Haier DW12-TFE3ME - Manuals

EN Positioning the appliance Positioning the appliance in the desired location. The back of the appliance should rest against the wall, and the sides, along the adjacent cabinets or wall. The dishwasher is equipped with water supply and drain hoses that can be positioned to the right or the left to ...

EN Electrical Connection After making sure that the voltage and frequency values for the current in the home correspond to those on the rating plate (located on the stainless steel inner door of the appliance) and that the electrical system is correct for the maximum voltage on the rating plate, ins...

EN Getting to know your dishwasher Close-up view (control panel) "1/2" Indicator Low Salt Indicator Time-remaining Indicator F G H I J A B C D E State Indicator ON-OFF Button Delayed Start Button Delayed Start Indicator Low Rinse Aid Indicator Knob For Selecting Cycle "1/2" Button B ...

EN 7 Salt The hardness of the water varies from place to place. If hard water is used in the dishwasher, depositswill form on the dishes and utensils.The appliance is equipped with a special softener that uses a salt specifically designed to eliminate limeand minerals from the water. How to fill the...

EN 8 How to fill rinse aid Important Proper dosage of the rinse aid improves drying. If drops of water remain on the dishes or spot- ting occurs, the dosage adjustor should be turned to a higher setting. If the dishes have white streaks, turn the dosage adjustor to a lower setting. Rinse aid This pr...

EN 4 3 How to fill the detergent dispenser Detergent Detergent specifically intended for use with dishwashers must be used. The dispenser must be refilled before the start of each wash cycle fol- lowing the instructions provided in the "Programme overview". The de- tergent dispenser is locat...

EN Not suitable for the dishwasher What you should not put into the dishwasher Cutlery and tableware manufactured in whole or part from wood.They become faded and unsightly in appearance.Furthermore,the adhesives that are used are not suitable for the temperature that occur inside the dishwasher.Del...

EN Arranging crockery, glasses, etc. in the dishwasher Before placing the dishes in the dishwasher, remove larger food particles to prevent the filter from be- coming clogged, which results in reduced performance. If the pots and pans have baked-on food that is extremely hard to remove, we recommend...

EN The upper rack is designed to hold more delicate and lighter dishware, such as glasses, cups and saucers, plates, small bowls and shallow pans (as long as they are not too dirty). How to use the upper rack fig.G fig.F Shelf Lean tall glasses and those with long stems against the shelf- not agains...

EN Programme overview Wash programme Type of crokery e.g. china, pots/ pans, cutlery, glasses, etc Amount of food remains Description of cycle Condi- tion of food remains Pre-wash with warm water. Extended wash at 70°C. Rinses with cold water. Rinse with hot water. Drying. Pre-wash use cold water. E...

EN Washing dishes Programme selection The most appropriate programme can be identified by comparing the type of crockery, cutlery, etc., as well as the amount and condition of food remains, with the details contained in the wash cycle table.The corresponding programme sequence, duration and consumpt...

EN End of programme Interrupting the programme Open the door. Caution! There is a risk of water squirting out from inside the appliance. Do not open the door fully until spray arm has stopped rotating. When you open the door, the dishwasher will beep ten times every thirty seconds. If the appliance ...

EN After 3 seconds the delayed start indicator “ E ” blinks, the time-remaining indicator “ G ” will blink and decrease , the programme will start until the delayed start indicator “ G ” goes out . Reset drain function You can use Reset drain function to stop the washing cycle under running by Rotat...

EN How to keep your dishwasher in shape After Every Wash After every wash, turn off the water supply the appliance and leave the door slightly ajar so that moisture and odors are not trapped inside. Remove the plug Before cleaning or performing maintenance, always switch off the remove the plug from...

EN Care and maintenance Dishwasher salt Check the LOW SALT indicator “ I ”. Top up with salt, if required. Regular inspection and maintenance of your appliance helps to prevent problems from occurring.This saves time and aggravation.You should therefore carefully inspect the inside of your dishwashe...

EN Inspect the nozzles in the spray arms for blocked holes due to remnants of food. If necessary, pull the lower arm “ 10 ” upwards and lift it off. Unscrew the upper spray arm “ 9 ”. Clean both spray arms under running water. Refit the spray arms. Ensure that the lower arm has locked into place and...

EN When the buzzer emits 10 short warning signal every 30 seconds and the time-remaining indicator display "E3" Have you checked whether: the drain hose is too low. Error display on the time-remaining indicator When the buzzer emits 10 short warning signal every 30 seconds and the time-remai...

EN If you take all these checks and the dishwasher still does not function or your dish- washer have any other error display, you can power the dishwasher OFF, and wait a few minutes. You can power the dishwasher on, try it again , if the dishwasher still does not function and/or the problem persist...

EN Technical data 12 standard place settings Width Depth Height Capacity Mains water pressure Power voltage Total absorbed power 60 cm 60 cm 85 cm See nameplate See nameplate See nameplate Fuse 13A Important information Notes on waste disposal Old appliances still have some residual value. An enviro...

EN General information Measures must be taken to ensure that built-under and built-in units that are subsequently re-sited as free-standing appliances cannot topple over. This can be achieved by bolting the dishwasher to the wall or fitting it under a continuous work surface which is screwed to the ...