Enviro 50-1021 - Manuals - manualsarea.com

Page 2 - Table of Contents

2 Introduction..............................................................................................................3 Pellet Quality.......................................................................................................3 Important Safety Data.....................................

Page 3 - Introduction; Pellet quality is important, please read the following:; for a recommended pellet type.; ASH; may allow longer intervals between cleaning.

3 Introduction * This manual is designed for the home owner in conjunction with the technical manual. * P ELLET Q UALITY : Pellet quality is important, please read the following: Your enviro pellet stove has been designed to burn wood pellets only. Do not use any other type of fuel, as this will voi...

Page 4 - Caution: Do not connect to any air distribution duct or system.; warranty. Check with your dealer for fuel recommendations.; THE USE OF CORDWOOD IS PROHIBITED BY LAW.; damper as needed to ensure proper combustion.

4 Introduction I MPORTANT S AFETY D ATA : Please read this entire Owner’s Manual before installing or operating your ENVIRO Pellet Stove. Failure to follow these instructions may result in property damage, bodily injury or even death. Contact your local building or fire official to obtain a permit a...

Page 5 - ELECTRICAL: The use of a surge protected power bar is recommended.; The unit must be; Never; the heater while it is in use.; KEEP ASH PAN FREE OF RAW FUEL.; performance, smoking and other side effects of poor combustion.; SAVE THIS INSTRUCTION MANUAL FOR FUTURE REFERENCE

Introduction ASHES: Disposed ashes should be placed in a metal container with a tight fitting lid. The closed container of ashes should be on a non-combustible floor on the ground, well away from all combustible materials pending final disposal. If the ashes are disposed of by burial in soil or othe...

Page 6 - Specifications

22 1 / 4 " (565 mm) 33 1 / 16 " (840 mm) 21 1 / 4 " (539 mm) 5 13 / 16 " (147 mm) 26 3 / 8 " (670 mm) 27 7 / 8 " (708 mm) 24 3 / 8 " (619 mm) When not installing the optional Hearth Pad on the unit, the minimum requirements for floor protection are a width of 24 3 / 8 ...

Page 7 - Operating Instructions; ALSO FIND

7 Operating Instructions C ONTROL B OARD F UNCTIONS : 1. AUGER TRIM: Used to change feed rates on LOW ONLY for poorer quality fuels. Push the Auger Trim button until the number 1 and 5 lights appear on the Heat Level Indicator. This will increase the feed rate to 4 seconds ON time Auger pulse. This ...

Page 8 - PRE-BURN INSTRUCTIONS; OPERATION

Operating Instructions O PERATING Y OUR P ELLET S TOVE : PRE-BURN INSTRUCTIONS : The burn pot liner holes must be clear and the liner installed properly against the ignitor tube for proper operation. Check the hopper for enough pellets to start the unit. DO NOT OPERATE THE UNIT WITH THE DOOR OR ASH ...

Page 9 - DO NOT unplug unit while Combustion fan is operating.

9 Operating Instructions T URNING Y OUR P ELLET S TOVE O FF : • MANUAL and HI / LOW mode: To turn the unit OFF, simply press the ON / OFF button. This will stop the feed of pellets. The blowers will continue to operate and cool the stove down. When cool enough, the stove will turn off. • AUTO / OFF ...

Page 10 - Routine Cleaning and Maintenance; TOOLS REQUIRED TO CLEAN UNIT:; ” wrench or socket, Brush, Soft Cloth, Vacuum with fine filter bag; BURNER POT AND LINER; tube and the ignitor cartridge.; HEAT EXCHANGER TUBES; unit to run efficiently.; ASH PAN AND DOOR GASKETS

2-3 Days / Weekly Bi-annually or 2 Tons of Fuel Burn Pot and Liner Exhaust Vent Heat Exchanger Tubes Fresh Air Intake Tube Ash Pan Blower Mechanisms Door Glass Heat Exchanger Tubes Inside Firebox Behind Firebox Liners Ash Pan and Door Gaskets All Hinges Door Latch Post Season Clean-up Routine Cleani...

Page 11 - ASH PAN; DO NOT PLACE UNBURNED; DOOR GLASS CLEANING

11 Routine Cleaning and Maintenance ASH PAN (weekly) This part is located under the burner, in the pedestal, and has a latching mechanism to secure it. To remove the ash pan, open the cover from the right hand side, unlock the latch on the pedestal cover and pull the pan out. Dump the ashes into a m...

Page 12 - EXHAUST VENT; DO NOT lubricate this motor. Check gaskets and replace if needed.; POST SEASON CLEAN-UP; operating the pellet heater.; BRICK PANEL; in no way covered by warranty.; DOOR GLASS REPLACEMENT

Routine Cleaning and Maintenance EXHAUST VENT (biannually) This vent should be cleaned every year or after two tons of pellets. We recommend contacting your dealer for professional cleaning. To clean the vent pipe, tap lightly on the pipe to dislodge any loose ash. Open the bottom of the “T” to dump...

Page 13 - Warranty; WHEN FILING A WARRANTY CLAIM PLEASE COMPLETE THE FOLLOWING

13 Warranty Sherwood Industries Ltd. gives a five year limited warranty on all steel manufactured parts. A one-year warranty is provided on all electrical components. The above limited warranties are extended only to the original purchaser. There is no warranty on the following parts: ● Fiberglass r...

Page 14 - Installation Data Sheet

14 NAME OF OWNER: _________________________________________ ADDRESS: _________________________________________ _________________________________________ _________________________________________ PHONE:___________________________________ NAME OF DEALER: _________________________________________ ADDRE...