Enviro C-11290 - Manuals

5 Specifications WARNING: Operation of this heater when not connected to a properly installed and maintained venting system can result in carbon monoxide (CO) poisoning and possible death. D imensions : 16 5 / 8 " (42.2cm) 25 ¾" (65.3cm) 25 ¾" (65.4cm) 27" (68.6cm) 25 ¾" (65.3cm)...

6 Operating Instructions For Your Safety, Read Safety Precautions And Lighting Instructions Before Operating WARNING: IF YOU DO NOT FOLLOW THESE INSTRUCTIONS EXACTLY A FIRE OR EXPLOSION MAY RESULT, CAUSING PROPERTY DAMAGE, PERSONAL INJURY OF LOSS OF LIFE. P iLot L ighting i nstRuctions : Figure 2. L...

7 2. Start the pilot by pressing the gas control knob and turning it to PILOT. While holding the gas control knob in, press the piezo ignitor several times until the pilot light starts. Hold the gas control knob in for 30 seconds. Check that the pilot has fully engulfed the thermocouple assembly (se...

8 Operating Instructions For Your Safety, Read Safety Precautions And Lighting Instructions Before Operating R emote contRoLs (o PtionaL ): This fireplace can use an optional remote control or an optional cordless wall thermostat. If either of these are to be used to control the fireplace for the ma...

Electronic ignition module Maintenance And Service R outine m aintenance : At least once a year, run through the following procedures to ensure the system is clean and working properly. Check the burner to see if all the ports are clear and clean. Check the pilot to make sure it is not blocked by an...

Figure 6: Handles for Removing Door. Figure 7: Removing of Door. Maintenance And Service R ePLacing the g Lass : The glass in the fireplace is a high temperature ceramic. If the glass is damaged in any way, a factory replacement is required (see P artS l iSt - c oMPonentS ). Wear gloves when handlin...

11 Using a ½" deep socket remove/reinstall the main burner orifice. Undo the two (2) screws that hold burner in the firebox. Rotate handles and remove the door and glass. Lift off the pilot head and replace with proper pilot orifice for fuel type to be used. Venturi adjustment bracket. Pilot ass...

Initial Installation QUALIFIED INSTALLERS ONLY WARNING: Operation of this heater when not connected to a properly installed and maintained venting system can result in carbon monoxide (CO) poisoning and possible death. P RePaRation F oR i nstaLLation : • Remove the packaging from the appliance, and ...

Initial Installation QUALIFIED INSTALLERS ONLY Vertical Termination Storm Collar Flashing Round Support Box/Wall Thimble Ceiling Firestop Pipelength Pipelength Cathedral Ceiling Support Box Pipelength Round Support Box/Wall Thimble Pipelength Horizontal Termination 90° Elbow Your total vent pipe len...

15 1 In accordance with the current CSA B149, Natural Gas and Propane Installation Code. 2 In accordance with the current ANSI Z223.1 NFPA 54, National Fuel Gas Code. * These numbers are only estimates. Clearance in accordance with installation codes and the requirements of the gas supplier. t A ven...

16 Initial Installation QUALIFIED INSTALLERS ONLY Wire spacers Figure 19: Wire Spacers. it to the inner wall frame using four (4) 1½” wood screws. If a wall is greater than 8” (203mm) in depth, the clearance above the flex must be 4⅜” (111mm) 6. Apply a bead of Mill-Pac Black sealant to the new Ø4” ...

Flue Pipe Adaptor Wall Framing Wall Thimble Fire Stop Exhaust 4" Flex Pipe Combusion Air 6 5 / 8 " Flex Pipe Wire Spacers Horizontal Vent Termination Initial Installation QUALIFIED INSTALLERS ONLY Figure 21: Installation of Fireplace Horizontal Vent Kit. 10. Apply a bead of Mill-Pac Black se...

18 EXCEPTION TO WARNING: This product has been evaluated by Intertek for using a Direct Vent GS starting collar in conjunction with Secure Vent, Direct-Temp, and Ameri Vent Direct venting systems. Use of these systems with the Direct Vent GS starting collar is deemed acceptable and does not affect t...

