Ford SK5W7J-19A361-AA- Manuals

Page 2 - TABLE OF CONTENTS

2/42 SK5W7J-19A361-AA © Copyright Ford 2005 2W7Z-16A901-AA Rev Date- 8/29/05 TABLE OF CONTENTS READ ME FIRST ........................................................................................................... 3 KIT CONTENTS .......................................................................

Page 3 - READ ME FIRST; RMST

3/42 SK5W7J-19A361-AA © Copyright Ford 2005 2W7Z-16A901-AA Rev Date- 8/29/05 READ ME FIRST For convenience this document uses short names when referring to a particular system or kit. The list below identifies theshort names used herein: Remote Start System with Deluxe Vehicle Security and Keyless E...

Page 4 - KIT CONTENTS

4/42 SK5W7J-19A361-AA © Copyright Ford 2005 2W7Z-16A901-AA Rev Date- 8/29/05 A E I O B F J P C G K D H L KIT CONTENTS WARNING: / AVERTISSEMENT This vehicle is equipped with a remote controlled engine starter. To reduce the risk of serious Injury or death, switch engine startersystem into service mod...

Page 6 - KIT BILL OF MATERIALS LISTS

6/42 SK5W7J-19A361-AA © Copyright Ford 2005 2W7Z-16A901-AA Rev Date- 8/29/05 2W7Z-19G364-AARemote Start System w/Deluxe Vehicle Security and Keyless Entry Kit(RKE/VSS/RMST) REF DESCRIPTION QTY A PC-32 MODULE ASSEMBLY 1 B RKE/VSS/RMST DNA ASSEMBLY (2W7J-19G367-BA) 1 C 4 BUTTON POWERCODE TRANSMITTER W...

Page 9 - MODULE PREPARATION; In this diagram, the parking light fuse is shown in the; positive; polarity position and the Dome light fuse is; negative

9/42 SK5W7J-19A361-AA © Copyright Ford 2005 2W7Z-16A901-AA Rev Date- 8/29/05 MODULE PREPARATION Place the supplied fuses into the power distributionblock on the control module. Refer to the fuseplacement drawing for the specific vehicle that you areworking on. Fuse placement drawings are located inv...

Page 11 - VEHICLE PREPARATION; Lock the doors using the factory RKE transmitter

11/42 SK5W7J-19A361-AA © Copyright Ford 2005 2W7Z-16A901-AA Rev Date- 8/29/05 VEHICLE PREPARATION All models except LS, T-Bird, Escort, Econoline andSuper-Duty Pick-ups, remove the steering columnshroud to allow access to the PATS transceiver antennaring around the ignition switch lock cylinder. A. ...

Page 12 - DIPOLE ANTENNA MOUNTING; ELECTRONIC MIRROR

12/42 SK5W7J-19A361-AA © Copyright Ford 2005 2W7Z-16A901-AA Rev Date- 8/29/05 DIPOLE ANTENNA MOUNTING 2 1 The optimum operating range for this system isdependant upon proper selection of the mountinglocation for the Dipole antenna. • Never mount the antenna behind (or on) any metalfilm or metal film...

Page 13 - STATUS LED; If necessary, remove the selected trim panel

13/42 SK5W7J-19A361-AA © Copyright Ford 2005 2W7Z-16A901-AA Rev Date- 8/29/05 STATUS LED Identify a suitable mounting location for the status LED.Make sure that there is at least 3/4” clearance behindthe selected mounting location. 1 Drill a 9/32” mounting hole. If necessary, remove the selected tri...

Page 15 - CORRECT

15/42 SK5W7J-19A361-AA © Copyright Ford 2005 2W7Z-16A901-AA Rev Date- 8/29/05 SECURILOCK INTERFACE KITS - 1L2Z-19G365-AB & 1S4Z-19G365-AB (Con’t) Carefully unwrap four (4) inches of the twisted red wireaway from the Securilock PATS antenna loop ( B ). 4 5 6 B A. Use a tie wrap ( Y ) to complete ...

