EverFocus EZ180 - Manuals - manualsarea.com

Page 2 - Notice

Notice This manual is presented to the users of EZ180 by EverFocus Electronics Corp. With years of engineering researches, EverFocus has spared no effort to provide the high quality products to the worldwide users. For the policy of continual product improvement, EverFocus reserves the right to make...

Page 3 - Table of Contents

Table of Contents Safety Warning …………………………………………1 Introduction……………………………………………..2 Specification…………………………………………….3 Major Parts Names…..…………………………….…..4 Installation Instructions………………………….….…5 Settings………………………………………………….7

Page 4 - Safety Warning

1. Handle the camera with care. Be careful when handling the camera, do not drop it or subject it to strong shock or vibration to prevent any damages to it. Do not disassemble it or place it on an unstable base. 2. Do not install the camera near electric or magnetic fields. Installed the camera away...

Page 5 - Introduction

The EZ180 series offers great performance in 1/3”image format B/W CCD camera. The EZ180 is ideal for outdoor applications such as parking lots, gas stations or shopping malls. The sophisticated circuit design provides a heater that turns on at 10 ℃ for cold weather. The EZ180 will provide protection...

Page 6 - Specification

EZ180 Pickup Device 1/3” SONY B/W CCD Picture Elements 768 x 494 (EIA) 752 x 582 (CCIR) Horizontal Resolution 560 TV lines Video Output BNC 1.0Vp-p, 75 ohm Lens Focal Length Vari-focal lens f=3.5~8mm Vari-focal lens f=9~22mm *Lens models and availability vary in different regions Sensitivity 0.1 lux...

Page 7 - Major Parts Names and Their Functions

Mounting Base Swivel Screw Assembly Screw Sun Shield Cover Back Fixing Plate Mounting Base Swivel Screw Assembly Screw Sun Shield Cover Back Fixing Plate Major Parts Names and Their Functions Fixing Screw Front Fixing Plate Fixing Screw Front Fixing Plate Mounting Bracket O-ring Seal Heater Lens Foc...

Page 8 - Installation Instructions

1. Using the supplied screws, mount the bracket base on the desired location. 2. Connect the BNC connector of the camera to a monitor or other video device through a 75 ohm type coaxial cable with BNC female connector at cable extension. 3. Connect the 24VAC or 12VDC regulated power source of the ca...

Page 10 - Settings

The camera is set up at factory and normally requires no adjustments. Sometimes, however, adjustments may be necessary. Please refer to the following description for the function details. The IRIS ALC and IRIS Level adjustments are located on the side circuit board, use a screwdriver to adjust if ...

Page 11 - Control Switches

The 4 control switches are also located on the side circuit board, the switches in orders are for Flickerless, Back Light Comp, Auto Gain Control and Line Lock. FL(Flickerless) Normal/On When picture flicker fiercely, turn FL on, then the camera will stabilize the speed of electronic shutter at 1/...