Haier HDW12-TFE3SS - Manuals

Before you start Safety and compliance These instructions are intended as a guide only. It is the responsibility of the installer to ensure that installation complies with applicable regulations and local government by-laws. Installation must be performed by a suitably qualified person. Incorrect ins...

Product and cabinetry dimensions $ % ( ) * & ' * The top panel may be removed to suit underbench cavity height. See instructions further below.**Depending on feet height adjustment. Product dimensions (mm) A overall height of product with top panel in place with top panel removed* 850 (min) -870...

1 Preparing the product and cabinetry The top panel may be removed to suit underbench cavity height. See the illustrations below. Important! To prevent possible steam damage to the cabinetry, ensure that any bare wood surrounding the dishwasher is sealed with an oil-based paint or moisture-proof pol...

Electrical connection The dishwasher must not be connected to the electrical supply while installation is being carried out. Ensure all domestic wiring is properly earthed. Check the rating label and ensure that the voltage and frequency values for the current in the house correspond to those on the...

EN 11 HIJ Low Rinse Aid Indicator Light Heat Indicator Light Knob For Selecting Cycle ABC D "POWER" Light "POWER" Button "HALF LOAD" Light "HALF LOAD" Button E "DELAY" Light F "DELAY" Button G Time-remaining Indicator J A D C G F H I E B delay Detergen...

EN 12 How to fill rinse aid Important Proper dosage of the rinse aid improves drying. If drops of water remain on the dishes or spot- ting occurs, the dosage adjustor should be turned to a higher setting. If the dishes have white streaks, turn the dosage adjustor to a lower setting. Rinse aid This p...

EN 4 3 How to fill the detergent dispenser Detergent Detergent specifically intended for use with dishwashers must be used. The dispenser must be refilled before the start of each wash cycle fol- lowing the instructions provided in the "Programme overview". The de- tergent dispenser is locat...

EN Not suitable for the dishwasher What you should not put into the dishwasher Cutlery and tableware manufactured in whole or part from wood.They become faded and unsightly in appearance.Furthermore,the adhesives that are used are not suitable for the temperature that occur inside the dishwasher.Del...

EN Arranging crockery, glasses, etc. in the dishwasher Before placing the dishes in the dishwasher, remove larger food particles to prevent the filter from becoming clogged, which re- sults in reduced performance. If the pots and pans have baked-on food that is extremely hard to remove, we recommend...

EN Programme overvie w W ash programme Description of cycle Pre-wash with hot water. Extended wash. Rinses with cold water. Rinse with hot water. Drying.Prewash use cold water. Extended wash. Rinse with cold water. Rinse with hot water. Drying. Hot rinse.Drying. Short wash.Cold rinse. Short cold was...

EN Programme selection The most appropriate programme can be identified by comparing the type of crockery, cutlery, etc., aswell as the amount and condition of food remains, with the details contained in the wash cycle table.Thecorresponding programme sequence, duration and consumption details are s...

EN How to keep your dishwasher in shape After Every Wash After every wash, turn off the water supply the appliance and leave the door slightly ajar so that moisture and odors are not trapped inside. Remove the plug Before cleaning or performing maintenance, always switch off the remove the plug from...

EN Care and maintenance Regular inspection and maintenance of your appliance helps to prevent problems from occurring.This saves time and aggravation.You should therefore carefully inspect the inside of your dishwasher from time to time. Overall condition of appliance Check that no grease or scale h...

EN Inspect the nozzles in the spray arms for blocked holes due to remnants of food. If necessary, pull the lower arm “ 10 ” upwards and lift it off. Unscrew the upper spray arm “ 9 ”. Clean both spray arms under running water. Refit the spray arms. Ensure that the lower arm has locked into place and...

EN When the buzzer emits 10 short warning signal every 30 seconds and the time-remaining indicator display "E3" Have you checked whether: the drain hose is too low. Error display on the time-remaining indicator 24 When the buzzer emits 10 short warning signals every 30 seconds and the time-r...

EN If you take all these checks and the dishwasher still does not function or your dish- washer have any other error display, you can power the dishwasher OFF, and wait a few minutes. You can power the dishwasher on, try it again , if the dishwasher still does not function and/or the problem persist...

