EverFocus EN-7515C - Manuals

Page 3 - Important Safety Instruction

INSTRUCTION MANUAL …………………………………………………………………………… 1 Important Safety Instruction 1. Read these instructions. 2. Keep these Instructions. 3. Heed all warnings. 4. Follow all instructions. 5. Do not use this apparatus near water. 6. Clean only with dry cloth. 7. Do not block any ventilation openings. I...

Page 4 - with liquids, such as vases, shall be placed no the apparatus.; magnitude to constitute a risk of electric shock to persons.

14. Refer all servicing to qualified service personnel. Servicing is required when the apparatus has been damaged in any way, such as power-supply cord or plug is damaged, liquid has been spilled or objects have fallen into the apparatus the apparatus has been exposed to rain or moisture does not op...

Page 5 - CAUTION; located/installed near the equipment and is easily accessible.; ATTENTIONN; située ou installée à proximité du matériel et être facile d`accès; NEVER REMOVE THE BACK COVER

maintenance(servicing) instructions in the literature accompanying the appliance. INSTRUCTION MANUAL …………………………………………………………………………… 3 CAUTION The power supply cord is used as the main disconnect device, ensure that the socket-outlet is located/installed near the equipment and is easily accessible. AT...

Page 6 - NOTE

Do not cover the unit or place anything on the top of unit. ▶ AVOID HEAT Avoid placing the unit in direct sunshine or near a heating appliance. ▶ TO ELIMINATE EYE FATIGUE Do not use the unit against a bright back ground and where sunlight or other light sources will shine directly on the monitor. ▶ ...

Page 7 - DOC COMPLIANCE NOTICE; A. SIDE PANEL CONTROL

the grantee or manufacturer could void the user’s authority to operate such equipment. ▶ DOC COMPLIANCE NOTICE This digital apparatus does not exceed the Class B limits for radio noise emissions from digital apparatus set out in the radio interference regulation of Canadian Department of communicati...

Page 8 - Select picture mode.

9. S-VIDEO (Y/C) IN Y/C separated signal input 10. S-VIDEO (Y/C) OUT Y/C separated signal looping output 11. PC STEREO IN 6 …………………………………………………………………………… INSTRUCTION MANUAL B. REMOTE CONTROLLER 1. POWER( ) Turns the power ON or OFF. There will be a few seconds delay before the display appears. 2. SO...

Page 9 - Input mode information Display

Mute the sound. 11. MENU Activates and exits the On Screen Display. 12. EXIT Exit the On Screen Display. 13. VOL( ) Increases or decreases the level of audio volume. 14. UP/DOWN Move to OSD menu. 15. ENTER Accepts your selection or displays the current mode. 16. INFO Input mode information Display ....

Page 10 - OSD MENU DESCRIPTION; Press the MENU button and then up(

Activates and exits the On Screen Display. 7. POWER ON/OFF( ) Turns the power ON or OFF. There will be a few seconds delay before the display appears. 8. IR Sensor Remote controller sensor. 9. POWER LED The power LED(next to the power switch) lights with green when the power is turned ON. The power ...

Page 15 - Press

Press the ( ▶) or ENTER button and then up( ▲ )/down( ▼ ) button to select the desired Mute. Press the MENU button to save. INSTRUCTION MANUAL …………………………………………………………………………… 13 4. Volume Press the up( ▲ ) / down( ▼ ) button to select the Volume. Press (◀) / right( ▶ ) button to adjust Volume. Press t...

Page 17 - Press ENTER button to select the reset; Reset; : Select to reset all setting to the factory default values.

C. SETUP MENU Press the MENU button and then up( ▲ ) / down( ▼ ) button to select the Setup menu. Press the right( ▶ ) or ENTER button . INSTRUCTION MANUAL …………………………………………………………………………… 15 1.Reset Press ENTER button to select the reset Reset : Select to reset all setting to the factory default value...

Page 19 - Press the MENU button to save.

Press the up( ▲ ) / down( ▼ ) button to select language. Press the MENU button to save. INSTRUCTION MANUAL …………………………………………………………………………… 17 3. OSD Tone Press the up( ▲ ) / down( ▼ ) button to select the OSD tone menu. Press the right( ▶ ) or ENTER button

Page 22 - Wall-mount Installation; The monitor fixing bracket assembled with monitor

Press the up( ▲ ) / down( ▼ ) button select on or off Press the MENU button to save. 20 …………………………………………………………………………… INSTRUCTION MANUAL Using the VESA standard wall mount design and the 100mm hole pattern on the back panel to install the LCD monitor to the wall. Wall-mount Installation 1.The Monito...

Page 23 - PIN ASSIGNMENTS

INSTRUCTION MANUAL …………………………………………………………………………… 21 ▶ PIN ASSIGNMENTS

Page 24 - ACCESSORY; POWER CONSUMPTION; MODE; Remote Control Unit

▶ ACCESSORY 22 …………………………………………………………………………… INSTRUCTION MANUAL This monitor features a power management system to “power down” upon receipt of the VESA DPMS(The display power management signaling) from a VESA DPMS video card. The VESA DPMS-compliant video card performs this signaling system through...

Page 26 - POWER SUPPLY; Technical specifications are subject to change without notice.

PC Stereo in 304.1 mm x 228.1 mm PACKING DIMENSIONS (W x D x H) 440mm X 160mm X 390mm (17.3”x 6.3“x 15.4’) WEIGHT Net Weight : 4.8Kg (10.6Ibs) Gross Weight : 6.26Kg (10.6Ibs) POWER SUPPLY (Electrical Ratings) DC 12V/ 3A (AC110~220V,50~60HZ for Auto switching) ▶▶ NOTE : Technical specifications are s...

Page 27 - WEEE Symbols

WEEE Symbols Correct Disposal of This Product(Waste Electrical &Electronic Equipment) (Applicable in the European Union and other European countries with separate collection systems) This marking shown on the product or its literature,indicatesthat it should not be disposed with other household ...