Page 17 - Vehicle wiring harness

17/42 SK5W7J-19A361-AA © Copyright Ford 2005 2W7Z-16A901-AA Rev Date- 8/29/05 SECURILOCK INTERFACE KIT - 1L3Z-19G365-AB Route the loop end of PATS interface antenna ( B ) leadup along steering column to area around transceiverantenna coil. Slip antenna loop ( B ) over PATS transceiver. 2 3 1 A B C B...

Page 18 - SIREN INSTALLATION; BB

18/42 SK5W7J-19A361-AA © Copyright Ford 2005 2W7Z-16A901-AA Rev Date- 8/29/05 Locate a suitable mounting location that away from hotand/or moving vehicle/engine components. SIREN INSTALLATION Mount siren using screws provided (BB). Applyrustproofing compound (Super Seal #F3AZ-19515-SA)to drilled hol...

Page 19 - Ground connection must be tight and secure.; HOOD TILT SWITCH INSTALLATION

19/42 SK5W7J-19A361-AA © Copyright Ford 2005 2W7Z-16A901-AA Rev Date- 8/29/05 2x Locate an easy to access area near the drivers sidehood hinge. Mount the hood safety switch using the supplied sheetmetal screws (BB) so that the switch will be biaseddownward when the hood is closed. Route the wirecare...

Page 20 - MOUNTING THE CONTROL MODULE

20/42 SK5W7J-19A361-AA © Copyright Ford 2005 2W7Z-16A901-AA Rev Date- 8/29/05 MOUNTING THE CONTROL MODULE 1 3 To Securilockmodule Trim and tape off WHITE RF Antenna A. Using the supplied long tie wraps (X), mount thecontrol module to underdash wiring harnesses and/or dash mounting brackets. Module m...

Page 21 - SYSTEM WIRING CONNECTIONS; NOTE: The system will not function properly if not programmed.; WARNING LABEL INSTALLATION

21/42 SK5W7J-19A361-AA © Copyright Ford 2005 2W7Z-16A901-AA Rev Date- 8/29/05 SYSTEM WIRING CONNECTIONS 1 A. Finish routing the systems wiring harnesses to their destination points and secure all system wiring using the supplied tiewraps (Y). B. Make the wiring connections as shown. Vehicle specific...

Page 22 - Transmitter programming:; System Programming Instructions

22/42 SK5W7J-19A361-AA © Copyright Ford 2005 2W7Z-16A901-AA Rev Date- 8/29/05 Transmitter programming: A. Open the driver’s door (press and hold in brake pedal on Remote Start only system); NOTE: On vehicles with negative polarity door ajar switch input circuits (Refer to the vehicle specific progra...

Page 23 - To advance to the next option bank:; CONTINUED; Shock sensor setting (not applicable to RKE or RKE/RMST systems); Make sure that the drivers window is rolled down.

23/42 SK5W7J-19A361-AA © Copyright Ford 2005 2W7Z-16A901-AA Rev Date- 8/29/05 To change the setting of an option (VSS system): A. Press the door trim “Lock” switch to advance to the desired option (refer to the programming charts on the followingpages for the specific system that you are programming...

Page 24 - System Programming Instructions - Remote Start Systems

24/42 SK5W7J-19A361-AA © Copyright Ford 2005 2W7Z-16A901-AA Rev Date- 8/29/05 Securilock (PATS) Interface Programming and Remote Start Operation Test (two programmed PATS ignition keys are required for this step) NOTE: This step does not apply to Econoline, SuperDuty Pick-ups and Escort A . Sitting ...

Page 26 - SECURILOCK INTERFACE AND RELAY APPLICATION CHART; Driver Door

26/42 SK5W7J-19A361-AA © Copyright Ford 2005 2W7Z-16A901-AA Rev Date- 8/29/05 SECURILOCK INTERFACE AND RELAY APPLICATION CHART Note: Application information is also located in thevehicle specific wiring section Model Year / Model Relay Requirements 2002 Securilock Interface Kit Headlight Rear Defros...

Page 29 - Factory setting

29/42 SK5W7J-19A361-AA © Copyright Ford 2005 2W7Z-16A901-AA Rev Date- 8/29/05 Option Bank 1 – 4 chirps 1 – Lite-touch adjustment 2 – Full shock adjustment 3 – Optional alarm disable Disables security functionality. ........................................................................................

