Page 2 - power source ratings.; PREFACE
1 6. Cleaning Do not touch the surface of sensor by hand directly. Use a soft cloth to remove the dirt from the camera body. Use lens tissue or a cotton swab and ethanol to clean the sensor and the camera lens. 7. Do not operate the camera beyond the specified temperature, humidity or power source r...
Page 3 - SPECIFICATIONS
2 SPECIFICATIONS Pickup Device 1/3'' SONY Super HAD CCD Video Format NTSC or PAL Scanning System NTSC: 525 TV lines, 60 fields/sec PAL: 625 TV lines, 50 fields/sec Picture Elements 768 x 494(NTSC) ; 752 x 582(PAL) Horizontal Resolution 560TVL Sensitivity 0.5Lux/F=1.2 S/N Ratio Over 48dB(AGC off) Ele...
Page 6 - LENS ADJUSTMENT; Zoom and focus adjustments; as necessary to obtain the
5 LENS ADJUSTMENT Zoom and focus adjustments After the camera was installed, the zoom and focus of the lens must be adjusted. 1. Loosen the zoom ring knob, and then turn the ring towards <W > or <T > as necessary to obtain the desired view range. W side (Zoom out) The viewing range will ...
Page 7 - ADJUSTMENTS; To select light metering method:
6 ADJUSTMENTS (1) IRIS ALC Adjustment To select light metering method: Turn the IRIS ALC Adjustment VR counterclockwise for Average Metering. Turn the IRIS ALC Adjustment VR clockwise for Peak Metering. (2) IRIS Level Adjustment Brightness Level can be adjusted from the IRIS level VR while using...
Page 8 - Flickerless; The default setting is OFF.; Auto Gain Control Adjustment; The sensitivity increases automatically when the light is low.
7 (3) Flickerless When picture flicker fiercely, turn FL on, then the camera will stabilize the speed of electronic shutter at 1/100(NTSC) or 1/120(PAL) automatically, and reduce the flicker immediately. The default setting is OFF. (4) Auto Gain Control Adjustment AGC ON: The sensitivity increases a...
Page 9 - INSTALLATION; Remove the plastic dome cover.
8 INSTALLATION 1. Remove the plastic dome cover. 2. Lossen the two screws of the supporting bracket to remove the camera body. 3. Use four screws to fix the camera base on the ceiling. 4. Put the camera body back to the supporting bracket, then tighten the two screws to fix the camera. 5. Connect th...
Page 10 - EverFocus Electronics Corp.; Haidian District, Beijing China
9 EverFocus Electronics Corp. Head Office: 12F, No.79 Sec. 1 Shin-Tai Wu Road, Hsi-Chih, Taipei, Taiwan TEL: +886-2-26982334 FAX: +886-2-26982380 www.everfocus.com.tw USA L.A. Office: 1801 Highland Ave. Unit A Duarte, CA 91010, U.S.A. TEL: +1-626-844-8888 FAX: +1-626-844-8838 www.everfocus.com USA N...