Haier DW12-CBE7- Manuals

Page 2 - C B A; Low rinse aid indicator light; NOTICE; Safety Is a Good Habit to Get Into

Close-up View (control panel) C B A E D F A B C D E F Low rinse aid indicator light Low salt indicator light Cycle indicator light ON-OFF Button ON-OFF Light "HALF LOAD" Button NOTICE Carefully read the instructions contained in this manual, as they provide important information which is ess...

Page 3 - Technical characteristics

Close-up View (Interior) .2. GB V J L E G F I K E F G H I Upper Rack Top Spray Arm Rack Height Adjustor Lower Rack J K L V Washing Filter Detergent and Rinse Aid Dispenser Third Sprayer Salt Container Cap Bottom Spray Arm Technical characteristics 60 cm 58 cm 82 cm 12 standard place settings 0.03-0....

Page 4 - Salt; To prevent the formation of rust, load the salt just be-; Adjusting Salt Consumption; Water Hardness

Salt .3. GB Salt The hardness of the water varies from place to place. If hard water is used in the dishwasher, deposits will form on the dishes and utensils. The appliance is equipped with a special softener that uses a salt specifically designed to eliminate lime and minerals from the water. Loadi...

Page 5 - Detergent and Rinse Aid; Detergent; cess detergent on the edges of the dispenser.; Rinse Aid; Important

.4. GB Detergent and Rinse Aid Detergent Detergent specifically intended for use with dishwashers must be used. The dispenser must be refilled before the start of each wash cycle following the instructions provided in the "Wash Cycle Table". The detergent dispenser is located on the inside p...

Page 6 - Loading the Dishwasher; How to use the lower rack; Shelf

.5. Loading the Dishwasher GB Before placing the dishes in the dishwasher, remove larger food particles to prevent the filter from becoming clogged, which re- sults in reduced performance. If the pots and pans have baked-on food that is extremely hard to remove, we recommend that they are soaked bef...

Page 7 - Starting the Appliance; Starting a wash cycle

.6. Starting the Appliance GB Starting a wash cycle After having completed all of the installation steps in the preced- ing paragraphs, turn on the water to the unit, partially open the door of the dishwasher, and press the ON-OFF button "A" lo- cated on the control panel. The "B" in...

Page 8 - Wash Cycle Table

Page 10 - Troubleshooting

.9. Troubleshooting GB It may occur that the dishwasher does not function or does not function properly. Before calling for assistance, Iet us see what can be done first: have you forgotten to press one of the buttons or to perform an essential operation? The Dishwasher Does Not Start Have you check...

Page 11 - Installation

.10. Installation GB Positioning the Appliance Positioning the appliance in the desired location. The back should rest against the wall behind it, and the sides, along the adjacent cabinets or wall. The dishwasher is equipped with water supply and drain hoses that can be positioned to the right or t...