Haier XPB56-23S- Manuals

Page 2 - Meaning and description of the symbols; Accessories

Before Using Before Using Names of the par ts Meaning and description of the symbols Warning sign Forbidding sign Contents marked with that symbolare related to the safety of the product and the personal safety of the users. Please operate in strict conformity to the contents,otherwise it may cause ...

Page 3 - Do not use water hotter than 50 C .

Before Using Before Using Safety precautions If the power cord is bad, to avoid risk it is required to replace it by the techniciansof our special shop or the after-sale service department. Keep the pin of the powerplug clean. Do not put the machine at damp place like the bathroom . Never wash it wi...

Page 5 - Usage of the drain hose; Do not tramp or press the drain hose.; Before Using; Install the lint filter

Please install and adjust the machine according to the requirement of the manual. It is very important to your security and correct operating the machine. Usage of the drain hose The drainage shall be smooth with the drain hose.1.The height of the drain hose shall be less than 10cm , or the drainage...

Page 6 - Extend the drain hose from the rear side; How to change the direction of the drain hoses; Figure 1; Extend the drain hose from the side of spin tub

Extend the drain hose from the rear side How to change the direction of the drain hoses Figure 1 indicates the ex factory installationposition of the drain hose. Put soft items on the ground. Lean the machine down gently with the front surface facing the ground. Take off the drain hose from the cabi...

Page 7 - You can fill water into the wash tub directly; Using process

Quick water-filling entrance You can fill water into the wash tub directly through this entrance. It can reduce the humidity inside the control panel significantly and prolong the operating life of the components. Quick water-filling entrance Using process Using process Introduction of the major fun...

Page 8 - Pay attention to followings before washing the laundries

Preparation before washing1.Connect the water inlet hose.2.Confirm that the washing machine is earthed reliably . Then insert the power plug into the receptacle. Do not connect the earth terminal to the gas pipe and tap water pipe.3.Put down the drain hose . 4.Slanting or uneven ground may result in...

Page 9 - Reference weight of the laundries

Reference weight of the laundries Working suit up,down Jeans about 800g The capacity of washing and spinning ofthe machine refer to the largest weight ofthe standard laundries under dry condition that can be washed or spinned in one time. Laundries quantity in one washing cycleshall be lower than th...

Page 10 - Usage of the detergent

Selection of the quantity of the washing powder list 1 Selection of the current , water level and washing time list 2 How to use the washing powder How to use the whitener Fill water to decided level. Dilute the whitener with container. Pour it slowly into thewashing tub. Avoid using whitener on lau...

Page 11 - Washing sequence; Wash; Figure 3

STANDARD Washing sequence Figure 1 Figure 2 Figure 4 Spin timer Wash timer Wash selector Water-filling entrance (To set to below 2 minute, first set to 5 minute then turn it back. it can increase the service life of the timer). Using process Using process (Standard current, strong current) (to set t...

Page 12 - Rinsing

Rinse with stored water Rinse with water-filing 1. Put the laundries into the wash tub. Select suitable current according to the laundries. 2. Fill water to preset water level. 3. Rinse Adjust the wash timer to 2-3 minutes to do rinsing. When the laundries quantity is below 2.4kg, please use "ST...

Page 13 - Spinning; Put the laundries into the spin tub evenly and smoothly.

Spinning 1. 2. Put the laundries into the spin tub evenly and smoothly. Spin Outer cover of The spin tub Inner cover of The spin tub Using process Using process (1) Put the gland in properly. Please put in the gland properly even if the laundries quantity is small. (2) Close the inner and outer cove...

Page 15 - Cleaning the overflow filter; Disposal of the complete unit

Wipe the complete unit with soft cloth twisted dry. Wipe with neutral detergent if too dirty Do not wash it directly by water Using process Using process Cleaning the overflow filter 2. Take off the corrugation pipe. Dismantle the upper part of the corrugation pipe inside the overflow filter ( as in...

Page 16 - Trouble-shooting Answers to question; When the remained water is frozen

Trouble-shooting Answers to question When the remained water is frozen Prevent the freezing (be sure to discharge the water completely after using) After complete draining, set the "WASH SELECTOR" at "STRONG" or "STANDARD" If it is set at "DRAIN", it will be rather di...

Page 17 - Phenomena The reason; The machine does not act.

Trouble-shooting Answers to question (If there's breakdown, please pull off the power plug before checking) The following phenomena are not breakdowns sometimes. Please confirm again before sending it to repair. If there are real breakdowns, please come to the special maintenance department or after...

Page 18 - Packing list

User's manual One piece Water inlet hose Water-filling jointer Gland Lint filter Packing list Twin-tub washing machine One set One piece One piece One piece One piece

Page 19 - Specification

Type Model Power source Water level Water quantity about Rated washing capacity kg Rated input power W Dimension(mm) Wash pattern Weight kg Injection pressure Rated spinning capacity kg Twin-tub washing machine WMS663 V~, 50Hz Maximum/43L Medium/36L Minimum/30L 6.5 5 Wash 320 Spin 150 L740 W428 H936...