...

7 Automatic brush rollindicator (some models only) When red is in the OFF window, brushroll is STOPPED. When red is in the ON window brush rollis ROTATING. AUTOMATIC BRUSH ROLL ON OFF 2-10 2-11 2-12 2-13 Cleaning lightweightflexible rugs Stand on one end of rug and movecleaner toward other end or ed...

8 2-19 K Check bag indicator (some models only) The indicator (K) will begin to show red asthe filter bag fills with dirt. There are three conditions that will causethe indicator to become completely red: 1. If the bag is full; change the bag. 2. If very fine materials have been pickedup, clogging t...

Replacing final filter The final filter assists in the filtration process to return clean air to the room. If filter becomes dirty, hand wash filter incold water with mild detergent, then airdry. To remove final filter, first open the dooron the side of the cleaner (Fig. 3-5). Grasp filter (B) and p...

3-12 3-11 D C 3-9 3-10 Belt replacement The belts are located under the bottomplate of the cleaner and should bechecked from time to time to be surethey are in good condition. The flat (wide) belt is described below; the other is described under “Brush rollreplacement”. When to replace Disconnect cl...

Installing brush roll Grasp brush roll and fit it into position byfirst sliding end, opposite the belt, intothe rectangular slot (G) on side of clean-er.Push other side of brush roll (H) intoplace. Belt may fit loosely when proper-ly installed. Reposition flat belt and bottom plate (Figs. 3-12 and 3...

12 3-22 3-24 3-23 E Powered hand tool Belt replacement The powered hand tool belt is designedto last a long time and is not normallyreplaced. However, if the belt is crack-ed, gouged or broken, it should bereplaced. 6. With curved ends down, slide endplates (C) of brush roll into slots (E) ontool. 7...

13 Service To obtain approved HOOVER serviceand genuine HOOVER parts, locate thenearest Hoover Factory Service Center or Authorized Hoover WarrantyService Dealer (Depot) by: • checking the Yellow Pages under “Vacuum Cleaners - Household” OR- • checking the list of Factory Service Centers provided wi...

14 4-2 Full One Year Warranty (Domestic Use) Your HOOVER® appliance is warrantedin normal household use, in accordancewith the Owner’s Manual against originaldefects in material and workmanship fora period of one full year from date ofpurchase. This warranty provides, at nocost to you, all labor and...

¡Salvaguardias importantes! Al usar un artefacto eléctrico observe siempre las precauciones básicas, incluyendo la siguientes: LEA TODA LAS INSTRUCCIONES ANTES DE USAR ESTE ARTEFACTO Advertencia: Para reducir el riesgo de incendio, choque eléctrico o lesiones: • No use el artefacto a la intemperie o...

Esta aspiradora fue inspeccionada yempacada cuidadosamente antes de salirde fábrica. En caso de necesitar ayudadurante el ensamble u operación, llame al 1-800-944-9200 para una referencia automática de la ubicación de los cen-tros de servicio autorizados (EE.UU.solamente) O 1-330-499-9499 para habla...

Haga funcionar la aspiradora solamente alvoltaje especificado en la placa de datosque se encuentra en la parte inferior de laaspiradora. Esta aspiradora está diseñada para usodoméstico. Interruptor de encender-apagar Enchufe el cordón en la toma de corrienteeléctrica.Para encender la aspiradora, emp...

Continúe levantando el frente de laaspiradora de modo que al llegar a la orillaesté totalmente fuera de la alfombrilla. Mueva hacia atrás la aspiradora paracomenzar nuevamente, baje el frente de laaspiradora, y diríjala solamente haciaadelante. Limpieza de las orillas La aspiradora tiene limpiaorill...

filtración de alergenos HEPA tipo Y. Es imperativo que use únicamente lasbolsas de filtro genuinas HOOVERdistribuidas por The Hoover Company paraasegurar que su aspiradora funcione almáximo de su eficacia. Las bolsas depapel HOOVER se identifican por estasmarcas comerciales - Cómo cambiar la bolsa D...

