Haier HDW9TFE3SS2 - Manuals

Before you start Safety and compliance These instructions are intended as a guide only. It is the responsibility of the installer to ensure that installation complies with applicable regulations and local government by-laws. Installation must be performed by a suitably qualified person. Incorrect in...

Product and cabinetry dimensions A B E F G C D * The top panel may be removed to suit underbench cavity height. See instructions further below. **Depending on feet height adjustment. Product dimensions (mm) A overall height of product with top panel in place with top panel removed* 850 (min) -870 (m...

Electrical connection The dishwasher must not be connected to the electrical supply while installation is being carried out. Ensure all domestic wiring is properly earthed. Check the rating label and ensure that the voltage and frequency values for the current in the house correspond to those on the...

11 Getting to know your appliance Close-up view (control panel) Dishwasher interior Upper Rack abcde fghij Top Spray ArmSilverware BasketBottom Spray Arm Lower Rack Detergent and Rinse Aid Dispenser Washing Filter Water Inlet HoseDrain HosePower Supply Cord "3 in 1" Indicator Heater Indicato...

Rinse aid This product makes dishes sparkle and helps them to dry without spotting. The dispenser is located on the inside panel of the door.When the low rinse aid indicator lights up on the control panel (see Fig.A), you must add rinse aid. Adding rinse aid Regardless of the type of detergent dispe...

5 4 13 How to fill the detergent dispenser Detergent Detergent specifically intended for use with dishwashers must be used. The dispenser must be refilled before the start of each wash cycle following the instructions provided in the "Programme overview". The detergent dispenser is located o...

14 Non-Dishwasher Items Cutlery and tableware manufactured in whole or part from wood. These will become faded and deteriorate quickly. Furthermore, the adhesives that are used are not suitable for the temperature inside the dishwasher.Delicate decorative glassware and vases, special antique or irre...

15 Loading the Dishwasher Before placing the dishes in the dishwasher, remove the larger food scraps to prevent the filter from becoming clogged.If the pots and pans have baked-on food that is extremely hard to remove,we recommend they are soaked before washing. This will eliminate the need for extr...

16 Programme overview en When the programme is finished leave the door open30°(approximately 100mm) to improve the drying performance.“ ” be able to applied “ ”not to be applied W ash programme Description of cycle Pre-wash with hot water. Extended wash at 68°C. Rinses with cold water. Rinse with ho...

17 Washing dishes Programme selection The most appropriate programme can be identified by comparing the type of crockery, cutlery, etc., and the amount and condition of food residue, with the details contained in the programme overview. The corresponding programme sequence, duration and consumption ...

Switch dishwasher ON.Immediately press the delayed start button "F". The delayed start indicator "E" blinks and the time remaining indicator "G" changes to " ".Press the delayed start button for 2 seconds until the numerical display shows the required delay.To cancel ...

19 After 3 seconds the delayed start indicator "E" blinks. The time-remaining indicator "G" will also blink. The programme will start when both lights fade. 3 in 1 function When using "3 in 1" combination products, the rinse-aid lights are no longer relevant. It may be helpfu...

21 Care and maintenance Regular inspection and maintenance of your appliance helps to prevent problems from occurring. This saves time and aggravation. You should therefore carefully inspect the inside of your dishwasher from time to time. Overall condition of appliance Check that no grease or scale...

22 Inspect the nozzles in the spray arms for holes blocked due to food residue.If necessary, pull the lower arm "11" upwards and lift it off.Unscrew the upper spray arm "10".Clean both spray arms under running water. Refit the spray arms. Ensure that the lower arm has locked into pla...

23 Resolving minor problems yourself Experience has shown that you can resolve most problems that arise during normal daily usage yourself without having to call out a service engineer.Not only does this save costs, but it also means that the appliance is available for use again that much sooner. Th...

24 When the buzzer emits 10 short warning signals every 30 seconds and the time-remaining indicator displays"E4"Have you checked whether: The drain hose is creased or kinked.The drain hose is too high. If you carry out all these checks and the appliance still does not function or your applia...

26 Not enough detergent was added to dispenser.Detergent has insufficient bleaching properties. Use a detergent containing a chemical bleaching agent. Plastic items are discoloured Not enough detergent was added to dispenser compartment.Amount of rinse-aid was set too low.Water softener was set too ...

27 Technical data 9 standard place settings Width Depth Height Capacity Mains water pressure Power voltage Total absorbed power 450 mm 600 mm 850 mm 0.03-1.0MPa 220-240V~ 50Hz 1950W Maximum current intensity 10A Important information Notes on waste disposal Old appliances still have some residual va...