GE DSKS433EBWW - Manuals

model-name

GE DSKS433EBWW Dryer – User Manual, Installation Manual, Manual in PDF format online.

Manuals:

User Manual GE DSKS433EBWW

1 Page 1
2 Page 2
3 Page 3
4 Page 4
5 Page 5
6 Page 6
7 Page 7
8 Page 8
9 Page 9
10 Page 10
11 Page 11
12 Page 12
13 Page 13
14 Page 14
15 Page 15
16 Page 16

Installation Manual GE DSKS433EBWW

1 Page 1
2 Page 2
3 Page 3
4 Page 4

Summary

Page 2 - FOR THREE-WIRE SUPPLY; WIRE RECEPTACLE; ELECTRICAL CONNECTION DETAILS; DO NOT USE EXTENSION CORD WITH THIS APPLIANCE; GROUNDING INSTRUCTIONS; POWER SUPPLY CORD; FOR PERSONAL SAFETY, THIS APPLIANCE MUST BE

FOR THREE-WIRE SUPPLY (208V & 240V MODELS) • Remove terminal block cover. ‡&RQQHFWWZR+27OLQHVWRRXWHUVFUHZV/DQG/RI terminal block. • Connect Neutral line to center VFUHZ1RIWHUPLQDOEORFN • Properly strain relief the cordset or cable to the cable entry hole with UL recognized strain relief. • R...

Page 3 - IF YOUR DRYER COMES WITH TOP EXHAUST,

DRYER TOP VIEW IF YOUR DRYER COMES WITH REAR EXHAUST, TO CHANGE TO SIDE OR BOTTOM EXHAUST: • Remove access panel at back of dryer to gain access to internal ducts. • Disconnect duct exhaust from blower housing UHPRYHWDSHVHFXULQJGXFW FOR SIDE EXHAUST: ‡5HPRYHGHVLUHGNQRFNRXWSODWHHLWKHUULJKWRUOHIWVLGH‡...

Page 4 - • If your dryer is approved for installation in an alcove or closet ,; WXUQV1RNLQNVRUREVWUXFWLRQVWRDLUÀRZ; NOTE: The clearances stated above are minimums.; ZRƒHOERZVZLOOEHWUHDWHGOLNHRQHƒHOERZ; FLEXIBLE

EXHAUST LENGTH CALCULATION RIGID (Preferred) 3DUWVDUHDYDLODEOHIURP\RXUORFDOVHUYLFHRUJDQL]DWLRQ :;;µ;·'XFW :;;(OERZ :;;µ;·'XFW :;;$OXPLQXPKRRG 4 ALCOVE OR CLOSET INSTALLATION • If your dryer is approved for installation in an alcove or closet , it will be stated on a label on the dryer back. The inst...

Manual GE DSKS433EBWW

1 Page 1
2 Page 2
3 Page 3
4 Page 4

Summary

Page 2 - GROUNDING INSTRUCTIONS; DO NOT USE EXTENSION CORD WITH THIS APPLIANCE; FOR THREE-WIRE SUPPLY; WIRE RECEPTACLE

PAGE 2 ELECTRICAL CONNECTION DETAILS OBSERVE ALL GOVERNING CODES AND ORDINANCES GROUNDING INSTRUCTIONS DO NOT USE EXTENSION CORD WITH THIS APPLIANCE FOR THREE-WIRE SUPPLY FOR FOUR-WIRE SUPPLY (208V & 240V MODELS) (208V & 240V MODELS) The operating voltage (Volts), Amperage (Amps) and Frequen...

Page 3 - ALTERNATE EXHAUST DIRECTIONS; EXHAUST SYSTEM CHECK LIST; EXHAUST INFORMATION; WARNING - IN CANADA AND IN THE UNITED; STATES, THE REQUIRED EXHAUST DUCT DIAMETER; THAN SPECIFIED IN THE EXHAUST LENGTH TABLE.; EXHAUST CONNECTION; WARNING - TO REDUCE THE RISK

ALTERNATE EXHAUST DIRECTIONS PAGE 3 Left knockout Bottom knockout Right knockout For Rear ExhaustFor Side Exhaust Rigid Metallic Ducting Cut Here EXTENSION DUCT It is importat to replace the ground clip after cutting the exhaust duct, (on rear exhaust model). Blower Front of dryer 152 mm 295 mm 115 ...

Page 4 - EXHAUST LENGTH CALCULATION; WHEN INSTALLED IN MANUFACTURED; CHECK THE FOLLOWING; ALCOVE OR CLOSET; RECOMMENDED MAXIMUM LENGTH; CONNECTING THE DRYER; RIGID METAL TRANSITION DUCT

PAGE 4 EXHAUST LENGTH CALCULATION WHEN INSTALLED IN MANUFACTURED (MOBILE) HOMES - USE OF CASTERS (120V PORTABLE MODELS ONLY) NOTE TO INSTALLER - ...AFTER INSTALLATION CHECK THE FOLLOWING ALCOVE OR CLOSET INSTALLATION Parts are available from your local service organization: If your dryer is approved...

GE Dryers Manuals