Hisense HWFL1014V - Manuals

Page 4 - you have; SAFETY INFORMATION

1 The manufacturer reserves the right for any modifications on the product which might be deemed necessary or useful without informing about it in this IFU. Before operating your new washing machine, please read this instruction carefully, and keep it for future reference. If you have lost it accide...

Page 5 - − staff kitchen areas in shops, offices and other working

ensure Ensure Single inlet - Dual inlet - and cold only Ensure that the ventilation openings in the base of the washing machine (if available on your model) are not obstructed by a carpet or other material. 2 3 9. For appliances with ventilation openings in the base, that a carpet must not obstruct ...

Page 7 - Type of fabric / care label symbol; BEFORE THE FIRST WASH CYCLE

Control panel layout and appearance will depend on the model. 6 7 Clean the outside of the washing machine with a damp cloth. Do not use abrasive detergents. Never open the door forcibly or use it as a step. 1. Sort the laundry according to... Type of fabric / care label symbol Cottons, mixed fibres...

Page 9 - DRAINING RESIDUAL WATER; if it fails to perform spin cycles.; Ensure that the water has

1 0 1 1 unds Remove siphon in softener slot. (fig.“C”). Refit the siphon in the detergent drawer and fit the drawer back inside its housing. Press the release lever in the main wash compartment downward and remove the drawer(fig.“B”). B C Select the “Rinse+Spin” programme,reduce the speed to 1000rpm...

Page 12 - Hot / Cold fill fault - For Models with Dual Inlets; a. “F01” displayed on screen

1 6 1 7 Fig.1 Hot fill Red inlet valve Blue inlet valve Cold fill Red inlet valve Blue inlet valve Cold fill Y-piece Fig.2 If you wish to connect hot and cold water supply (Fig.1): 1 Fix the red marked inlet hose to the hot water tap and to the inlet valve with the red filter on the rear side of mac...

Page 13 - ELECTRICAL CONNECTION; Fault code; else; If; ey; If fault code “Unb” is shown; rvice

TRANSPORT/HANDING 1 8 19 adequate for the machine’s 10 A Current Rating. The electrical power cable must be replaced exclusively by a licensed electrician. ELECTRICAL CONNECTION C. Fault code The washer stops when the program is running. The display window showsfault code “F 13 ”, “F14”, “F24”, else...