Friedrich P08S - Manuals

PARTS 1. Control panel 2. Remote control receiver 3. Hot air-outlet 4. Evaporator’s filter 5. Cool air-inlet 6. Air-outlet’s joint part 7. Cool air-outlet 8. Condenser’ s filter 9. Hot air-inlet 10. Drain hole 5

DISPLAY FUNCTIONS KEY Press to turn unit "ON" or "OFF". 2. MODE Press this key to select cooling, heating, or dehumidifying. 3. TEMPERATURE REGULATION KEY (UP) - During cooling function ： This key raises the preset temperature by 1°F each time it is pressed and the maximum limit is 8...

MAINTENANCE AND CLEANING 8. SLEEP CONTROL FUNCTION 1. While in cooling mode, press the SLEEP key to set the temperature. It increases 2°F after an hour and at most increases 4°F after 2 hours. 2. While in heating mode, press the SLEEP key to set the temperature. It decreases 2°F after hour and at mo...

9 REMOTE CONTROL FUNCTIONS Instruction for the operating keys: When a remote control signal is transmitted, a transmission icon on the display flashes once, indicating the signal has been transmitted.

DRAIN PIPE NOTICE This unit can evaporate the condensation and distribute through the exhaust hose automatically. 1. The drain pipe doesn’t have to be installed, when the unit is in cool mode. Please make sure that the rubber cap is locked on drain hole, when the unit is running. 2. When operating t...

MAINTENANCE AND CLEANING MAINTENANCE PLEASE DISCONNECT THE POWER CORD BEFORE CLEANING. AIR FILTER The air filter located on the left hand side of the unit can be removed simply by pulling the frame up. Clean the air filter with a vacuum cleaner ensuring all dust is removed. CONDENSER/EVAPORATOR Use ...

INSTALLATION PLACE FOR USE 1. Because the machine distributes hot air, please don’t place or operate in a narrow place.2. Do not work the machine in a humid place.3. Don’ t place the machine in a sunlit corner otherwise the unit might shut down due to the overheat and the color of the machine may so...

INSTALLATION WINDOW KIT INSTALL 1. Install the Flexible Exhaust Hose and the Adjustable Window Slider Kit as depicted in Fig.1 & Fig.1a. How to enjoy heating function? 1. For heating function: remove the exhaust hose from the unit, as shown in "Fig.01“.2. As shown in "Fig.02“, slide the ...

TROUBLESHOOTING Error Code Cause Troubleshooting E1 Electrical short on both temperature sensor and PCB Contact an electrician for repair E2 Electrical short of temperature sensor copper tube and PCB wiring Contact an electrician for repair E4 Indicates water tank full or poor contact of signal plug...