FFHT1814V Publication No: 5995718268 # Functional Parts 3 10/19 * Non-Illustrated Parts DOOR Model Index: A FFHT1814V (FFHT1814VB0) B FFHT1814V (FFHT1814VW0) POS. NO PART NO. DESCRIPTION 1 5304511145 A - Badge, Frigidaire, black 1 5304511144 - B Badge, Frigidaire, white 2 5304522117 A - Door Assembl...
2 Ice Maker Installation Instructions 1. Unplug refrigerator from electrical outlet. 2. Lift the freezer shelf up and out. Set aside. See Figure 1. 3. Remove water inlet and electrical cover, located on the inside of the unit, by inserting a flathead screwdriver on left side of opening in the small ...
Page 3 - *If you have a unit with an access cover,
3 Ice Maker Installation Instructions 9. To install the ice bin, the freezer shelf needs to be in the lowest position. Slide the ice bin between the side wall and the right side of the ice maker housing positioned on the shelf. See Figure 7. 10. Locate the Ice maker installation label on the rear ou...
4 Ice Maker Installation Instructions (with access cover) NOTE Ensure power cord is aligned with the notch at the bottom of the access cover and the water line is located inside the notch at the top right of the cover. 16. Plug the connector on the water valve wire har- ness into the connector abo...
Page 5 - Ice Maker Installation Instructions (without access cover); Connecting Ice Maker to Water Supply
5 Ice Maker Installation Instructions (without access cover) 19. Remove the connector box from the unit with a Philips screwdriver. Discard screw. See Figure 15. 20. Open the connector box using a flat head screwdriver. Insert at the notched point and turn. Insert the water valve in the hole in the ...
Page 6 - Before Installing The Water Supply Line, You Will Need:; Smart Choice; WARNING; To Avoid Property Damage:; IMPORTANT
6 Connecting Ice Maker to Water Supply Before Installing The Water Supply Line, You Will Need: • Basic Tools: adjustable wrench, flat blade screwdriver, and Phillips screwdriver • Access to a household cold water line with water pressure between 30 and 100 psi. • A water supply line preferably made ...
Page 7 - To Connect Water Supply Line To Ice Maker Inlet Valve; Units with access cover; Units without access cover
7 Connecting Ice Maker to Water Supply To Connect Water Supply Line To Ice Maker Inlet Valve 1. Disconnect refrigerator from an electrical power source. 2. Place the end of water supply line into the sink or a bucket. Turn ON the water supply and flush the supply line until the water is clear. Turn ...