Page 2 - ASKING FOR ASSISTANCE
Technical Support : Telephone (818) 772-9100 (800) 545-6900 Fax (818) 772-9120 Technical Support Hours: 8:00 AM to 5:00 PM Monday thru Friday (PST). Write To: Gefen Inc. c/o Customer Service 20600 Nordhoff St Chatsworth, CA 91311 www.gefen.com [email protected] Notice Gefen Inc. reserves the right t...
Page 3 - CONTENTS
CONTENTS 1 Introduction 2 Operation Notes 3 Features 4 Sender Panel Layout 5 Sender Panel Descriptions 6 Receiver Panel Layout 7 Receiver Panel Descriptions 8 Connecting And Operating The Extender 9 DIP Switch Confi guration 11 Network Cable Wiring Diagram 12 Specifi cations 13 Warranty
Page 4 - INTRODUCTION
1 Congratulations on your purchase of the Extender for HDMI 1.3 over one CAT6. Your complete satisfaction is very important to us. Gefen Gefen delivers innovative, progressive computer and electronics add-on solutions that harness integration, extension, distribution and conversion technologies. Gef...
Page 5 - OPERATION NOTES; READ THESE NOTES BEFORE INSTALLING OR; • When
2 OPERATION NOTES READ THESE NOTES BEFORE INSTALLING OR OPERATING THE EXTENDER FOR HDMI 1.3 OVER ONE CAT6 • The Extender for HDMI 1.3 over one CAT6 was designed for use with high quality CAT-6a (augmented) cabling. This unit will either not perform to specif cation or refuse to operate completely if...
Page 6 - FEATURES
3 Features • Flexible extension of high-bandwidth HDMI 1.3 thanks to inexpensive and widely-available CAT6 cable • Audio and video are transmitted digitally over the CAT6 cable for zero signal loss • Single Link Range (maximum resolution): 1080p/60, 12-bit color depth • Compliant with HDMI 1.3, HDMI...
Page 7 - SENDER PANEL LAYOUT
4 Front Panel Back Panel 1 2 3 4 SENDER PANEL LAYOUT
Page 8 - SENDER PANEL DESCRIPTIONS
5 1 5V DC Power Receptacle Connect the included 5V DC power supply between this input and an open wall power socket. 2 Power LED Indicator This LED will become active once the included 5V DC power supply is properly connected between the unit and an open wall power socket. 3 HDMI Input With Mono•LOK...
Page 9 - RECEIVER PANEL LAYOUT
6 Front Panel Back Panel 1 2 3 5 4 RECEIVER PANEL LAYOUT
Page 10 - connected between the unit and an open wall power socket.; RECEIVER PANEL DESCRIPTIONS
7 1 Equalization Adjustment This trimpot is used to equalize the signal to compensate for the extension distance and the quality/skew variances that are found in different CAT-6a cabling brands. 2 HDMI Input With Mono•LOK Secure Connector This input will accept a single HDMI source for extension. Th...
Page 11 - How to Connect the Extender for HDMI 1.3 over one CAT6; Extender for HDMI 1.3 over; How to Equalize the Extender for HDMI 1.3 over one CAT6; Extender for HDMI 1.3 over one CAT6 receiving unit; CONNECTING AND OPERATING THE EXTENDER
8 How to Connect the Extender for HDMI 1.3 over one CAT6 1. Connect a HDMI cable (one is supplied) between the HDMI output on a HDMI source device and the HDMI input on the Extender for HDMI 1.3 over one CAT6 sending unit . 2. Connect a single CAT-6a cable between the sending and receiving units. NO...
Page 12 - DIP SWITCH CONFIGURATION; DIP SWITCH CONFIGURATION – DEEP COLOR
9 DIP SWITCH CONFIGURATION DIP SWITCH CONFIGURATION – DEEP COLOR By default, Deep Color support is disabled (DIP #2 in the OFF position). If Deep Color support is needed, you can change the position of one of the DIP switches on the bottom of the receiver: 1. If the Receiver unit is currently being ...
Page 13 - DIP SWITCH CONFIGURATION – EDID
10 DIP SWITCH CONFIGURATION DIP SWITCH CONFIGURATION – EDID Under normal circumstances, a source device (digital and analog) will require information about a connected device/display to assess what resolutions and features are available. The source can then cater its output to send only resolutions ...
Page 14 - NETWORK CABLE WIRING DIAGRAM
1 2 3 4 5 6 7 8 Gefen has specif cally engineered their products to work with the TIA/EIA-568-B specif cation. Please adhere to the table below when f eld terminating cable for use with Gefen products. Failure to do so may produce unexpected results and reduced performance. This product was designed...
Page 15 - SPECIFICATIONS
12 Video Amplif er Bandwidth ....................................................................... 225 MHz Single Link Max. Resolution ................................................ 1080p/60, 12 bit color Input DDC Signal ......................................................................... ...
Page 16 - WARRANTY
13 Gefen warrants the equipment it manufactures to be free from defects in material and workmanship. If equipment fails because of such defects and Gefen is notif ed within two (2) years from the date of shipment, Gefen will, at its option, repair or replace the equipment, provided that the equipmen...