Page 2 - ASKING FOR ASSISTANCE; Fax
ASKING FOR ASSISTANCE Rev A1 Technical Support : Telephone (818) 772-9100 (800) 545-6900 Fax (818) 772-9120 Technical Support Hours: 8:00 AM to 5:00 PM Monday thru Friday, Pacifi c Time Write To: Gefen, LLC.c/o Customer Service20600 Nordhoff St Chatsworth, CA 91311 www.gefentoolbox.comsupport@gefent...
Page 3 - CONTENTS
CONTENTS 1 Introduction 2 Operation Notes 3 Features 4 Sender Unit Layout 5 Sender Unit Descriptions 6 Receiver Unit Layout 7 Receiver Unit Descriptions 8 Connecting the HDKVM Extra Long Range Extender 9 Wiring Diagram 10 DIP Switch Confi guration 12 Network Cable Wiring Diagram 13 Wall Mounting Ins...
Page 4 - INTRODUCTION
1 Congratulations on your purchase of the GefenToolBox HDKVM Extra Long Range Extender. Your complete satisfaction is very important to us. About Gefen We specialize in total integration for your home theater, while also focusing on going above and beyond customer expectations to ensure you get the ...
Page 5 - OPERATION NOTES; PLEASE READ THESE NOTES BEFORE INSTALLING OR; The shielded cable has an advantage by providing immunity to
2 OPERATION NOTES PLEASE READ THESE NOTES BEFORE INSTALLING OR OPERATING THE HDKVM EXTRA LONG RANGE EXTENDER • CAT-5 or CAT-6 cables should not exceed 330 feet (100 meters). • Shielded (STP) CAT-5 or CAT-6 is recommended. However, un-shielded (UTP) CAT-5 or CAT-6 is acceptable. NOTE: The shielded ca...
Page 6 - FEATURES; Features; • IR; Package Includes
3 FEATURES Features • Supports 1080p Full HD and 3DTV at 330 feet (100 meters) • Extends USB 2.0 up to 330 feet (100 meters) • Supports USB 2.0 480 Mbps • Backward-compatible with USB 1.1 devices • IR backchannel • Ethernet support • Locking Power Supplies • Surface-mountable Package Includes (1) Ge...
Page 7 - SENDER UNIT LAYOUT; Left Side
4 SENDER UNIT LAYOUT Left Side Right Side Top 8 2 1 3 4 7 5 9 6
Page 8 - SENDER UNIT DESCRIPTIONS
5 1 USB LINK Transmits the USB signals from the Sender Unit to the Receiver Unit usingCAT-5e / CAT-6 cable. 2 LINK Transmits the HDMI, Ethernet, and IR signals from the Sender Unit to the Receiver Unit using CAT-5e / CAT-6 cable. 3 ETH Connect a CAT-5 cable from a port on a local Ethernet switch to ...
Page 9 - RECEIVER UNIT LAYOUT
6 RECEIVER UNIT LAYOUT Left Side Right Side Top 9 2 1 3 4 7 8 5 6 10
Page 10 - RECEIVER UNIT DESCRIPTIONS; Connects an Ethernet cable from this port to a network device.
7 RECEIVER UNIT DESCRIPTIONS 1 Ext IR Connect an IR Extender (Gefen part no. EXT-RMT-EXTIR) cable from this port to the Hi-Def source to extend the IR control. 2 ETH Connects an Ethernet cable from this port to a network device. 3 LINK Transmits the HDMI, Ethernet, and IR signals from the Sender Uni...
Page 11 - How to Connect the HDKVM Extra Long Range Extender
8 CONNECTING THE HDKVM EXTRA LONG RANGE EXTENDER How to Connect the HDKVM Extra Long Range Extender 1. Connect the Hi-Def source to the Sender Unit using the included HDMI cable. 2. Use an HDMI cable to connect the Receiver Unit to an HDTV display. 3. Connect the USB host device to the Sender Unit. ...
Page 12 - Wiring Diagram for the HDKVM Extra Long Range Extender; HDMI CABLE; This product should always be connected to a grounded
9 CONNECTING THE HDKVM EXTRA LONG RANGE EXTENDER Wiring Diagram for the HDKVM Extra Long Range Extender GTB-HDKVM-ELR CAT-5 LINK CABLE / ETHERNET (Up to 330 ft) HDMI CABLE Sender Router Router Receiver Sender USB CABLE HDMI Display Home TheaterMultimedia PC USB Printer Attention: This product should...
Page 13 - DIP SWITCH CONFIGURATION; Receiver Unit; • ON
10 DIP SWITCH CONFIGURATION Receiver Unit The Gefen HDKVM Extra Long Range Extender contains four (4) DIP switches on the bottom of the Receiver Unit (the Sender Unit does not contain DIP switches). Each of these DIP switches performs a different function. DIP Switch 1 - EDID Mode (Default = ON) • O...
Page 14 - If an HDMI device is connected, set DIP 3 in the OFF position.
11 DIP SWITCH CONFIGURATION Receiver Unit DIP Switch 2 - Hot Plug Detect (Default = OFF)* • ON - HPD Pass-Through HPD follows upstream HPD towards the source. The HPD signal will refl ect the connection status between the display device and the source device. If the source or monitor is temporarily ...
Page 15 - Orange; NETWORK CABLE WIRING DIAGRAM
1 2 3 4 5 6 7 8 Gefen recommends the TIA/EIA-568-B wiring option. Please adhere to the table below when fi eld terminating cable for use with Gefen products. Pin Color 1 Orange / White 2 Orange 3 Green / White 4 Blue 5 Blue / White 6 Green 7 Brown / White 8 Brown 12 NETWORK CABLE WIRING DIAGRAM CAT-...
Page 16 - WALL MOUNTING INSTRUCTIONS
13 WALL MOUNTING INSTRUCTIONS The GefenToolBox HDKVM Extra Long Range Extender Sender Unit and Receiver Unit may be mounted vertically on a wall or in a cabinet with wood/drywall screws as shown in the diagram above. There should be an inch or two of clearance between the edges of the unit and any w...
Page 17 - SPECIFICATIONS
14 Maximum Pixel Clock................................................................................225 MHz Input Video Signal................................................................................1.2 Volts p-p Input DDC Signal.................................................................
Page 18 - WARRANTY; Proof of sale may be required in order to claim warranty.; PRODUCT REGISTRATION; under the Support section of the Gefen Web site.
WARRANTY 15 Gefen warrants the equipment it manufactures to be free from defects in material and workmanship. If equipment fails because of such defects and Gefen is notifi ed within two (2) years from the date of shipment, Gefen will, at its option, repair or replace the equipment, provided that th...
Page 19 - Pb
Rev A1 20600 Nordhoff St., Chatsworth CA 91311 1-800-545-6900 818-772-9100 fax: 818-772-9120 www.gefentoolbox.com [email protected] Pb This product uses UL listed power supplies.