Haier HWD-D1000TXVE - Manuals

Page 2 - Table of contents

page no. Before use Parts .......................................................................................................... 1 Safety instructions ................................................................................. 2 - 4 Installation ...............................................

Page 3 - Parts

1 This diagram may vary slightly with the layout of the washing machine you have just purchased due to technical improvements. NOTICE Please read these instructions carefully before using this appliance. The instructions contain important information which will help you get the best out of the appli...

Page 4 - Safety instructions

2 Using your appliance will be simple, but please make sure read the following to get the best out of it and to ensure your own safety. BEFORE sWITChING ThE applIaNCE ON FOR ThE FIRsT TIME: DO ✓ Ensure you connect the appliance directly to a domestic mains water supply. ✓ Ensure that the appliance i...

Page 7 - Installation

Caution: protective gloves should be warn • Remove all the packing materials (including the foam base) to prevent vibration during use, as show in Fig. 1. On opening, water drops may be visible on the appliance. This is a normal phenomenon. • Check that the appliance is also supplied with the follow...

Page 10 - Functions

8 G. start/pause button When the washing machine is connected to the power socket and a programme is selected, touch this button to start operation. Touch this button again during operation to pause the programme. The display screen will flash and the machine will be paused. Press the button again a...

Page 11 - Programme selection guide

9 Programme selection guide NOTE: “O” indicates that softener can be added if need; “ ★ ” indicates that detergent must be added; “X” indicates that detergent must not added; “*” indicates cold water. 1) The wash temperature indicates the maximum temperature.2) The wash temperature refers to the max...

Page 12 - Preparing for a cycle

10 Preparing for a cycle Detergent selection Only special low foam detergent should be used in automatic drum washing machines. For blended or wool fabrics, special detergent should be used. Dry cleaning solvent should not be used. Caution: do not use too much detergent. laundry treatment • Sort out...

Page 14 - Using your appliance

12 3. selecting washing programme To get the best wash, an appropriate washing programme should be selected according to the type of laundry. 4. Washing temperature settings Set the washing temperature as required, otherwise set at position * when a cold wash is acceptable. 5. Function selection but...

Page 15 - Other functions

1. Control panel lock function: To prevent children from accidentally changing the settings, the control panel can be locked by pressing the “Temperature” and “Delay” buttons at the same time. After the panel is locked, the sign “LOCK” and the remaining wash time will be displayed on the LED alterna...

Page 16 - Maintenance

14 1. Turn off the water tap and pull out electricity plug after each wash. Open the porthole to prevent formation of moisture and odours. If the washing machine is left idle for a long period, drain the water in the machine and replace the drain hose. 2. Unplug the machine during cleaning and maint...

Page 18 - Trouble shooting

16 Trouble shooting In the unlikely event of difficulties with your appliance please follow the trouble shooting guide below. If the problem persists, contact an approved service engineer. If an error code is displayed, please refer to the error code guide below. problem possible cause how to correc...

Page 19 - T e c h n i c a l s p e c i -c a t i o n

1 7 M odel / Item HW D -D 1 0 0 0 T X VE/M E HW D -D 1 2 0 0 T X VE/M E Power Source 2 2 0 -2 4 0 V/ 5 0 Hz 2 2 0 -2 4 0 V/ 5 0 Hz Working C urrent ( M ax ) ( A) 1 0 1 0 Tap Water Pressure ( M Pa) 0 . 0 3 P 1 0 . 0 3 P 1 Washing Power ( W ) 2 0 0 2 0 0 Spinning Power ( W ) 3 5 0 4 5 0 M ax Load ( kg...