Haier AD522AMEAA- Manuals

5 2. If the supply cord is damaged, it must be replaced by the manufacturer or its service agent or a similar qualified person. 3. If the fuse on PC board is broken please change it with the type of T 3.15A /250VAC. 4. The wiring method should be in line with the local wiring standard. 1. Applicable...

Parts and Functions 6 Air outlet Air inlet Duct Air outlet Air inlet Duct For series 182, 242, 282 For series 362, 422, 482, 522

please check the following things about your air conditioner before making a servie call. Unit fails to start ON OFF Is the power sourceswitch adjust cut in? Is city supply power innormal? Powerstoppage? Isn't the signal receivingsection exposed to thedirect sunlight or strongillumination? Isn't the...

8 The followings are not malfunction Shuru Shuru When the air conditioner is started, when the compressor starts orstops during operation or when the air conditioner is stopped, itsometimes sounds "shuru shuru" or "gobo gobo". It is the flowingsound of the refrigerant, and it is not ...

9 Care and Maintenance Points to observe Turn off the power supply switch. Do not touch with wet hand. Do not use hot water or volatileliquid. ON OFF Thinner Do notuse! Benzine Tooth powder Cleaning CAUTION Do not dry the air filter with fire.Do not run the air conditioner without the air filter. Do...

10 For Preparation of Heating("Hot Keep") "HOT KEEP"is operated in the following cases. When heating is started: In order to prevent blowing out of cool wind, the indoor unit fan stopped according to the room temperature which heating operation is started. Wait for approx. 2 to 3 min...

11 Is The Unit Installed Correctly For inspection and maintenance When you change your address or the installation place Electric work Confirm the following items for safe and comfortable use of air conditioner.The installation work is to be burden on the sales dealer, and do not conduct it by yours...

12 Installation Manual For Indoor Unit 1. Safety precautions WARNING Please read these "Safety Precautions" first then accurately execute the installation work.Though the precautionary points indicated herein are divided under two headings,and , those points which are related to the strong p...

14 (4) Preparation for suspending the unit (a) Size of hole at ceiling and position of hanging bolts <Combination with silent panel> 57 A B C (Hanging bolt position) (Ceiling hole size) (Panel dimensions) 137 30 30 (Ceiling ~ panelwrap dimensions) (Ceiling ~ panel wrap dimensions) (Hanging bol...

15 (5) Installation of indoor unit Fix the indoor unit to the hanger bolts.If required, it is possible to suspend the unit to the beam, etc.Directly by use of the bolts without using the hanger bolts. When the dimensions of main unit and ceiling holes does not match, it can be adjusted with the slot...

16 VP 30 Secure the elevation as high as possible(approx. 100 mm) A downhill grade of1/100 or more Drain hose Joint for VP 25(Local procurement) 600 (Maxi m um local drain up dimension) Right overhead 290~325mm Attached drain hose clamp Drain piping Main unit Drain situation can be checked with tran...

18 5. Electric wiring WARNING DANGER OF BODILY INJURY OR DEATH TURN OFF ELECTRIC POWER AT CIRCUIT BREAKER OR POWER SOURCE BEFOREMAKING ANY ELECTRIC CONNECTIONS. GROUND CONNECTIONS MUST BECOMPLETED BEFORE MAKING LINE VOLTAGE CONNECTIONS. (1) Selection of size of power supply and interconnecting wires...

19 For remote type, flash times 1 2 3 4 5 6 7 8 9 10 1 1 12 13 14 15 16 17 18 19 20 Failure description Indoor ambient temp. sensor failure Indoor coil temp. sensor failure Outdoor ambient temp. sensor failure Outdoor coil temp. sensor failure Over -current protection High pressure abnormal Power su...