1 2 3 4 5 View showing fully open restrictor plate View showing fully closed restrictor plate 1 2 3 4 5 Figure 22: Restrictor plate settings. The ENVIRO WESTPORT has been designed with a built in restrictor plate. The restrictor is designed to enhance flame appearance when installing this unit with ...

21 Initial Installation QUALIFIED INSTALLERS ONLY Figure 28: Installing Vent Cap with Vinyl Siding Stand-Off. Figure 29: Installing Horizontal Vent Termination. wall, run a bead of non-hardening mastic around the edges, so as to make a seal between the termination and the wall. The arrow on the vent...

27 Firebox Top Flue Collar Adapter Undo four ¼" screws that hold flue collar elbow to unit. Figure 40: Step 3 of Converting Top Vented into Rear Vented. Figure 41: Step 4 of Converting Top Vented into Rear Vented. i nstaLLation oF R eaR v enteD a PPLiance : Siding Exterior wall Drywall Vent pipe...

31 Initial Installation AUTOMATIC SAFETY SHUT DOWN: If the spill switch is activated and shuts off the main burner the following procedure should be followed.• Is the pilot flame still on? If not, the reason for the fireplace shut down is not the spill switch. • Turn off the pilot flame and turn off...

Initial Installation QUALIFIED INSTALLERS ONLY g as L ine c onnection anD t esting : WARNING: Only persons licensed to work with gas piping may make the necessary gas connections to this appliance. O L I T P TP T H T P T H IN O UT H I LO N OF O F LI P T O Manifold Pressure Tap Inlet Pressure Tap Hi/...

33 Figure 51: Gas Control Valve and Optional Thermostat Wiring. Initial Installation QUALIFIED INSTALLERS ONLY e LectRicaL R equiRements F oR g as v aLve anD o PtionaL b LoweR : The ENVIRO WESTPORT will operate without electrical power. This model has a millivolt gas control, which uses the pilot fl...

Fan assembly Valve cover Control panel (Fan control location) Screw hole Figure 53: Optional Blower (Fan) Installation. Secondary Installation i nstaLLation oF o PtionaL b LoweR : 1. Remove the pre-assembled blower from the packaging. Inspect the blower for damage. If damage is noticed call your dea...

35 1. Carefully remove logs from box. Check to ensure there is no damage. It is very important to install all logs in their proper position to insure safe, optimum operating conditions. 2. Place the log set into the firebox. Locate each log by seating it down onto the burner tray support pins. Follo...

Secondary Installation CAUTION: NEVER OPERATE THIS APPLIANCE WITH THE GLASS DOOR REMOVED. Important note: When the unit is turned on for the first time, It should be turned onto high without the fan on for the first four (4) hours. This will cure the paint, logs, gasket material and the other produc...

37 Figure 63: Top brick panel in place, screws shown. Figure 64: Back brick panel in place. Figure 65: Side brick panels in place. Figure 62: Brick panel bracket, slots shown. 1. Remove the two (2) screws from the rear of the baffle, use a ¼” socket or a flat head screwdriver. Place the provided bri...

38 Trouble Shooting Problem Possible Cause Solution The main burner does not ignite when called for. The gas valve may not be on. • Check that the gas control knob is in the “ON” position. Thermostat is not calling for heat. • Adjust the thermostat several degrees above ambient temperature. Problem ...

Parts List - Components Reference Number Part Description Part Number 9 120° Ceramic Fan Temperature Sensor EC-001 10 S.I.T. Nova Valve Convertible 50-1421 11 Thermocouple EC-009 11 Spark Electrode with Ignitor Cable EC-011 11 Thermopile EC-012 11 Pilot Orifice NG Threaded EC-019 11 Pilot Orifice LP...

45 Parts Diagram - Components 13 17 16 10 27 15 26 24 9 22 11 21 25 29 20 14 19 23 12 28 18 WESTPORT - Components January 2005

46 Warranty Sherwood Industries Ltd. is the manufacturer of the Enviro line of heating products. At Sherwood Industries, our commitment to the highest level of quality and customer service is the most important thing we do. Each Enviro stove is built on a tradition of using only the finest materials...

48 Installation Data Sheet The following information must be recorded by the installer for warranty purposes and future reference. NAME OF OWNER: _________________________________________ ADDRESS: _________________________________________ _________________________________________ ___________________...