Page 2 - CONTENTS
JB0112-070-INS-LAB-RevB14 2 CONTENTS INTRODUCTION ................................................................................................... 3 INTENDED USE ............................................................................................ 3 SYMBOLS KEY ...............................
Page 4 - Symbols Key
JB0112-070-INS-LAB-RevB14 4 Symbols Key O Off I On ~ Alternating current IPX0 Enclosed equipment without protection against ingress of waterAttention (read the instructions) II Class II (not applicable for UL1431)BF: This product is in accordance with the degree of protection against electric shock ...
Page 5 - IMPORTANT SAFETY PRECAUTIONS
JB0112-070-INS-LAB-RevB14 5 IMPORTANT SAFETY PRECAUTIONS When using electrical products, especially when children are present, always follow basic safety precautions, including the following: DANGER: Indicates a potential hazard situation or unsafe practice that, if not avoided, will result in death...
Page 9 - SETUP; MAINTENANCE/Cleaning the Nebulizer Cup; WARNING: Ensure that the nebulizer compressor is
JB0112-070-INS-LAB-RevB14 9 SETUP Info: Before initial operation, clean the nebulizer cup assembly following the instructions given in MAINTENANCE/Cleaning the Nebulizer Cup . WARNING: Ensure that the nebulizer compressor is unplugged during setup. 1. Before each use, inspect the compressor and nebu...
Page 10 - WARNING: Before use, check that all parts are securely
JB0112-070-INS-LAB-RevB14 10 Info: The reservoir tube, shown in the illustration earlier in this manual, acts as a holding tank for the mist, reducing the amount lost during treatment. Its use is optional. If you wish to use the reservoir tube, install it now on the small end of the T adapter. 8. In...
Page 11 - Move the ON/OFF switch to the ON position to start the; Cleaning the Nebulizer Cup
JB0112-070-INS-LAB-RevB14 11 OPERATION Info: The drawing board must be removed from the nebulizer housing before use. To remove the drawing board, push the button and slide the drawing board in the opposite direction from the cover arrow. Nebulizer Operation s NOTICE: The Neb-u-Tyke Neb-a-Doodle Neb...
Page 12 - Drawing Board Operation; WARNING: This product contains small parts that may; present a choking hazard to small children. Always use
JB0112-070-INS-LAB-RevB14 12 Drawing Board Operation push button arrow 2 1 To remove the drawing board, push the button and slide the drawing board in the opposite direction from the cover arrow.To install the drawing board, insert the drawing board on the side with the housing arrow that matches th...
Page 13 - Safety Overload; NOTICE: Do not exceed 30 minutes of continuous; The motor of this device has a built-in thermal overload
JB0112-070-INS-LAB-RevB14 13 Safety Overload s NOTICE: Do not exceed 30 minutes of continuous operation. 1. The motor of this device has a built-in thermal overload protector. Should the motor overheat, the protector will automatically shut off the motor. Should this occur, move the ON/OFF switch to...
Page 15 - Replacing the Filter; the filter cap located next to the ON/OFF switch.; Storage
JB0112-070-INS-LAB-RevB14 15 Replacing the Filter s NOTICE: Change the filter once every 30 days or when the filter changes color. Additional filters can be purchased at www.grahamfield.com or from your Graham-Field authorized distributor. 1. Ensure that ON/OFF switch is in the OFF position. Open th...
Page 16 - TROUBLESHOOTING; Problem
JB0112-070-INS-LAB-RevB14 16 TROUBLESHOOTING If your Neb-u-Tyke Neb-a-Doodle Nebulizer Compressor fails to function, consult the following Troubleshooting guide. If the problem persists, consult your Graham-Field authorized distributor. Problem Cause and Solution Device doesn’t operate Check if plug...
Page 17 - SPECIFICATIONS; Specification
JB0112-070-INS-LAB-RevB14 17 SPECIFICATIONS Specification Description Max pressure (compressor) 32.5 PSIMax flow rate Approximately 12 LPM Nebulization rate .33 ml/min Particle dimension .5 - 5 microns Capacity 5 ml Filter Sponge Dimensions (LxWxH) 10" × 6.5" × 4.2" (255 mm x 166 mm x 10...
Page 18 - LIMITED WARRANTY
JB0112-070-INS-LAB-RevB14 18 LIMITED WARRANTY SCOPE OF WARRANTY GF Health Products, Inc. (“GF”) warrants to the original purchaser only that it will replace or repair components, at GF’s sole discretion, that are defective in material or workmanship under normal use and service. All warranties are c...
Page 20 - Made in China
Manufactured for: GF Health Products, Inc. 2935 Northeast Parkway Atlanta, Georgia 30360 USA Telephone: 770-368-4700 Fax: 770-368-2386 www.grahamfield.com Made in China
Page 21 - Compresor de Nebulizador; Manual de Usuario
Lea antes de operar el nebulizador. Guarde este manual para referencia en el futuro.Info: La más reciente versión de este manual podrá ser encontrado en www.grahamfield.com. La Ley Federal (USA) restringe este aparato para ventas por la orden de su médico. Este aparato no debe ser utilizado si el op...
Page 22 - CONTENIDOS
JB0112-070-INS-LAB-RevB14 2 GF Health Products, Inc. no es responsable de errores tipográficos. Para obtener la información más actualizada y vigente relativa a los envases, garantías, productos y especificaciones, incluyendo la versión más actualizada de estas instrucciones, por favor visite nuestr...
