Page 2 - Contents
Contents Safety precautions Installation and adjustment Preparation before washing The musts in washing Usage of the detergent Washing sequence Disposal after washing Packing list *Specification Names of the parts Trouble-Shooting *Answers to question
Page 3 - Meaning and description of the symbols; Warning sign; Names of the parts; Spin water-filling entrance
1 Meaning and description of the symbols Warning sign Forbidding sign Contents marked with that symbol are related to the safety of the product and the personal safety of the users. Please operate in strictconformity to the contents, otherwise it may cause damage of the machine or injure thepersonal...
Page 4 - Safety precautions
2 Safety precautions Please insert the power cord into special receptacle with rated vol-tage.Be sure to use single-phase three pins receptacle.The earthing terminal of the receptacle must be earthed reliably.If possible,please adopt electric leakage protector. When the machine is normallyusing, ple...
Page 6 - Installation and adjustment; Install the lint filter; The drainage shall be smooth with the drain hose.
Overflow filter Lint filter If the extra hose is too long, cut it eitherat point A or B. <10cm B A > 30mm <1.5m 4 Installation and adjustment Please install and adjust the machine according to the requirement ofthe manual. It is very important to your security and correct operating the mach...
Page 7 - How to change the direction of the drain hoses; Extend the drain hose from the side of spin tub; Install the water inlet hose Select the water level
5 How to change the direction of the drain hoses Figure 1 indicates the ex factory installationposition of the drain hose. Put soft items on the ground. Lean the machine down gently with the front surface facing the ground. Take off the drain hose from the cabinet.Take the hose out of the fixing gro...
Page 8 - Preparation before washing
6 Preparation before washing1.Connect the water inlet hose.2.Confirm that the washing machine is earthed reliably . Then insert the power plug into the receptacle. Do not connect the earth terminal to the gas pipe and tap water pipe.3.Put down the drain hose . 4.Slanting or uneven ground may result ...
Page 9 - The musts in washing; How to use the whitener; How to use the washing powder; Usage of the detergent
7 The capacity of washing and spinning of the machine refer to the largest weight of thestandard laundries under dry condition that can be washed or spinned in one time. Laundriesquantity in one washing cycle shall be lowerthan the rated capacity. The wash standard capacity of this machine is 5.8 kg...
Page 10 - Washing sequence; Wash
8 Washing sequence Figure 1 Spin timer Wash timer Wash selector (To set to below 2 minute, first set to 5 minute then turn it back. it can increase the service life of the timer). (standard current, strong current) (to set to below 1 minute, first set to 2 minute then turn it back. it can increase t...
Page 11 - Midway spinning; Put the laundries into the spin tub evenly and smoothly.
Midway spinning 1. 2. 3. Put the laundries into the spin tub evenly and smoothly. Spin Run the foam-removing spinning. Push Push Proper Proper Outer cover of the spin tub Inner cover of the spin tub The laundries are slanting Gland No gland (1) Put the gland in properly. Please put in the gland prop...
Page 12 - Rinsing
Rinse with stored water Rinse with water-filling 1. Put the laundries into the wash tub. Select suitable current according to the laundries. 2. Fill water to preset water level. 3. Rinse Adjust the wash timer to 2-3 minutes to do rinsing. When the laundries quantity is below 2.4kg, please use STANDA...
Page 13 - Spinning
11 Selection of the spin time list 3 Laundries Spin time (minutes) About 4~5 Bed sheet or blanket About 2~4 Underwear (knitwear) Swear (chemical fiber) About 1~2 Within 1 minute Blending thin laundries 1. Put the laundries into the spin tub evenly and smoothly. 2. Press the gland in the tub properly...
Page 14 - Cleaning the overflow filter; Cleaning the lint filter; Disposal after washing
12 After using, please clean the lint and eyewrinker of the lint filter and overflow filter in time. Otherwise it may influence your using the machine.Please first pull off the power plug from the receptacle before cleaning. 1 Take off the overflow filter. As indicated in the figure, nip the elastic...
Page 16 - Trouble-shooting Answers to question; When the remained water is frozen
14 Trouble-shooting Answers to question When the remained water is frozen If the laundries fall to the outer side of the spin tub,please take them out immediately. 1.DismantleAs indicated in the figure, push the point marked with " " to pull the spin tub frame to oblique upwards to dismantle...
Page 17 - Trouble-shooting Answer to question; Phenomena The reason
15 Trouble-shooting Answer to question (If there's breakdown, please pull off the power plug before checking) The following phenomena are not breakdowns sometimes. Please confirm again before sending it to repair. If there are real breakdowns, please come to the special maintenance department or aft...