Enviro EP3 - Manuals - manualsarea.com

Page 2 - Table of Contents

Table of Contents 2 Introduction..............................................................................................................3 Rating Label Location......................................................................................3 Pellet Quality....................................

Page 3 - Introduction; Pellet quality is important, please read the following:; will void the warranty.; ASH; may allow longer intervals between cleaning.

3 Introduction * This manual is designed for the home owner in conjunction with the technical manual. * R ATING L ABEL L OCATION : Freestanding: The rating label is located on the inside of the hopper lid.Fireplace Insert and Built-In Heater: The rating label is located on the hopper cover. P ELLET ...

Page 4 - adjusting the slider damper located on the left side of the stove.; Caution: Do not connect to any air distribution duct or system.; warranty. Check with your dealer for fuel recommendations.; THE USE OF CORDWOOD IS PROHIBITED BY LAW.; damper as needed to ensure proper combustion.

4 I MPORTANT S AFETY D ATA : Please read this entire Owner’s Manual before installing or operating your ENVIRO Pellet Stove. Failure to follow these instructions may result in property damage, bodily injury or even death. Contact your local building or fire official to obtain a permit and any inform...

Page 5 - have thoroughly cooled before disposing of them.; ELECTRICAL: The use of a surge protected power bar is recommended.; The unit must be; Never; the heater while it is in use.; KEEP ASH PAN FREE OF RAW FUEL.; SAVE THIS INSTRUCTION MANUAL FOR FUTURE REFERENCE

5 Introduction ASHES: Disposed ashes should be placed in a metal container with a tight-fitting lid. The closed container of ashes should be on a non-combustible floor on the ground, well away from all combustible materials pending final disposal. The ashes should be retained in the closed container...

Page 6 - Operating Instructions; ALSO FIND; control proportionately to the heat output.

Operating Instructions A UTOMATIC S AFETY F EATURES : Your pellet Stove has the following safety features:A. The stove will shut off when the fire goes out and the exhaust temperature drops below 120°F (49°C). B. The stove has a high temperature safety switch. If the temperature on the hopper reache...

Page 7 - pellets may need a higher setting; blue zone; DO NOT unplug unit while combustion

Operating Instructions Figure 3: Dial-A-Fire control panel. 1. Check and fill hopper with pellets.2. Make sure unit is plugged into a working outlet.3. Switch the power “ON” by pushing the start-up switch once only. 4. Turn knob “B” to the 12 o’clock position. (Lower grade pellets may need a higher ...

Page 9 - PRE-BURN INSTRUCTIONS; : When the thermostat contacts are closed the stove settings are; OPERATION – ON / OFF mode; when the thermostat contacts close again.; DO NOT unplug unit while Combustion fan is operating.

9 Operating Instructions O PERATING Y OUR P ELLET S TOVE - C IRCUIT B OARD : PRE-BURN INSTRUCTIONS : The burn pot liner holes must be clear and the liner installed properly against the ignitor tube for proper operation. Check the hopper for enough pellets to start the unit. DO NOT OPERATE THE UNIT W...

Page 10 - Routine Cleaning and Maintenance

10 Routine Cleaning and Maintenance NOTE: Do not use abrasive cleaners to clean the surface or any part of the stove. The following should be inspected periodically to ensure that the appliance is operating at its optimum and giving you excellent heat value: 2-3 Days / Weekly Bi-Annually or 2 Tons o...

Page 13 - Warranty; WHEN FILING A WARRANTY CLAIM PLEASE COMPLETE THE FOLLOWING

13 Warranty Sherwood Industries Ltd. gives a five year limited warranty on all steel manufactured parts. A one-year warranty is provided on all electrical components. The above limited warranties are extended only to the original purchaser. There is no warranty on the following parts: ● Fiberglass r...

Page 14 - Installation Data Sheet

14 The following information must be recorded by the installer for warranty purposes and future reference. NAME OF OWNER: _________________________________________ ADDRESS: _________________________________________ _________________________________________ _________________________________________ P...