Ford 2002 Crown Victoria- Manuals

Page 2 - Severe service conditions

This brochure is intended to aid the operators of police or fleet vehicles(used in severe duty, high mileage operations) in understanding therequired maintenance services for such vehicles. It covers maintenanceservices for vehicles equipped with Heavy Duty packages. However, othervehicles operated ...

Page 3 - Maintenance recommendations

Police and fleet vehicles are manufactured with heavy-duty parts that aredesigned specifically for the varying demands and unique requirementsunder which they are operated. Components that are part of the optionpackages are listed below and on the following pages with a brief outlineof their major f...

Page 4 - mode should only be used in situations noted in the “Owner Guide.”; ELECTRICAL; Severe duty equipment

POWERTRAIN OVERSPEED PROTECTION The powertrain control module (PCM) includes logic to electronicallyprevent powertrain overspeed in any transmission selector position. TRANSMISSION The police vehicle has a unique high-performance powertrain includingtransmission and an aluminum driveshaft, which is ...

Page 6 - Aftermarket equipment installation

alarms) that are equipped with radio transmitters. If you install thisequipment in your vehicle, you should comply with those rules and aqualified technician should install the equipment. Ford Motor Companyvehicles are in compliance with FCC regulations (CFR 47 Part 15) andSAE J551d for radiated ele...

Page 7 - AIR BAGS; instruction could result in personal injury.

AIR BAGS Dual driver/passenger air bags affect the way police equipment can bemounted in police vehicles. Any surfaces that could come into contact with an air bag, once it hasdeployed, must not damage the air bag or alter its deployment path. Once the air bag has fully deployed, any peripheral equi...

Page 8 - Figure 1

All air bag and equipment mounting zone dimensions are approximatedue to different air bag deployment characteristics. Figure 1 1. 325 mm (12.5 inches) from center of air bag door 2. 375 mm (15 inches) from center of air bag door 3. 700 mm (27.5 inches) No objects should be placed between the air ba...

Page 9 - Figure 2

Figure 2 1. 650 mm (25.5 inches). Cross section through center of vehicle(passenger side shown) 1 Severe duty equipment 9

Page 10 - Figure 3

Figure 3 1. 580 mm (23 inches). Front passenger compartment 1 Severe duty equipment 10

Page 11 - Figure 4; Equipment must not interfere; The air bag door must be kept clear for deployment of air bag

Figure 4 1. Area on top of instrument panel. Equipment must not interfere with driver visibility. 2. The air bag door must be kept clear for deployment of air bag 3. Area in front of center console from bottom of ashtray to top ofinstrument panel (see Figure 2 for dimensions) 4. 279 mm (11 inches) w...

Page 13 - Figure 6; Area on tunnel between seats

Figure 6 1. Area on top of instrument panel. Equipment must not interfere with driver visibility. 2. Area on tunnel between seats 3. 229 mm (9 inches) 4. 305 mm (12 inches) 1 2 3 4 Severe duty equipment 13

Page 14 - IMPORTANT AIR BAG DO’S AND DON’TS; reduce the risk of passengers being thrown from the vehicle.

IMPORTANT AIR BAG DO’S AND DON’TS Do not attempt to tamper with, disconnect or deactivate the air bagsystem. Tampering with an air bag system could cause the bag to inflate orbecome inoperative. The air bag system should not be disconnected ordeactivated. Do not mount or place any objects in the dep...