Page 24 - Símbolos
JB0112-070-INS-LAB-RevB14 4 Símbolos O Apagado I Encendido ~ Corriente alternando IPX0 El equipo no tiene protección contra sumergiendo en aguaAtención (lea las instrucciones) II Clase II (no aplicable para UL1431)BF: Este producto está en concordancia con el grado de protección sobre el riesgo de d...
Page 25 - DIRECTIVAS IMPORTANTES DE SEGURIDAD
JB0112-070-INS-LAB-RevB14 5 DIRECTIVAS IMPORTANTES DE SEGURIDAD PELIGRO: Indica una situación de peligro o una practica insegura que, si no es evitada, resultará en muerte o heridas serias a la persona. ADVERTENCIA: Indica una situación de peligro o una practica insegura que, si no es evitada, puede...
Page 29 - ENSAMBLAJE; Mantenimiento/Limpieza de la Taza del Nebulizador; ADVERTENCIA: Antes de conectar el cordón de; nebulizador para daño reemplace si es necesario.
JB0112-070-INS-LAB-RevB14 9 ENSAMBLAJE Aviso: Antes de operación inicial, limpie la taza del nebulizador siguiendo las instrucciones escritos en la sección Mantenimiento/Limpieza de la Taza del Nebulizador . ADVERTENCIA: Antes de conectar el cordón de electricidad, asegure que el interruptor de ON/O...
Page 30 - ADVERTENCIA: Antes de uso, verifique que todas las
JB0112-070-INS-LAB-RevB14 10 Info: La manga de reserva, en la ilustración superior del manual, es como un tanque de retención para reducir la cantidad de medicamento perdido durante tratamiento. Es opcional. Si desea usar la manga de reserva, posicione en la parte inferior del adaptador T. 8. Instal...
Page 31 - Mantenimiento/Limpieza de la
JB0112-070-INS-LAB-RevB14 11 OPERACIÓN Info: La tabla de dibujar tiene que ser apartado del nebulizador antes de uso. Para quitar la tabla de dibujar, empuje el botón y deslice la tabla de dibujar en la dirección opuesto de la flecha en la tapa. Operación del Compresor de Nebulizador s AVISO: El Com...
Page 32 - Operación de la Tabla de Dibujar; ADVERTENCIA: Este producto contiene partes pequeñas
JB0112-070-INS-LAB-RevB14 12 Operación de la Tabla de Dibujar botón flecha 2 1 Para quitar la tabla de dibujar, empuje el botón y deslice la tabla de dibujar en la dirección opuesto que la flecha en la tapa.Para instalar la tabla de dibujar, inserte la tabla de dibujar en el lado con la flecha en el...
Page 33 - Este compresor contiene un dispositivo de protección
JB0112-070-INS-LAB-RevB14 13 Seguridad en caso de sobrecarga s AVISO: No debe exceder más de 30 minutos de operación continuo. 1. Este compresor contiene un dispositivo de protección termal. Si el motor comienza a sobrecalentarse, se apagará automáticamente. Si esto ocurre, posicione el interruptor ...
Page 34 - Limpieza de la Taza del Nebulizador; Después de cado uso, desensamble la taza; Limpieza de la Tabla de Dibujar
JB0112-070-INS-LAB-RevB14 14 MANTENIMIENTO Limpieza de la Carcasa del Compresor ADVERTENCIA: Riesgo de electrocución. No remueve carcasa externa de este aparato. Todo desensamblaje y mantenimiento de este aparato debe ser realizado por un técnico de servicio cualificado. ADVERTENCIA: Este aparato no...
Page 35 - Instrucciones para el cambio del filtro de aire; Remueva la tapa del filtro de aire localizado al lado del; AVISO: No utilice algodón o cualquier material como filtro.
JB0112-070-INS-LAB-RevB14 15 Instrucciones para el cambio del filtro de aire Aviso: Cambie el filtro cada 30 días o cuando el filtro cambia color. Filtros adicionales pueden ser comprados en www.grahamfield.com o de su distribuidor autorizado de Graham-Field. 1. Remueva la tapa del filtro de aire lo...
Page 36 - DETECTANDO PROBLEMAS; Problema
JB0112-070-INS-LAB-RevB14 16 DETECTANDO PROBLEMAS Si su Neb-u-Tyke Neb-a-Doodle Compresor de Nebulizador falla, consulte a la guía de Detectando Problemas debajo. Si el problema continua, llame a su distribuidor autorizado de Graham-Field. Problema Causa y Solución El aparato no funciona Verifique s...
Page 37 - ESPECIFICACIONES; Especificación
JB0112-070-INS-LAB-RevB14 17 ESPECIFICACIONES Especificación Descripción Presión máxima del compresor 32.5 PSI Flujo máximo Aproximadamente 12 LPM Tasa de nebulización 0.33 ml/min Tamaño de partícula .5 - 5 microns Capacidad 5 ml Filtro Esponja Dimensión (largo x anchura x altura) 10" × 6.5"...
Page 38 - GARANTÍA LIMITADA
JB0112-070-INS-LAB-RevB14 18 GARANTÍA LIMITADA AMBITO DE GARANTÍA GF Health Products, Inc. (“GF”) garantía al comprador original o arrendatario (cual quiera es el “Cliente”) solamente, que va reemplazar o reparar componentes, a la decisión solo de GF, cuales son defectos en material o calidad utiliz...
Page 40 - Fabricado en China
Fabricado para: GF Health Products, Inc. 2935 Northeast Parkway Atlanta, Georgia 30360 USA Telephone: 770-368-4700 Fax: 770-368-2386 www.grahamfield.com Fabricado en China