Enviro 50-1573 - Manuals - manualsarea.com

Page 2 - Table of Contents

Table of Contents 2 Introduction..............................................................................................................3 Rating Label Location......................................................................................3 Pellet Quality....................................

Page 3 - Introduction; The rating label is located on the inside of the ash pan cover.; may allow longer intervals between cleaning.

3 Introduction * This manual is designed for the home owner in conjunction with the technical manual. * R ATING L ABEL L OCATION : The rating label is located on the inside of the ash pan cover. P ELLET Q UALITY : Pellet quality is important, please read the following: Your Enviro pellet stove has b...

Page 4 - Safety Warnings & Recommendations; Caution: Do not connect to any air distribution duct or system.

4 Safety Warnings & Recommendations Please read this entire Owner’s Manual before installing or operating your ENVIRO Pellet Stove. Failure to follow these instructions may result in property damage, bodily injury or even death. Any unauthorized modification of the appliance or use of replacemen...

Page 5 - ELECTRICAL: The use of a surge protected power bar is recommended.; The unit must be; KEEP ASH PAN FREE OF RAW FUEL.; DO NOT PLACE UNBURNED OR NEW PELLET FUEL IN ASH PAN.; SAVE THIS INSTRUCTION MANUAL FOR FUTURE REFERENCE

5 Safety Warnings & Recommendations ELECTRICAL: The use of a surge protected power bar is recommended. The unit must be grounded. The grounded electrical cord should be connected to a standard 220-240 volts (2.0-2.3 Amps), 50 hertz electrical outlet and also must be accessible. If this power cor...

Page 6 - Specifications; IMPORTANT: When not installing

6 Specifications D IMENSIONS & S PECIFICATIONS : IMPORTANT: When not installing the optional Hearth Pad on the unit, the minimum requirements for protection on combustibles floors are a width of 620mm (243⁄8”) & depth of 670mm (263⁄8”) under the unit. 22 1 / 4 " (565 mm) 33 1 / 16 " ...

Page 7 - Operating Instructions; ALSO FIND THE REASONS WHY

7 Operating Instructions C ONTROL B OARD F UNCTIONS : 1. AUGER TRIM: Used to change feed rates on LOW ONLY for poorer quality fuels. Push the Auger Trim button until the number 1 and 5 lights appear on the Heat Level Indicator. This will increase the feed rate to 4 seconds ON time Auger pulse. This ...

Page 8 - ignitor tube. Check the hopper for enough pellets to start the unit.; OPERATION

O PERATING Y OUR P ELLET S TOVE : DO NOT OPERATE THE UNIT WITH THE DOOR OR ASH PAN OPEN. Keep hopper lid closed except during re-fuelling.CAUTION: When operating during adverse weather, such as high winds or freezing rain, if the unit exhibits dramatic changes in combustion stop using the unit immed...

Page 9 - to smoke escaping from the stove.; THE SLIDER / DAMPER MUST BE SET AT TIME OF INSTALLATION.

9 active flame with no black tips then the air is set for proper operation, refer to Figure 7. The combustion exhaust blower is a variable speed blower controlled by the heat output button. This blower will decrease the vacuum pressure inside the stove and as the heat output button is turned down. S...

Page 10 - Routine Cleaning and Maintenance; BURNER POT AND LINER; HEAT EXCHANGER TUBES

DOOR GLASS CLEANING (2-3 days) Cleaning of the glass must only be done when stove is cold. Open the door by lifting the handle. The glass can be cleaned by wiping down the outside and inside of the glass with a dry soft cloth. 2-3 Days / Weekly Bi-annually or 2 Tons of Fuel Burn Pot and Liner Exhaus...

Page 11 - ASH PAN AND DOOR GASKETS; DO NOT PLACE UNBURNED OR RAW

11 Routine Cleaning and Maintenance If the glass has build up that can not be removed with only the cloth, clean the glass using paper towel and a gas appliance glass cleaner, this may be purchased through most dealers. If a gas appliance glass cleaner is not available, use a damp paper towel dipped...

Page 12 - POST SEASON CLEAN-UP; operating the pellet heater.

Routine Cleaning and Maintenance EXHAUST VENT (annually) Check vent for blockage prior to lighting after a prolonged shutdown period.This vent should be cleaned every year or after two tons of pellets. We recommend contacting your dealer for professional cleaning. For basic cleaning the vent pipe, t...

Page 13 - Installation Data Sheet

13 NAME OF OWNER: _________________________________________ ADDRESS: _________________________________________ _________________________________________ _________________________________________ PHONE:___________________________________ NAME OF DEALER: _________________________________________ ADDRE...