Enviro Omega - Manuals - manualsarea.com

Page 2 - Table of Contents

Table of Contents 2 Introduction........................................................................................3 Rating Label Location................................................................3Fuel Quality...............................................................................3...

Page 3 - Introduction

3 Introduction * This manual is designed for the home owner in conjunction with the technical manual. * R ATING L ABEL L OCATION : The rating label is located on the inside of the hopper. F UEL Q UALITY : Fuel quality is important, please read the following: Your Enviro pellet stove has been designe...

Page 4 - Safety Warnings & Recommendations; FIRE EXTINGUISHER AND SMOKE DETECTION:

4 Safety Warnings & Recommendations Please read this entire Owner’s Manual before installing or operating your Enviro Pellet Stove. Failure to follow these instructions may result in property damage, bodily injury or even death. Any unauthorized modification of the appliance or use of replacemen...

Page 5 - ELECTRICAL: The use of a surge protected power bar is recommended.; KEEP ASH PAN FREE OF RAW FUEL.; strongly; must; SAVE THIS INSTRUCTION MANUAL FOR FUTURE REFERENCE.

5 Safety Warnings & Recommendations ELECTRICAL: The use of a surge protected power bar is recommended. The unit must be grounded. The grounded electrical cord should be connected to a standard 110-120 volts (4.2 Amps), 60 hertz electrical outlet and also must be accessible. If this power cord sh...

Page 6 - Operating Instructions

21 13 / 16 " (554mm) 15 15 / 16 " (404mm) 22 1 / 16 " (561mm) 41 15 / 16 " (1065mm) 42 1 / 2 " (1080mm) 23 13 / 16 " (605mm) 26 1 / 8 " (664mm) 26 3 / 8 " (669mm) 24 3 / 16 " (615mm) Operating Instructions D IMENSIONS & S PECIFICATIONS : Figure 1: Dimensions o...

Page 7 - ALSO FIND THE REASONS WHY THE

7 Operating Instructions C ONTROL B OARD F UNCTIONS : 1. ON/OFF BUTTON: Used to turn the unit ON and OFF manually. 2. FUEL TYPE BUTTON: Used to switch between fuel type modes; Pellet (for all qualities of wood FEED TRIM ON/OFF FUEL TYPE HEAT LEVEL AUTO/OFF HIGH/LOW MANUAL PELLET C-11256 MULTIFUEL FE...

Page 8 - OPERATION

PRE-BURN CHECK : The burn pot liner holes must be clear and the liner installed properly against the ignitor tube and locked in place. Check the hopper for enough pellets to start the unit. Note: Fuel Type can only be changed when the unit is cold. The thermostat mode can be changed during normal op...

Page 9 - to smoke escaping from the stove.; THE SLIDER / DAMPER MUST BE SET AT TIME OF INSTALLATION.

9 the fire. • A tall, lazy flame with dark orange tips requires more air – Open slider (pull out) slightly. • A short, brisk flame, like a blowtorch, has too much air – Close slider (push in) slightly. • If the flame is in the middle of these two characteristics with a bright yellow/orange, active f...

Page 10 - Routine Cleaning and Maintenance; Check the Burn Pot Liner DAILY

Routine Cleaning and Maintenance The following list of components should be inspected and maintained routinely to ensure that the appliance is operating at its optimum and giving you excellent heat value. The appliance, flue gas connector and the chimney flue require regular cleaning. Check them for...

Page 11 - HEAT EXCHANGER TUBES

Figure 9: Omega Burn Heat Exchanger Cleaning. 11 Routine Cleaning and Maintenance HEAT EXCHANGER TUBES (Weekly) There are two (2) sets of exchanger tube scrapers; the handles are located under the top grill (trivet). Lift the grill and move the handles all the way up and down a few times (ONLY WHEN ...

Page 12 - EXHAUST PASSAGES; CLEANING PAINTED SURFACES

Routine Cleaning and Maintenance EXHAUST PASSAGES (Biannually) 1. Open the firebox door by lifting the handle. 2. Remove the burn pot assembly and clean all the parts. 3. Lubricate all screws with penetrating oil. 4. Using a 3⁄8” socket, remove the two (2) bolts that hold the firebox liner in place....

Page 13 - Warranty; Limited Lifetime Warranty:; exclusions apply to this warranty.; Here is how our Warranty works; Sign and verify that work and information are correct.

13 Warranty Sherwood Industries Ltd. is the manufacturer of the Enviro line of heating products. At Sherwood Industries, our commitment to the highest level of quality and customer service is the most important thing we do. Each Enviro stove is built on a tradition of using only the finest materials...

Page 14 - Exclusions and Limitations:

Warranty Exclusions and Limitations: 1. This Warranty does not cover tarnish, discoloration or wear on the plating or paint. 2. This Warranty excludes wear and tear or breakage caused by cleaning, moving or service on log set. 3. A qualified installer must install this stove or fireplace. This Limit...

Page 16 - Installation Data Sheet

16 NAME OF OWNER: _________________________________________ ADDRESS: _________________________________________ _________________________________________ _________________________________________ PHONE:___________________________________ NAME OF DEALER: _________________________________________ ADDRE...