Foster KS 60 - Manuals - manualsarea.com

Page 7 - Installation room

Installation room For proper operation of the gas appliance, it is essential that the room has anatural air flow from openings on the external walls providing sufficient air for combustion of the gas. These openings must have a free air -flow cross-section of at least 100 cm² (it is possible to make...

Page 9 - CONNECTION TO THE GAS SUPPLY; Using the seal provided.; DO NOT USE OPEN FL AMES WHEN SEARCHING FOR GAS LEAKS.; the use of a rubber flexible hose fastened with hose clamps is

CONNECTION TO THE GAS SUPPLY The supply system must be compliant with the current local standards in thecountry of use. The type of gas for which the oven has been regulated is indicated on the serial number plate located on one of the side edges of the cavity (visible with the door open) and on the...

Page 10 - for natural or methane gas, and; GPL

Adaptation to the gas in use Other types of gas can be used by changing the burner s etting as follows: 1) Make sure that the oven is not connected to the electrical mains.2) Open the oven door completely.3) Extract the bottom of the oven after having removed the retaining screws4) Take off the burn...

Page 11 - Setting of the minimum; after having adjusted the burner, open and close the oven door to

Setting of the minimum The oven thermostat is equipped with a by-pass for the minimum; when changing thetype of gas it is also necessary to adjust the setting in the following manner: Remove the thermostat knob; If the front panel is in glass, remove it by unscrewing the two locking ring nuts locate...

Page 13 - gnition

TURNING ON THE OVE N The oven is equipped with electric ignition. To turn on the oven, open the doorcompletely. Press the thermostat knob slightly and turn it counter-clockwise to themaximum. Press the knob completely to trigger the electric ignition and keep the knob pressed for a few seconds. Howe...

Page 14 - It allows to choose between th; Use of the selector and symbols; How to use the oven; Slide the food onto the spit rod between the two forks, securing it; To turn the oven light on.

Pilot light Th e light turns on when the selector knob is in any position different from 0. Selector knob It allows to choose between th e di ff ere nt cooking functions. Use of the selector and symbols : Oven light How to use the oven It allows to choose the preferred temperature of cooking.By turn...

Page 16 - INSTRUCTIONS FOR INSTALLING KNOB GUARD

INSTRUCTIONS FOR INSTALLING KNOB GUARD OPEN OVEN DOOR INSTALL KNOB GUARD IN SLOTS OF FRONT FASTEN KNOB GUARD ONTO FRONTBY MOVING IT TO THE RIGHT MAKE SURE THE KNOB GUARD IS ATTACHEDBY PULLING IT OUTWARDS CLOSE OVEN DOOR ATTENTION:During operation the knob guard gets very hot.Use kitchen gloves. 35

Page 18 - and clean it to keep

CLEANING AND MAINTENANCE OF THE OVEN Important: Before performing any maintenance, you must either unplug the oven or disconnect the power supply via the omni -polar switch of the electrical system. Cleaning the oven: Let the oven cool after each use and clean it to keep bur nt on residues from bein...

Page 19 - How to remove the oven door; After this, lift the door up and

How to remove the oven door To make it easier to clean the oven, it is possible to remove the door from the hinges as follows:The hinges A are equipped with 2 mobile U -bolts B.When the U-bolts B are lifted, the hinges are disconnected from their housing. After this, lift the door up and pull it out...

Page 20 - Cleaning the side racks; cks has; Replacing the oven bulb

Cleaning the side racks The side r a cks has to be hooked onto the wall of the oven. Slide the racks and tray provided into the side r a il s . To remove the side racks press on part A as shown . Replacing the oven bulb Disconnect the oven from the electrical power supplyUse a screwdriver to remove ...