Page 33 - RMST OPTION CHART; Option Bank 1 – 4 chirps

33/42 SK5W7J-19A361-AA © Copyright Ford 2005 2W7Z-16A901-AA Rev Date- 8/29/05 RMST OPTION CHART Factory setting Factory setting Option Bank 1 – 4 chirps 1 – Selectable chirps Enables arming/disarming confirmation chirps (uses horn). ......................................................................

Page 34 - Deluxe RKE/VSS OPTION CHART

34/42 SK5W7J-19A361-AA © Copyright Ford 2005 2W7Z-16A901-AA Rev Date- 8/29/05 Deluxe RKE/VSS OPTION CHART Factory setting Factory setting Factory setting Option Bank 1 – 4 chirps 1 – Lite-touch adjustment2 – Full shock adjustment3 – Optional alarm disable Disables security functionality. ..............

Page 36 - RKE OPTION CHART

36/42 SK5W7J-19A361-AA © Copyright Ford 2005 2W7Z-16A901-AA Rev Date- 8/29/05 RKE OPTION CHART Factory setting Factory setting Factory setting Option Bank 1 – 4 chirps 1 – Lite-touch adjustment 2 – Full shock adjustment 3 – Optional alarm disable Disables security functionality. .......................

Page 38 - WIRING HARNESS LEGEND

38/42 SK5W7J-19A361-AA © Copyright Ford 2005 2W7Z-16A901-AA Rev Date- 8/29/05 5 1 2 3 4 6 7 8 9 10 11 12 13 14 15 16 9 10 11 12 1 2 3 4 5 6 7 8 13 14 15 16 17 18 19 20 21 22 23 24 2 3 5 1 4 6 7 8 9 10 WIRE END VIEWS A MAIN HARNESS B CAR START B EXTENDED FUNCTION WIRING HARNESS LEGEND Main Harness (2...

Page 39 - Observe reading from meter.; Positive; : When testing a Negative polarity circuit,

39/42 SK5W7J-19A361-AA © Copyright Ford 2005 2W7Z-16A901-AA Rev Date- 8/29/05 Circuit Testing - Identifying Circuit Polarity 1 DC Volts Digital Volt Meter (DVM) set to “DC Volts”. Negative lead (Black) connected to a chassis ground. Positive lead (Red) connected to circuit under test. Observe readin...

Page 40 - Inline wire splice procedure; Wire Connection Procedures; RESULT FROM THE MOISTURE ON THE JOINT

40/42 SK5W7J-19A361-AA © Copyright Ford 2005 2W7Z-16A901-AA Rev Date- 8/29/05 1 Inline wire splice procedure Wire Connection Procedures Wire From Powercode Harness Cut Target Wire In Vehicle Heat Shrint Tubing Wih Hot Melt Wax NOTE: TO INSURE PROPER INSTALLATION, USE THE FOLLOWING GUIDELINES: APPLY ...

Page 41 - Ended Wire Splice Procedure

41/42 SK5W7J-19A361-AA © Copyright Ford 2005 2W7Z-16A901-AA Rev Date- 8/29/05 2 Ended Wire Splice Procedure Wire Connection Procedures NOTE: TO INSURE PROPER INSTALLATION, USE THE FOLLOWING GUIDELINES: APPLY FLOCK TAPE TO SHARP OR JAGGED AREAS DURING INSTALLATION OF WIRE HARNESS APPLY FLOCK TAPE TO ...

Page 42 - VEHICLE SPECIFIC WIRING DIAGRAMS

42/42 SK5W7J-19A361-AA © Copyright Ford 2005 2W7Z-16A901-AA Rev Date- 8/29/05 Color Function A-5 BLACK Ground A-20 GREEN/VIOLET Door Ajar Switch Input A-3 BLACK/WHITE Dome Light Output A-2 BLUE Door Lock Output A-14 GREEN Door Unlock Output A-12 LT.GREEN Unlock Switch Sense Input A-11 WHITE/BLUE Arm...