Heat & Glo ST-38GTV - Manuals

Page 2 - DO NOT; ALERTED; SAFETY AND WARNING INFORMATION

2 These units MUST use one of the vent systems described in the Installing the Fireplace section of the Installers Guide . NO OTHER vent systems or components MAY BE USED . This gas fireplace and vent assembly MUST be vented directly to the outside and MUST NEVER be attached to a chimney serving a s...

Page 3 - Section 4: Maintaining and Servicing; Table of Contents

3 Safety and Warning Information ..................................... 2 Service Parts List ............................................................ 4 Section 1: Approvals and Codes .................................... 6 Appliance Certification ......................................................

Page 4 - ST-38GTV Exploded Parts Diagram / Vue éclatée des pièces; La liste des numéros de pièce se; Service Parts

4 ST-38GTV Exploded Parts Diagram / Vue éclatée des pièces * Part number list on following page.* La liste des numéros de pièce se trouve à la page suivante. Service Parts 2 4 5 3 6 1 7 5

Page 5 - ST-38GTV Service Parts List / Liste des pièces de rechange; supply serial and model numbers to ensure correct service parts. /; Robertshaw Valve

5 ST-38GTV Service Parts List / Liste des pièces de rechange IMPORTANT: THIS IS DATED INFORMATION. The most current information is located on your dealers VIP site. When ordering, supply serial and model numbers to ensure correct service parts. / IMPORTANT : L'information fournie dans cette brochure...

Page 6 - Appliance Certification; Installers; Certification; Approvals and Codes; High Altitude Installations; Systems registered

6 Appliance Certification The Heat-N-Glo fireplace model discussed in this Installers Guide has been tested to certification standards and listed by the applicable laboratories. Certification MODEL: ST-38GTV LABORATORY: Warnock Hersey Listed TYPE: B Vent Decorative STANDARD: ANSI Z21.50CGA2.22 In...

Page 7 - Getting Started; Introducing the Heat-N-Glo Gas Fireplaces; Pre-install Preparation; Warranty

7 2 Getting Started Introducing the Heat-N-Glo Gas Fireplaces Heat-N-Glo B vent gas fireplaces are designed to operate with all exhaust gases expelled to the outside.The information contained in this Installers Guide , unless noted otherwise, applies to all models and gas control systems. Gas fire...

Page 9 - Installing the Fireplace; Step 1. Locating the Fireplace; Step 2. Framing the Fireplace; MEASURE FIREPLACE DIMENSIONS AND; Clearance Requirements; Model; NOTE: DIMENSIONS SHOWN IN INCHES

9 3 Installing the Fireplace Step 1. Locating the Fireplace The diagram below shows space and clearance require- ments for locating a fireplace within a room. Minimum Clearances from the Fireplace to Combustible Materials Inches mm Glass Front .......................... 3 6 ................. 9 1 4 F...

Page 12 - Securing the Fireplace; ROOF PITCH; C. Bedroom Installation in Canada

12 Step 5. Positioning, Leveling, and Securing the Fireplace The diagram below shows how to properly position, level, and secure the fireplace. Figure 7. Proper Positioning, Leveling and Securing of a Fireplace Place the fireplace into position (see Figure 7). Level the fireplace from side to si...

Page 13 - Standing Pilot Ignition

13 ! Figure 9. Gas Supply Line At the gas line access hole, use insulation to re-pack the space around the gas pipe. Insert insulation from the outside of the fireplace and pack the insulation tightly to totally seal between the pipe and the outer casing. Step 7. The Gas Supply Line NOTE: Have t...

Page 14 - Step 9. Wiring the Fireplace; Step 8. Gas Pressure Requirements; Pressure

14 ! Step 9. Wiring the Fireplace NOTE: Electrical wiring must be installed by a licensed electrician. CAUTION: DISCONNECT REMOTE CONTROLS IF YOU ARE ABSENT FOR EXTENDED TIME PERIODS. THIS WILL PREVENT ACCIDENTAL FIREPLACE OPERATION. For Standing Pilot Ignition WiringAppliance Requirements This appl...

Page 15 - Figure 11. Fan Wiring Diagram

15 Figure 11. Fan Wiring Diagram OUTERCASTING INNER CASTING BLOWERFLANGE LOWERMOUNTINGFLANGE BLOWER ASSEMBLY #6 X 1/2" SCREW UPPER MOUNTING BRACKET (B) OIL HOLES BLOWER ASSEMBLY ELECTRICAL JUNCTION BOX MOTOR 120 VOLT HOUSE WIRING GROUND WHITE BLACK GROUND SCREW WALL SWITCHOR SPEED CONTROL WALL J...

Page 17 - Step 12. Before Lighting the Fireplace; Step 13. Lighting the Fireplace; EMBER

17 Step 12. Before Lighting the Fireplace Before lighting the fireplace, be sure to do the following: Remove all paperwork from underneath the fireplace.Review safety warnings and cautions Read the Safety and Warning Information section at the beginning of this Installers Guide . Double-check for ...

Page 18 - Maintaining and Servicing Your Fireplace; Fireplace Maintenance; Placing Ember Material

18 4 Maintaining and Servicing Your Fireplace Fireplace Maintenance Although the frequency of your fireplace servicing and main- tenance will depend on use and the type of installation, you should have a qualified service technician perform an appli- ance check-up at the beginning of each heating se...