Reemplazo de la correa Cuando reemplace la correa, pida la pieza No. 38528037 de HOOVER . 1. Retire la placa inferior, el protector de lacorrea y el rodillo de escobillas como semuestra en las figuras 3-19 a 3-21. 2. Sostenga la turbina (E) y jálela con firmeza para sacarla. 3. Saque la correa de la...

• Deslizarlo a la posición activado (ON) Causa posibleSolución posible• El rodillo de escobillas está en la posición de apagado (OFF) • Mueva el control del rodillo de escobillas a la posición de encendido (ON) paraaspirar alfombras (carpet) • La banda plana está rota o desgastada• Cambie la banda p...

Précautions importantes ! Lors de l'utilisation d'un appareil électrique, observez toujours les précautions de base, en particulier les suivantes : LISEZ TOUTES LES INSTRUCTIONS AVANT D'UTILISER CET APPAREIL Avertissement : Pour réduire le risque d'incendie, d'électrocution ou de blessure : • N'util...

Cet aspirateur a été inspecté et soigneuse-ment emballé avant d’être expédié de l’u-sine. Si vous avez besoin d’aide pendantl’assemblage ou le fonctionnement,veuillez appeler le : Hoover Canada –1-800-463-3923 (Montréal) Contenu de la caisse Sortez toutes les pièces de la caisse et identifiez chaque...

Des peignes latéraux spéciaux sont fournissur les deux côtés à l’avant de l’aspirateurpour retirer la saleté de la moquette prèsdes plinthes et du mobilier. Guidez chaque côté parallèlement au bordde moquette ou de mobilier. Fixation du capot d’accessoires Le capot d'accessoires est amoviblelorsqu'i...

ment Débranchez l'aspirateur de la priseAvertissement – l’agitateur peut se met-tre en marche soudainement.Débranchez l’aspirateur lorsqu’il estretourné. Lorsque les brosses de l'agitateur sont usées,l'agitateur doit être remplacé. Pour vérifier l'état des brosses, déplacez lebord d'une carte en tra...

29 ils sont usés. Remplacement Lors de l'achat d'une paire de peigneslatéraux, demandez la pièce HOOVER nº39511004. Mode de remplace- ment Débranchez l'aspirateur de la prise élec-trique.Avertissement – L’agitateur peut se met-tre en marche brusquement.Débranchez l’aspirateur lorsqu’il estretourné.D...

30 • Faible succion de l’aspirateur • Consulter la section « Perte desuccion » Débouchages Débranchez l'aspirateur de la prise.Avertissement – L’agitateur peut démar-rer brusquement. Débranchez l’aspira-teur lorsqu’il est retourné.Une aspiration faible peut être due à uncolmatage. Voir la procédure ...

CLEANING TOOLS ! IMPORTANT! When using cleaning tools, the cleaner must be kept in the upright position, particularly when cleaning stairs. The nozzle height should also be set to tool mode. Remove hose from the hose socket. Remove the crevice tool from the extension tube. Fit the extension tube to ...

EMPTYING THE DUST CONTAINER Hold the container over the Bin and press the easy open button at the rear of the container. The dust container door will open and you can empty into a bin with no dust contact. Once emptied, gently tap or shake the container to release any excess dust from the filters. D...

CHANGING THE BELT OR BRUSHES CLEARING A BLOCKAGE IMPORTANT: Switch the cleaner off and remove the plug from the electricity supply before dismantling cleaner IMPORTANT: Switch the cleaner off and remove the plug from the electricity supply before dismantling cleaner If your cleaner is not picking up...

Genuine HOOVER Spares Tel. 08443 712 758 www.hooverspares.com Always replace parts with genuine Hoover spares. When ordering parts, always quote your model number. Hoover Customer Helpline Should any faults occur with your cleaner during the first 12 months, contact the Hoover Customer Helpline on t...

WARNING A thermal cut out switches off the cleaner to prevent overheating if it is used when full or there is a blockage or dirty filters. If this should happen switch off, unplug and correct the fault. It will take approximately 30 minutes for the cut out to automatically reset. User checklist If y...