EN Technical data 12 standard place settings Width Depth Height Capacity Mains water pressure Power voltage Total absorbed power 60 cm 60 cm 85 cm 0.03-1.0MPa 1950W Maximum current intensity Important information Notes on waste disposal Old appliances still have some residual value. An environment-f...

EN General information Measures must be taken to ensure that built-under and built-in units that are subsequently re-sited as free-standing appliances cannot topple over. This can be achieved by bolting the dishwasher to the wall or fitting it under a continuous work surface which is screwed to the ...

EN Positioning the appliance Positioning the appliance in the desired location. The back of the appliance should rest against the wall,and the sides, along the adjacent cabinets or wall. The dishwasher is equipped with water supply anddrain hoses that can be positioned to the right or the left to fa...

EN 6 H I J Low Rinse Aid Indicator LightHeat Indicator LightKnob For Selecting Cycle A B CD "POWER" Light"POWER" Button"HALF LOAD" Light"HALF LOAD" Button E "DELAY" Light F "DELAY" Button G Time-remaining Indicator J A D C G F H I E B delay Detergent a...

EN 7 How to fill rinse aid Important Proper dosage of the rinse aid improves drying. If drops of water remain on the dishes or spot-ting occurs, the dosage adjustor should be turned to a higher setting. If the dishes have whitestreaks, turn the dosage adjustor to a lower setting. Rinse aid This prod...

EN 4 3 How to fill the detergent dispenser Detergent Detergent specifically intended for use with dishwashers must be used.The dispenser must be refilled before the start of each wash cycle fol-lowing the instructions provided in the "Programme overview". The de-tergent dispenser is located ...

EN Not suitable for the dishwasher What you should not put into the dishwasher Cutlery and tableware manufactured in whole or part from wood.They become faded and unsightly inappearance.Furthermore,the adhesives that are used are not suitable for the temperature that occurinside the dishwasher.Delic...

EN Arranging crockery, glasses, etc. in the dishwasher Before placing the dishes in the dishwasher, remove larger foodparticles to prevent the filter from becoming clogged, which re-sults in reduced performance.If the pots and pans have baked-on food that is extremely hardto remove, we recommend tha...

EN Programme overvie w W ash programme Description of cycle Pre-wash with hot water. Extended wash. Rinses with cold water. Rinse with hot water. Drying.Prewash use cold water. Extended wash. Rinse with cold water. Rinse with hot water. Drying. Hot rinse.Drying. Short wash.Cold rinse. Short cold was...

EN Programme selection The most appropriate programme can be identified by comparing the type of crockery, cutlery, etc., aswell as the amount and condition of food remains, with the details contained in the wash cycle table.Thecorresponding programme sequence, duration and consumption details are s...

EN End of programme Interrupting the programme Open the door. Caution! There is a risk of water squirting out from inside the appliance. Do not openthe door fully until spray arm has stopped rotating.When you open the door, the dishwasher will beep ten times every thirty seconds.If the appliance has...

EN How to keep your dishwasher in shape After Every Wash After every wash, turn off the water supply the appliance and leave the door slightly ajar so that moistureand odors are not trapped inside. Remove the plug Before cleaning or performing maintenance, always switch off the remove the plug from ...

EN Care and maintenance Regular inspection and maintenance of your appliance helps to prevent problems from occurring.Thissaves time and aggravation.You should therefore carefully inspect the inside of your dishwasher fromtime to time. Overall condition of appliance Check that no grease or scale has...

EN Inspect the nozzles in the spray arms for blocked holesdue to remnants of food.If necessary, pull the lower arm “ 10 ” upwards and lift it off.Unscrew the upper spray arm “ 9 ”.Clean both spray arms under running water.Refit the spray arms. Ensure that the lower arm has lockedinto place and the u...

EN Technical data 12 standard place settings Width Depth Height Capacity Mains water pressure Power voltage Total absorbed power 60 cm 60 cm 85 cm 0.03-1.0MPa 1950W Maximum current intensity Important information Notes on waste disposal Old appliances still have some residual value. An environment-f...

EN General information Measures must be taken to ensure that built-under and built-in units that are subsequently re-sitedas free-standing appliances cannot topple over. This can be achieved by bolting the dishwasher tothe wall or fitting it under a continuous work surface which is screwed to the ad...