Enviro 828 MH - Manuals - manualsarea.com

Page 2 - SAFETY PRECAUTIONS; NOTE; GENERAL; Installation and repair should be done by a; Do not operate with cracked or broken; Young children should be carefully; FOR YOUR SAFETY; To prevent injury, if the pilot or pilot and

SAFETY PRECAUTIONS FOR SAFE INSTALLATION AND OPERATION OF YOUR "ENVIROGAS" ROOM HEATER, PLEASE, CAREFULLY READ THE FOLLOWING INFORMATION: • All "ENVIROGAS" gas-fired appliances must be installed in accordance with these instructions. Carefully read all the instructions in this manual...

Page 3 - ENVIROGAS 828 DIRECT VENT UNITS

TABLE OF CONTENTS 1 Code Approvals ...........................................................................................................................................3 Specifications ................................................................................................................

Page 6 - DECIDING WHERE TO LOCATE YOUR STOVE; FIREPLACE INSERT; ASSEMBLY INSTRUCTIONS; INSTALLATION; FREESTANDING

3. DECIDING WHERE TO LOCATE YOUR STOVE FREESTANDING: • Locate the stove in a large and open room that is centrally located in the house. This will optimize heat circulation and comfort. • The stove should be located out of traffic, away from furniture and draperies and should have sufficient access ...

Page 7 - Back Rail; Insert Adapter Box

FIREPLACE INSERT • Carefully clean the fireplace and flue before installing the stove. Failure to do so may result in fumes or dirt being blown into the room or insert and may cause a fire leading to death or serious injury. • If you are installing the optional fan kit, (see Installing Fan Kit) do s...

Page 9 - ELECTRICAL REQUIREMENTS; FAN INSTALLATION

2. Place the log with Burnt Area forward on log supports. Locate the log by matching the bottom pegs to the receiving holes in rear log supports. 3. Close door securely 7. ELECTRICAL REQUIREMENTS The ENVIROGAS 828 Series will operate without an external electrical power supply. This model has a Mill...

Page 10 - GAS LINE CONNECTION AND TESTING; TO TEST VALVE PRESSURES; NEVER USE AN OPEN FLAME FOR LEAK TESTING.

8. GAS LINE CONNECTION AND TESTING WARNING: Only persons licensed to work with gas piping can make the gas connections to this appliance. This appliance is equipped with a 3/8” stainless steel flex line from the valve. This line may be routed through the hole in the rear of the pedestal, or on inser...

Page 11 - AIR SHUTTER ADJUSTMENT

9. AIR SHUTTER ADJUSTMENT • There is a separate venturi air shutter for each burner • The venturies have been set for installation at sea level to 4,500 ft. • To adjust for higher altitudes : Remove the access cover plate, loosen the air shutter locking screws with a long screwdriver. Rotate the air...

Page 12 - VENT TERMINATION CLEARANCES

10. VENTING VENT TERMINATION CLEARANCES A= Clearance above grade, verandah, porch, deck, or [balcony (*12 inches (30cm) minimum] B= Clearance to window or door that may be opened [*12 inches (30cm) minimum] C= Clearance to permanently closed window [minimum 12 inches (30cm) recommended to prevent co...

Page 13 - FOR GAS STOVES. Kits are available for vertical venting or; FOLLOW THE VENT LENGTH DIAGRAM PRECISELY.; PLANNING YOUR INSTALLATION; Simpson Duravent Parts; Vertical

These models have been tested and certified for use with SIMPSON DURAVENT DIRECT VENT TYPE "GS" PIPE FOR GAS STOVE. Kits are available for vertical venting or horizontal venting. It is recommended that a bead of RTV High Temperature Silicone be applied to each vent joint before installation....

Page 14 - HORIZONTAL INSTALLATION

When planning your installation, it will be necessary to select the proper length of vent pipe for your particular requirements. It is important to note when passing through a wall, the maximum allowable wall thickness is 10-inches (254mm), 1 ½ inches clearance to combustibles must be maintained. Se...

Page 16 - VERTICAL INSTALLATION

VERTICAL INSTALLATION STEP 1. Check the instructions for required clearances (air spaces) to combustibles when passing through ceilings, walls, roofs, enclosures, attic rafters , or other nearby combustible surfaces. Do not pack air spaces with insulation. STEP 2. Set the gas appliance in the desire...

Page 19 - MOBILE HOME FUEL CONVERSION

11. MOBILE HOME FUEL CONVERSION To convert from Propane to Natural Gas or vise-versa 1. Disconnect the unit from the gas supply. 2. Open the door and remove the logset. 3. Remove the burner tray (2 screws) and the burner control assembly by removing the 8 screws holding it into the unit. 4. Remove t...

Page 20 - OPERATING INSTRUCTIONS

12. OPERATING INSTRUCTIONS FOR YOUR SAFETY READ BEFORE OPERATING WARNING: IF YOU DO NOT FOLLOW THESE INSTRUCTIONS EXACTLY, A FIRE OR EXPLOSION MAY RESULT CAUSING PROPERTY DAMAGE, PERSONAL INJURY OR LOSS OF LIFE. A) This appliance is equipped with a pilot that must be lit by hand by following these i...

Page 21 - MAINTENANCE AND TECHNICAL; OPENING THE DOOR; door is hot when in operation.; FOR CLEANING THE INSIDE OF THE FIREBOX; reverse steps 1 through 4.

13. MAINTENANCE AND TECHNICAL Periodically check to ensure that your "Direct Vent" system is clear. Periodically check the pilot and burner. Check to see that all the burner ports are clean and clear. Check the pilot head for blockage. Check to ensure the pilot flame is blue with small yello...

Page 22 - TROUBLE SHOOTING

14. TROUBLE SHOOTING Problem Possible Cause Solution Spark will not light the pilot after repeated pressing of spark ignitor Defective piezo ignitor Check connections to ignitor -If ignitor connections are good but there is no spark-replace ignitor Broken spark electrode -Check for broken ceramic in...

Page 23 - PARTS AND ACCESSORIES

15. PARTS AND ACCESSORIES Service Parts available from your local Envirogas Dealer. PART # DESCRIPTION 828-001 Convection Blower 828-002 Heyco Strain Relief 828-003 2-Speed Fan Switch 828-004 Eurosit Manually Regulated Valve, Natural Gas 828-005 Eurosit Manually Regulated Valve, Liquid Propane 828-0...

Page 25 - INSTALLATION DATA SHEET; Date of Installation:

17. INSTALLATION DATA SHEET The installer for warranty purposes and future reference must record the following information. Envirogas Models: 828.DV. FS. (Freestanding) Direct Vent Room Heater 828 DV. INS. (Insert) 828 DV. MH. (Mobile Home) Name of Owner: __________________________________________ A...