Frigidaire FGB24L2AB - Manuals

5 Avoid fire hazard or electrical shock. Do not use an adaptor plug, anextension cord, or remove grounding prongfrom electrical power cord. Failure to followthis warning can cause serious injury, fire ordeath. Grounding Instructions (electric ignjtion models only) IMPORTANT: READ AND SAVE THESE INST...

6 Oven Baking "Baking" means to cook foods such as cakes or casseroles by dry heat in a covered or uncovered pan. Roasting, often confusedwith baking, means to cook meat in an uncovered pan. To Bake or Roast, follow the instructions in the Setting Oven Controls section. Air Circulation in th...

7 Oven Cleaning Non Self-Clean Oven (some models) Porcelain has a smooth finish and is a type of glass fused to metal. Oven cleaners can be used on all interior oven surfaces.REMOVE SPILLOVERS AND HEAVY SOILING AS SOON AS POSSIBLE. REGULAR CLEANING WILL REDUCE THE NUMBER OF MAJOR CLEANING LATER. Adh...

8 Oven Cleaning (continued) Cleaning the Self-Clean Oven (some models) Adhere to the following cleaning precautions • Allow the oven to cool before cleaning.• Wear rubber gloves when cleaning any exterior parts of the oven manually. During self-cleaning cycle, the outside of the oven can become very...

9 Surfaces Aluminum (Trim Pieces) Glass, Painted and Plastic Body Parts and Decorative Trim Control Panel Porcelain Enamel Broiler Pan and Grid(somemodels), Door Liner, BroilerDrawer Oven and Broiler Rack(s) Oven Door How to Clean Use hot, soapy water and a cloth. Dry with a clean cloth. DO NOT scou...

10 Single Oven Models Only Before Setting Oven Controls Oven Vent Location The oven is vented through the upper control panel trim and grille or through the bottom grille of the upper control panel. When the oven is on, warm air is released through the vents. This venting is necessary for proper bur...

11 Single Oven Models Only (continued) General Cleaning (continued) To Remove and Replace Oven Bottom (Single Oven Models) To Remove the Oven Bottom: 1. Lift up the lift tab at the back of the oven bottom 2. Slide oven bottom out, and lift it up and out. To Replace the Oven Bottom: 1. Slide horizont...

12 88:88 CLOCK TIMER To Set the Clock When the range is first plugged in, or when the power supply to the appliance has been interrupted, “12:00” will flash in thedisplay window. 1. Push CLOCK button to select clock entry mode. A beep will be heard. 2. Push UP or DOWN ARROW to set appropriate time. ...

13 Models with Two Ovens To bake on one rack , place the rack on position 3. To bake on two racks , place the racks on positions 1 and 4. Models with Two Ovens Double Oven Models Only (continued) Before Setting Oven Controls Oven Vent Location The oven is vented through the upper control panel trim ...

14 Double Oven Models Only (continued) Setting Oven Controls Bake (upper oven) 1. Arrange oven racks while the oven is still cool. See "Arranging Oven Racks"under Before Setting Oven Controls . 2. Push in and turn the Temperature Control knob to the desired temperature. 3. Preheat the oven f...

15 Double Oven Models Only (continued) General Cleaning (continued) To Remove and Replace Oven Bottoms To Remove the Oven Bottom (upper oven): 1. Remove racks, broiler pan and wire guides. 2. Using the finger openings on each side of the oven bottom, pull out and lift up theoven bottom. To Replace t...

16 Double Oven Models Only (continued) Changing Oven Light Be sure the oven is unplugged and all parts are COOL before replacing the oven light. Wear a leather-faced glove for protection against possiblebroken glass. Use the rocker switch on the control panel to turn the oven light on or off. To Cha...

17 POSSIBLE CAUSE/SOLUTION Electronic control has detected a fault condition. Push CANCEL to clear the display and stop the display from beeping. Reprogram the oven. If a fault reoccurs, recordthe fault number, push the CANCEL pad and contact an authorized servicer. Poor installation. Place a level ...

Your appliance is covered by a one year limited warranty. For one year from your original date ofpurchase, Electrolux will pay all costs for repairing or replacing any parts of this appliance that prove to bedefective in materials or workmanship when such appliance is installed, used and maintained ...