Graco 3A0595D - Manuals - manualsarea.com

Page 2 - CONTENTS

2 CONTENTS Important ........................................................................ 3Burst Hazard .................................................................. 3Fire & Explosion Precautions ....................................... 3Toxic Fumes Hazard ..................................

Page 3 - FIRE & EXPLOSION PRECAUTIONS; WARNING

3 The following warnings are for the setup, use, maintenance, and repair of this equipment. The exclama-tion point symbol alerts you to a general warning and the hazard symbols refer to procedure-specific risks. When these symbols appear in the body of this manual, refer back to these Warnings. Prod...

Page 6 - Component Identification

6 Component Identification 262361 - Model 1720G Item Description 1 Beltguard 2 Air Filter 3 Oil Fill Port 4 Air Compressor Pump 5 Pump Oil Drain 6 Oil Sight Glass 7 Pilot Valve 8 Engine Switch Item Description 9 Engine 10 Engine Throttle Control 11 Pressure Gauge - Tank Psi 12 Tank Drain Valve 13 Pr...

Page 8 - NEvER attempt to open the drain

8 Component Identification SAFETY RELIEF VALVE: This valve is designed to pre-vent system failures by relieving pressure from the sys-tem when the compressed air reaches a predetermined level. The valve is preset by the manufacturer and must not be modified in any way. To verify the valve is working...

Page 9 - Initial Setup; NOTICE

9 INSTALLATION & PREPARATION INSTRUCTIONS Initial Setup Read safety warnings before setting-up air compres-sor. The following information contains operating and maintenance instructions. Ensure the oil level in the air compressor pump is ad-equate. If low, add sae 30w non-detergent oil. NOTICE I...

Page 10 - Gasoline Engine

10 INSTALLATION & PREPARATION INSTRUCTIONS Gasoline Engine Review “Fire & Explosion Precautions” pg. 3, before fueling. Locate the Safety Decals on your unit and heed their warnings. Read the engine manual accompanying this air com-pressor for correct engine start-up maintenance proce-dures....

Page 11 - OPERATION INSTRUCTIONS; Shutdown

11 OPERATION INSTRUCTIONS Start-Up Read all safety warnings before performing operation. Do not attempt to operate this air compressor until you have read and understood all safety precautions and instructions listed in this manual. 1. Flip the toggle on top of the pilot valve to the upright positio...

Page 12 - MAINTENANCE INSTRUCTIONS

12 MAINTENANCE INSTRUCTIONS Read the instruction manual before performing main-tenance. The following procedures must be performed when stopping the air compressor for maintenance or service. 1. Turn off air compressor.2. Disconnect spark plug wire from engine.3. Open all drains.4. Wait for the air ...

Page 13 - Troubleshooting; Problem

Troubleshooting Engine will not start. Various engine problems. Refer to the engine manual accom-panying your unit. Low engine oil level. Engine is equipped with an Oil Alert System which will not allow the engine to start if oil level is low. Add oil, if needed. Noisy operation. Loose engine pulley...

Page 15 - Notes

Page 16 - Air Compressor - Parts

Page 18 - Pump Assembly - Parts

18 Pump Assembly - Parts 16E739 (for use with Model 1310G)

Page 25 - Technical Data

25 Technical Data MODEL NUMBER 262360 262361 Engine: Honda Size 200cc 270cc Engine Type 4 Stroke, Overhead Valve, Single Cylinder Oil Type SAE 10W 30 Oil Capacity (oz./liters) 20 oz./591 ml 37 oz. /1094 ml Fuel Type Unleaded Gasoline 86 Octane Minimum Fuel Capacity (gallon/liters) .95/3.6 1.6/6.05 E...

Page 26 - Graco Standard Warranty; For Graco Canada Customers; Original instructions. This manual contains English. MM 3A0595; International Offices:

26 Graco Standard Warranty Graco warrants all equipment referenced in this document which is manufactured by Graco and bearing its name to be free from defects in material and workmanship on the date of sale to the original purchaser for use. With the exception of any special, extended, or limited w...