Page 2 - RCA INPUT, BOTH LOW LEVEL AND HIGH LEVEL; The amplifier; LEVEL; control is adjusted to 8V.; SETTING LEVEL; Follow their gain overlap instructions.; NOT; FDP 4.600 V2 CONFIGURATION EXAMPLES; CHANNEL STEREO NON-BRIDGED
2 RCA INPUT, BOTH LOW LEVEL AND HIGH LEVEL • The amplifier LEVEL control has sufficient adjustment range for both low level and high level input into the RCA jacks. A factory source radio that does not have RCA output, using the wires that are connected to the speakers, can be directly connected to ...
Page 3 - IF YOU ARE USING TWO SUBWOOFERS; CHANNEL WITH BRIDGED SUBWOOFER; DO NOT use a 2 Ohm Subwoofer.
3 IF YOU ARE USING TWO SUBWOOFERS (SEE GRAPHIC B2) • Put your woofer/tweeters on channel 1+2. Set 1+2 switch to HP. Adjust 1+2 HP frequency to 70 Hz. • Subwoofers on channel 3+4. Set 3+4 switch to LP/BP. Set 3+4 switch to LP. Adjust 3+4 LP frequency to 70 Hz. Set the switch to MONO. Plug in the remo...
Page 4 - BIAMP A WOOFER AND TWEETER; Connect the source deck front channel wires into inputs 3+4.
4 RADIO LP LP/BP 70Hz 3+4 70Hz HP MONO B3 (3 CHANNEL WITH BRIDGED SUBWOOFER) + – SUBWOOFER REMOTE SUB CONTROL XOVER XOVER BIAMP A WOOFER AND TWEETER (SEE GRAPHIC B4) • Connect the source deck front channel wires into inputs 3+4. • Set ROUTE switch to 3+4. • Set the switch to STEREO. • Connect your t...
Page 5 - CHANNEL BRIDGED; DO NOT USE a 2 ohm Speaker; adjustments, should be identical on both Channels.
5 2 CHANNEL BRIDGED (SEE GRAPHIC B5) • DO NOT USE a 2 ohm Speaker • Connect Front Left Channel from Source unit with Y adapter to input 1+2 Connect Front Right Channel from Source unit with Y adapter to input 3+4 Set ROUTE switch to 1+2, and STEREO/MONO Switch to Stereo • Connect Left Speaker to (1+...
Page 6 - Remove the end panel by the power terminals
6 POWER FUSES & BALANCED/UNBALANCED SWITCH FDP 4.600 V2 POWER FUSES > TO USE: Remove the end panel by the power terminals 2 x 25 amp ATC fuse FDP 4.600 V2 BALANCED/UNBALANCED SWITCH > TO USE: Remove the end panel by the RCA jacks.The standard switch position is input ground “ON”.Flip the s...
Page 7 - TROUBLESHOOTING; > FOCAL SIGN DOES NOT LIGHT
7 TROUBLESHOOTING > FOCAL SIGN DOES NOT LIGHT 1. Measure the voltage at the amplifier power terminal. It should be between 12 and 15 volts. 2. Measure the voltage at the amplifier REM terminal. It should be between 12 and 15 volts. 3. If you are using BTL high level for automatic turn on, try con...
Page 8 - > SUBWOOFER REMOTE VOLUME CONTROL LED LIGHT; WARRANTY INFORMATION; from and authorized retailer; . This time period is extended to; no alterations; are; abuse, or modification; TECHNICAL SPECIFICATIONS
8 > SUBWOOFER REMOTE VOLUME CONTROL LED LIGHT 1. While playing music the LED light should be Green. Occasional red LED light flash indicates that the amplifier has reached maximum loudness. 2. If the red LED light flashes with the beat of the music, TURN DOWN THE VOLUME before you damage your spe...
