Enviro Indoor Gas Fireplace - Manuals

Specifications R ATING L ABEL L OCATION : The rating label is located under the control panel and is attached to a rectangular metal sheet that is chained to the fireplace. D IMENSIONS : Surround Style Distance Direct Vent B-Vent Arched Surround From Flue To Surround 14 11 / 16 ” (376 mm) 14 9 / 16 ...

7 WARNING: IF YOU DO NOT FOLLOW THESE INSTRUCTIONS EXACTLY A FIRE OR EXPLOSION MAY RESULT, CAUSING PROPERTY DAMAGE, PERSONAL INJURY OF LOSS OF LIFE. P ILOT L IGHTING I NSTRUCTIONS : Figure 3. Lighting instruction label. 1. STOP! Read the safety information above on this label. 2. Turn off all electr...

8 Operating Instructions For Your Safety, Read Safety Precautions And Lighting Instructions Before Operating T URN O FF U NIT : Flip switch to OFF to turn off burners only.If the fireplace is to be turned off for the season, or for servicing, turn the gas shut off valve to OFF. If the unit is going ...

9 Maintenance And Service Warning: Failure to position the parts in accordance with this manual, or failure to use only parts specifically approved with this appliance, may result in property damage or personal injury.At least once a year, run through the following procedures to ensure the system is...

Maintenance And Service QUALIFIED INSTALLERS ONLY G LASS D OOR R EMOVAL : Blower / Fan Gas & Electrical Tray Complete Burner Top with Grate Attached Log Support Tray Figure 10: Removing burner and gas tray. 1. Turn the unit off and allow the unit to cool completely. 2. Remove the fascia or louve...

Maintenance And Service F UEL C ONVERSION : TO BE INSTALLED BY A QUALIFIED SERVICE AGENCY ONLY Please read and understand these instructions before installing. Figure 11: Removing valve cap. a) Remove the main burner orifice with a 1⁄2 inch deep socket.b) Put a bead of pipe-thread sealant or approve...

Initial Installation WARNING: Operation of this heater when not connected to a properly installed and maintained venting system can result in carbon monoxide (CO) poisoning and possible death. C LEARANCES TO C OMBUSTIBLES : Maintain sufficient clearances for operation, service and maintenance. • A c...

14 Initial Installation Check draft with a match or smoke in a 1⁄4" (6 mm) tube located here. M INIMUM F IREPLACE S IZE : Description of Fireplace Dimension Direct Vent B-Vent Width At Back 23 1⁄4” (591 mm) 23 1⁄4” (591 mm) At Front 35” (889 mm) 35” (889 mm) Height With Surround Only 23 3⁄4” (60...

16 Install sealed throat connector or flashing to prevent leakage of room air up through chimney. DV Only: Before installing vent liners, mark each liner on both ends to designate which is the intake and the exhaust. Measure the height of the chimney beforehand and purchase the appropriate kit. Neve...

17 Initial Installation QUALIFIED INSTALLERS ONLY E LECTRICAL R EQUIREMENTS : Fan Control Black White White Black Green/Yellow Green Black Power Cord 120V AC FAN 120 o F (49 o C) Temperature Sensor CNT2 CNT3 CNT1 CNT4 The fan is thermostatically controlled and it will not operate if the appliance is...

Initial Installation QUALIFIED INSTALLERS ONLY G AS L INE C ONNECTION : Warning: Only persons licensed to work with gas piping may make the necessary gas connections to this appliance. Gas Line Connection: •This fireplace is equipped with a certified flexible pipe located on the right side of the un...

Secondary Installation Figure 29: Filler panel with trim installation. I NSTALLATION OF S URROUND P ANEL : The Sienna must have one of the panels installed around the unit; the unit panel, the filler panel, or the filler panel with trim. If you have trim for your filler panel, the trim must be insta...

21 Secondary Installation L OG S ET AND E MBER I NSTALLATION : NOTE: The logs are fragile and should be handled gently. The placement of the logs is not arbitrary. If they are positioned incorrectly, the flames can be “pinched” and will not burn correctly. The burner, and a few of the logs come with...

23 Secondary Installation Figure 36. Sienna complete log set-up with embers burning. NOTE: While the glass is still removed, it is recommended that the gas line be purged by lighting the pilot.When lighting the fireplace for the first time since the log set and embers have been installed/replaced, w...

Secondary Installation R EMOVING T HE B RICK P ANEL : The brick panel set is fragile, handle with extreme care. The brick panel set comes pre-installed. The centre and top panel are the only panels that need to be removed if the complete gas and electrical tray assembly must be removed. The side pan...

25 Trouble Shooting Problem Possible Cause Solution The main burner does not ignite when called for. The gas valve may not be on. • Check that the gas control knob is in the “ON” position. Thermostat is not calling for heat. • Adjust the thermostat several degrees above ambient temperature. Problem ...

Parts List- Unit Components Reference Number Part Description Part Number 1 120°F Ceramic Fan Temperature Sensor EC-001 2 300°F (149°C) Manual Reset Spill Switch (Normally Closed) EC-003 3 S.I.T. Nova Valve Convertible 50-1421 4 Thermocouple EC-009 4 Spark Electrode with Ignitor Cable EC-011 4 Therm...

27 Parts Diagram - Components SI EN N A -C om po ne nt s O ct ob er 20 04 �� �� �� �� �� � �� �� �� �� ��

Parts Diagram - Burner SIENNA - Burner October 2004 �� � � � � �� �� � � �� � �� � 28

Parts Diagram - Options SIENNA - Options October 2004 �� �� �� �� �� �� �� 30

31 Warranty Sherwood Industries Ltd. offers a Limited Lifetime Warranty on this gas product. This Limited Lifetime Warranty covers the appliance for a period of seven years from the date of installation. This warranty applies only to the original owner in the original location. Covered under the lif...

Installation Data Sheet The following information must be recorded by the installer for warranty purposes and future reference. NAME OF OWNER: _________________________________________ ADDRESS: _________________________________________ _________________________________________ ______________________...