Haier HWM120-01- Manuals

Please install and adjust the machine according to the requirement of the manual. It is very important to your security and correct operating the machine. Installation and adjustment Install the lint filter After opening the package, please take out thelint filter from the document bag and install i...

1. The height of the drain hose shall be less than 10cm, or the drainage will not be smooth, and cost such long time that the machine may stop at mid way. 2. Do not ramp or press the drain hose. 3. If the drain hose is too long, cut it at mid point. To make smooth drainage, cut the front end of the ...

The exit end face of the faucet Confirm the water faucet Connection between the water inlet hose jointer and the water faucet water faucet, suitable water faucet, not suitable It is required that the front end shall be longer than 10mm.The exit end face of the faucet shall be flat and smooth. If not...

1 Preparation before washing Pay attention to followings before washing the laundries Preparation before washing 1. Connect the water inlet hose. Open the water faucet. 2. Confirm that the washing machine is earthed reliably. Then insert the power plug into the receptacle. The earth terminal shall n...

Reference weight of the laundries: working suit up,down jeans about 800g The capacity of washing and spinning of the machine refer to the largest weight of the standard laundries under dry condition .that can be washed or spinning in one time. One time washing quantity shall be lower than the rated ...

How to use the whitener First turn the detergent box down before adding detergent. How to use the washing powder Direct dissolved in the machine(not applicable for fuzzy and reserve programs)1.Fill small quantity of water.2.Add the power. Run for 30 seconds to dissolve it completely.3.Put in the lau...

Description of the function of the knobs and buttons 4 Use the operation buttons Mode and meaning of the VFD indicator the frame of the indicator is flashing : indicate the running program. the frame of the indicator is on : indicate the program about to run, or indicate the selected mode the frame ...

POWER ON/OFF button Push the "On/Off" button to switch on the power. When the power is on, push it again to switch off the power.After the power is switched on , if the washing machine is idlefor 10 minutes, it will switch off the power automatically. one or more one programs among soak wash...

Push the POWER ON/OFF button to switch on the power. Push the PROGRAM button to select the suitable automatic program. Steps of using the operation buttons and description of the steps After switching on the power, the machine will set to standard program automatically. To select other program, push...

Selection method of the procedure programs Times of pushing the PROCESS button Selected procedureprogram Applicable procedure Contents (the lighted indicators indicate the programs about to run) Wash, rinse, spin(standard program) Wash (the washing liquidremains in the tub) Wash (the rinsing liquidr...

Push the RESERVE button to select the suitable reserve program Push the START/PAUSE button 5 close the lid 6 finish washing 16 hours later, finish wash Confirm the reserve program Excluding during soak, wash, filling water procerdure,If you open the top lid, the machine will stop working and alarm b...

Clean The filter screen of the water inlet valve is likely to be blocked by foreign materials and influence the water inlet. Please clean it with brush every two months. 7.Disposal after washing After using, please clean the lint and foreign materials of the lint filter etc. in time. Otherwise it ma...

After the reserve is started, it rings and thedigital tube displays E0 The safety switch acts. The spinning can not work (after twice revising) The digital tube shows E3 and it rings. It does not do water inlet or the speed is slow ( the water level is not reached after15 minutes). The digital tube ...

Packing list Full Automatic washing machine Components of the water inlet hose Lint filter Name Quantity One Specification Water level/Water quantity (about) 1/29L 2/35L 3/41L 4/47L 5/53L 6/59L 7/65L 8/71L 9/77L 10/83L 11/89L 12/96L Max water consumption About 280L Water Injection pressure 0.03MPa~0...