Graco 308613E- Manuals

Page 2 - Warnings; WARNING

Warnings 2 308613E Warnings The following warnings are for the setup, use, grounding, maintenance, and repair of this equipment. The exclama-tion point symbol alerts you to a general warning and the hazard symbols refer to procedure-specific risks. When these symbols appear in the body of this manua...

Page 4 - Installation; Mount Valve

Installation 4 308613E Installation Accessories are available from Graco. Be sure all accessories are properly sized to withstand the pres-sures in the system. Mount Valve Mount the valve on a 0.50 in. (12.7 mm) diameter rod on a mounting fixture or a dispensing machine. The paint gun has a clamping...

Page 5 - Operation; Adjustments; Application Data

Operation 308613E 5 Operation Adjustments Set the actuating air to at least 75 psi (5.2 bar) and start the pump. Set the pump speed and pressure to obtain the desired flow rate. Always use the lowest pump speed nec-essary to achieve desired results. Pressure Relief Procedure 1. Shut off the power to...

Page 6 - Maintenance; Service; Needle, Seat and Packings

Maintenance 6 308613E Maintenance Clean Dispensing Valve and System Daily An important part of the care and maintenance of your automatic dispensing valve is proper flushing. Flush the valve daily with a compatible solvent until all traces of fluid are removed from the valve passages. Perform Pressu...

Page 8 - Air Piston, Spring and Seal

Service 8 308613E 12. Install seat valve into valve housing. 13. Install valve body. Tighten nut. 14. Install RAC guard. Air Piston, Spring and Seal Perform Pressure Relief Procedure , page 5. Remove valve as explained on page 6. Remove air cylinder cap, take out spring and pull out the piston. Clea...

Page 9 - Replacement Parts and Kits (Double Acting Gun 24G980)

Replacement Parts and Kits (Double Acting Gun 24G980) 308613E 9 Replacement Parts and Kits (Double Acting Gun 24G980) 2 1 20 3 4 11 10 12 13 14 15 16 17 18 19 18 9 24 6 5 23 ti16354a 25 8 27 (Not included) 26 (Not included) Ref. Part Description Qty. 1 243161 GUARD, RAC 1 *2 206987 SEAT, valve 1 3 1...

Page 10 - Replacement Parts and Kits (Single Acting Gun 238377)

Replacement Parts and Kits (Single Acting Gun 238377) 10 308613E Replacement Parts and Kits (Single Acting Gun 238377) 5953b 22 17 14 5 6 15 13 12 11 9 8 21 7 10 3 2 1 20 19 4 16 18 28 (Not included) 26 (Not included) Ref. Part Description Qty. 1 243161 GUARD, RAC 1 *2 206987 SEAT, valve 1 3 101748 ...

Page 11 - Troubleshooting

Troubleshooting 308613E 11 Troubleshooting Technical Data Problem Cause Solution Uneven spray pattern Fluid pressure too low Increased pressure to pump, or adjust fluid pressure regulator Spray gun will not stop spraying Fluid pressure too high Reduce pressure to pump, or adjust fluid pressure regul...

Page 12 - Graco Standard Warranty; Graco Information

All written and visual data contained in this document reflects the latest product information available at the time of publication. Graco reserves the right to make changes at any time without notice. Original instructions. This manual contains English. MM 308613 Graco Headquarters: Minneapolis Int...