Haier HBU-18CF03- Manuals

Cautions WARNING! Carefully read the following information in order to operate the airconditioner correctly. Below are listed three kinds of Safety Cautions and Suggestions. WARNING!CAUTION! Incorrect operations may result in injuries or machine damages; in some cases maycause serious consequences. ...

WARNING ! CAUTION ! Please ask the dealer or specialist to install, never try by the users themselves. After the installation please be sure of the following conditions. Incorrect installation may cause water leaking, shock and fire hazard. Please call dealer to install the air-conditioner. Air-cond...

Introduction to Spare Parts Swing fender Air filter Outlet Suction grill (located in the suction grill) (located in the outlet) Indoor unit 6

3. Dismantle air filter CAUTION! 4. Clean 6. Close inlet grill7. Press the filter signal return key on the controller. (A) Remove dust with vacuum filter. 5. Install air filter (1) Put filter into protruding parts at the top of the inlet grill.(2) Connect the two pothooks with inlet grill See 2 [Cle...

8 3. Take of inlet grill 4. Clean CAUTION! NOTE When the filter too much dust To spray the special detergent for vent fan orutensils. 5. Install inlet grill6. Install air filter7. Close inlet grill [Clean outlet and shell] see 3see "Clean air filter"see 1 CAUTION! Don't use gasoline, benzene...

9 NOTE 1.The inner part of indoor unit must be cleaned. Consult dealer, because clean must be done by technician. 2.In cooling operation, discharging system discharge water in room. Seasonal Reserve Operate the unit with FAN mode on a fair day for about half a day to dry the inside of the unit well....

10 The followings are not malfunction Hua Hua Trouble Shooting Water flowing sound is heard When the air conditoner is started, when the compressor starts or stops during operation or when the air conditioner is stopped,it sometimes sounds “ Bi- Bi-” or “Godo-Godo”. It is the flowing sound of the re...

12 When Trouble Happens Insufficient cooling or heating The operation controller adjusted as required Air filter too dirty ? Horizontal swing louver upward ? (in HEAT mode) Any obstacle exists at the air inlet or outlet? Door or window left opened ? Insufficient cooling Any other heat sources in the...

13 When Trouble Happens The exterior alarm signal input "Run" light flashes eleven times The indoor coil temperature is higher than room temperature when cooling or the former is lower than the later when heating "Run" light flashes thirteen times BM1 (1) OFF (2)OFF BM2 BM3BM4 (1) OF...

14 Customer Need-to-know Customer Need-to-know Please install the air conditioner according to the requirements specified in this manual to ensure the air conditioner work well.Be careful not to scratch the surface of the case during moving the air conditioner.Please keep the installation manual for...

15 Installation tools 1. Screw driver2. Hacksaw3. Drill with a diameter of 60mm4. Inner hexagon spanner,shifting spanner5. Spanner (14, 17, 19, 24, 27mm)6. Pipe cutter7. Pipe expander8. Knife9. Pincers10. Leakage detector or soapy water11. Band tape12. Scraper13. Refrigerant oil The installation too...

16 Unit shall be grounded. But grounding shall not be connected to gas pipe water pipe, telephone line. Poor grounding will cause electric shock. Be sure to install a leakage breaker to avoid electric shock. Arrange water drainage according to this Manual. Cover pipe with insulation materials in cas...

17 (2) Ceiling height Indoor unit can be installed on ceiling of 2.5-3m in height. (Refer to Field setting and Installation Manual of ornament panel.) (3) Install suspending bolt. Check if the installation place is strong enough to hold weight. Take necessary measures in case it is not safe. (Distan...

18 (2) Cut an opening in ceiling for installation if necessary. (when ceiling already exists.) (3) Install a suspending bolt. (Use a M10 bolt) To support the unit weight, anchor bolt shall be used in the case of already exists ceiling. For new ceiling, use built-in type bolt or parts prepared in the...

19 ( As for outdoor piping, please refer to installation Manual of outdoor unit. ) Outdoor is precharged with refrigerant. Be sure to see the Fig.1, when connecting and removing piping from unit. For the size of the flare nut, please refer to Table 1. Apply refrigerant oil at both inside and outside...

20 Check if water drainage is smooth after installation.Charge, through air outlet or inspecting hole, 1200cc water to see water drainage. (1) Install water drainage pipe Pipe dia, shall be equal or larger than that of unit piping.(pipe of polyethylent; size: 25mm; O.D:32mm) Drain pipe should be sho...

21 As for outdoor unit circuit, please see Installation Manual of outdoor unit. Note: All electric wires have their own poles, poles must match that on terminal block. 9. INSTALLATION OF ORNAMENT PANEL Be sure to show customers Operation Manual and guide them how to operate unit correctly. Before in...