Page 2 - AT A GLANCE; Front View
01 AT A GLANCE Front View ⑥ ⑤ ⑦ ⑧ ① ② ③ ④ ⑨ ① LED Light ② Motion Sensor ③ Primary Camera Lens ④ Microphone ⑤ Ambient Light Sensor ⑥ LED Ring / Doorbell Button ⑦ LED Light ⑧ Secondary Camera Lens ⑨ Speaker
Page 3 - Rear View; HOW THE SYSTEM WORKS; Works Independently
03 02 Rear View ⑤ ① ② ③ ④ SYNC ① Detaching Mechanism ② Power Terminals for Existing Doorbell Wires (Optional) ③ SYNC Button Press to turn on the doorbell.Press and hold for 2 seconds until you hear a beep to set up the doorbell. (Optional)Press quickly 5 times within 3 seconds to turn off the doorbe...
Page 4 - SETTING UP THE SYSTEM
05 04 CHARGING THE BATTERY PACK 1. Remove the pre-installed battery pack from the battery compartment. 0 ～ 100% 2. Fully charge the rechargeable battery pack before installation. 3. Place the battery pack into the battery compartment. 0 ～ 100% SETTING UP THE SYSTEM 1. Download and install the eufy S...
Page 5 - Option 1: Battery Powered; DOORBELL MOUNTING; Choose a Location
07 06 DETERMING THE POWER OPTION Option 1: Battery Powered If you don't have existing doorbell wiring at your front door, use the included battery. You are free to determine the location of the doorbell, and the mounting will be easy and quick. When the battery is low, you will need to recharge it. ...
Page 6 - Mount the Bracket
09 08 Mount the Bracket Use the provided screws to secure the mounting bracket on the wall. Without 15º Mounting Wedge Mounting Bracket Mounting Bracket Wooden Wall Mounting Bracket Mounting Bracket Mounting Wedge Mounting Wedge With 15° Mounting Wedge Hard Wall Without 15º Mounting Wedge With 15° M...
Page 7 - Check the Doorbell Wires
11 10 Install the Doorbell Align the doorbell with the bottom of the mounting bracket, then press the top of the doorbell into place until it clicks. Recharging the Battery 1. Insert the detaching pin into the pin hole on the top of the doorbell, then lift the top for removal. 2. Repeat steps in ...
Page 10 - Connect the Wires to the Doorbell; Install the Doorbell
17 16 Connect the Wires to the Doorbell Connect the wires to the terminals on the back of the doorbell, then tighten the terminal screws. Wire can be connected to any terminal. SYNC SYNC To prevent short-circuiting, make sure the wires are not touching each other after connecting them to the termina...
Page 11 - SAFETY; NOTICE
19 18 SAFETY • The suitable temperature for devices and accessories is -20°C to 50°C (Charging temperature is 0°C to 40°C). • Unless specifically indicated that it is safe to do so in the user guide or instruction manual, do not use this device in an environment that exceeds the recommended low or h...
Page 12 - CUSTOMER SERVICE
21 20 Cet appareil numérique de la classe B est conforme à la norme NMB-003 du Canada. IC RF Statement When using the product, maintain a distance of 20cm from the body to ensure compliance with RF exposure requirements. Lors de l'utilisation du produit, maintenez une distance de 20 cm du corps afin...
