Ford VMM- Manuals

Page 2 - Trademark Acknowledgements; Copyright Information

Trademark Acknowledgements Teradyne is a registered trademark of Teradyne, Inc. All other brands and product names are trademarks or registered trademarks of Teradyne, Inc., Teradyne Diagnostic Solutions, Ltd or their respective owners. Ford is a registered trademark of Ford Motor Company. Copyright...

Page 3 - VMM S; AFETY; VMM; VMM HARDWARE MANUFACTURER’S WARRANTY AGREEMENT TERMS

DEFINITIONS, ACRONYMS, AND ABBREVIATIONS ........................................... 1 VMM DESCRIPTION ................................................................................................. 2 SAFETY WARNINGS ....................................................................................

Page 6 - VMM Safety Information; DO observe the safety warnings and cautions in this document.; WARNING - This indicates the presence of a hazard that can; Proper Installation and Use of this Equipment

" # " $ % & + , ( # - VMM Safety Information You should read and understand this safety information before installing, assembling and using the equipment. DO observe the safety warnings and cautions in this document. WARNING - This indicates the presence of a hazard that can cause person...

Page 9 - to this and other connected equipment.; Pollution Degree 2; conductivity caused by condensation must be expected.; Installation Category 2; over-voltages than Installation Category 2.

" # " $ % & 0 WARNING - Do not alter this equipment’s cabling during lightning activity if there is any cabling connecting from the equipment to the outside of the building in which this equipment is installed ie through a pc connector. A defective electrical earth connection to any equi...

Page 12 - location of the LED status indicators on the VMM.

" # " $ % & 3 &$ , ! he VMM unit has four LED status indicators that are visible through LED ID Label. The LED status indicators allow the user to visually observe the operation of the VMM. Refer to Fig A for the location of the LED status indicators on the VMM. * ) T LED 4: (AMBER) ...

Page 13 - Normal Power-up LED Operation; VMM is in ‘warm-up’ mode following storage at temperatures below 0; Software Updates; releases become available.

" # " $ % & Normal Power-up LED Operation The VMM Heart Beat / Under temperature / Over temperature Operating LED (LED1) will be flashed regularly, approximately once per second, when the VMM software is running normally. This LED will flash slowly, approximately once every 2 seconds, (w...

Page 14 - Troubleshooting Table

" # " $ % & - sers should perform the following checks to determine if they can resolve any problems with the VMM unit. If the VMM is still inoperable after performing the checks, contact the Ford Technical Information Support for assistance (see Support Instructions chapter for details)...

Page 23 - THIRD PARTY SOFTWARE. BUYER ASSUMES ALL RISK AS TO THE QUALITY AND; amounts owing by Buyer to Seller hereunder.

" # " $ % & ) Manufacturer's satisfaction are determined to be defective and which are necessary, in Hardware Manufacturer's judgment, to return the equipment to good operating condition. Repairs or replacements qualifying under this Warranty will be performed or made on regular business...

Page 27 - stated warranty period.

" # " $ % & ). cleaning, storage or handling; (E) fire, water, wind, lightning or other natural causes; (F) adverse environmental conditions, including, without limitation, excessive heat, moisture, corrosive elements, or dust or other air contaminants; radio frequency interference; elec...