Furuno 525TID-TMD - Manuals

Furuno 525TID-TMD – Manual in PDF format online.

Manuals:

Manual Furuno 525TID-TMD

1 Page 1
2 Page 2
3 Page 3
4 Page 4

Summary

Page 2 - Type of Boat; Installation; Assembling the Transducer & Bracket; upper; Compensating for Transom Angle; No shim is needed for; Hole Drilling

Figure 2. Headroom required on stepped transom TM258: 244 mm (9-3/4") headroom Type of Boat • Single drive —Mount a minimum of 15 cm (6") beyond the swing radius of the propeller (see Figure 1). • Twin drive —Mount between the drives a minimum of 15 cm (6") beyond the swing radius of the...

Page 3 - Mounting & Adjusting the Bracket; CAUTION; Testing on the Water; To improve performance; Stabilizing the Bracket

Mounting & Adjusting the Bracket CAUTION: Do not position the transducer deeper in the water than necessary to avoid increasing drag, spray, and water noise and reducing boat speed. CAUTION : The stainless steel bracket must be isolated from a metal hull to prevent electrolytic corrosion. If no ...

Page 4 - When reattaching the; Cable Routing; or; Checking for Leaks; that do not interlock must; Cleaning; AIRMAR; TECHNOLOGY CORPORATION

4 Copyright © 2009 Airmar Technology Corp. All rights reserved. 2. Apply sealant to the threads of the remaining screw to prevent water seeping into the transom. 3. Fasten the stabilizing screw into place with a socket wrench. For clear access to the screw, remove the transducer assembly from the br...

Furuno Manuals