Enviro 1700 - Manuals - manualsarea.com

Page 2 - Table of Contents

Table of Contents 2 Safety Precautions.............................................................................................3 Operating Instructions........................................................................................4 Building Your Fire........................................

Page 3 - Safety Precautions; FOR SAFE INSTALLATION AND OPERATION OF YOUR “ENVIRO” WOOD

3 Safety Precautions FOR SAFE INSTALLATION AND OPERATION OF YOUR “ENVIRO” WOOD STOVE, PLEASE CAREFULLY READ THE FOLLOWING INFORMATION: ● Please read this entire manual before you install and use your new woodstove. Failure to follow instructions may result in property damage, bodily injury or even d...

Page 4 - Operating Instructions; FIRST START; ash can be used in the garden or compost.; CLEANING THE PLATED SURFACES:; stain on plated finishes.; To avoid this, give the face a quick wipe with denatured alcohol on; Never clean the door when it is hot. Do not use other; FIRE EXTINGUISHER AND SMOKE DETECTION:

Operating Instructions FIRST START When first installed, the chimney, firebricks and steel are cold and it usually takes several hours on a fairly high burn for them to become hot and dry enough for the stove to function well. We recommend during the unit’s first burn that a door and window are open...

Page 5 - CHIMNEY FIRE, WHICH COULD DAMAGE THE CHIMNEY OR CAUSE A HOUSE FIRE.; away from heater while it is in use.

CREOSOTE - ITS FORMATION AND REMOVAL: When wood is burned slowly, it may produce tar and other vapors that, combined with moisture, form creosote. These vapors condense in the relatively cooler chimney flue of a slow burning fire and, if ignited, make an extremely hot fire. Therefore, the smoke pipe...

Page 6 - DO NOT OVERLOAD THE STOVE.; Helpful Hints Worth Repeating; Helpful advice on the correct way to start your fire.

6 Operating Instructions d) Regulate the heat output of the stove by adjusting the air controls to allow a larger fire and vice versa. A short period of experimentation with the control settings will allow you to regulate the heat output to keep your home comfortable. Do not use a grate or elevate t...

Page 7 - to always open the door slowly between placing wood into the fire.; What type of wood is best to use as firewood?; column gauge can be used to reference this amount.

7 Operating Instructions to always open the door slowly between placing wood into the fire. h) Once the wood has started to ignite and the smoke has reduced, close the wood stove door fully. The reduction of smoke is a good indication that the draft in the chimney has started and good combustion is ...

Page 8 - Note

8 Operating Instructions 8. What can cause a poor draft? The most common factors for poor draft are:a) Air supply b) Environmental conditions c) Cold chimney temperatured) Poor chimney installation and maintenancee) Atmospheric pressure a) Air supply – Inside the home, normal household appliances su...

Page 10 - Specifications

Specifications 1200 S PECIFICATIONS : Model 1200 Freestanding 1200 Insert Flat Top Step Top Width x Depth 25” x 22 7 / 16 ” (635 mm x 570 mm) 273⁄4” x 211⁄2” (705 mm x 546 mm) Height with pedestal or legs 28 1⁄4” (718mm) 31 1⁄4” (794 mm) Height of body 18 1⁄4” (464 mm) 21 1⁄4” (540 mm) 19 1 / 16 ” (...

Page 13 - MAINTAIN THESE MINIMUM CLEARANCES TO UNSHIELDED COMBUSTIBLES*; a NON-COMBUSTIBLE hearth pad

Specifications C LEARANCES T O C OMBUSTIBLES - 1200 F REESTANDING : MAINTAIN THESE MINIMUM CLEARANCES TO UNSHIELDED COMBUSTIBLES* Single Wall Pipe Double Wall Pipe** Double Wall Pipe with Heat Shield (Flat top model only) Top vent out back wall with min. 48” (1220 mm) vertical rise; double wall A Fr...

Page 19 - Installation

19 Installation Please read and understand these instructions before installing pedestal or ash pan and leg option. Failure to follow these instructions carefully could cause personal injury or property damage. All screws are pre-installed on the base of the unit. R EMOVAL F ROM P ALLET : • Place th...

Page 21 - Fresh air connection to the unit must be a non-combustible pipe,

21 Installation O UTSIDE A IR K IT : It is mandatory to use outside air for installations in mobile homes.A 4” (10.2 cm) fresh air adaptor kit is available. This adaptor can be installed either on the back pedestal or through the floor under the pedestal. The cover plate must be installed on the uni...

Page 23 - A L; explicitly. Also refer to “; Set floor protector and stove in location in accordance with the “

23 Installation I NSTALLATION OF A L ISTED , F ACTORY B UILT C HIMNEY - F REESTANDING : This is a generic set of instructions; always follow the chimney manufacturer’s instructions explicitly. Also refer to “ R ECOMMENDED H EIGHTS F OR F LUE P IPE ” . 1. Set floor protector and stove in location in ...

Page 24 - IMPORTANT

Installation Hearthpad Floor Pedestal Woodstove Optional fan Outside air connection through wall or floor Chimney connector Ceiling Insulated chimney Roof flashing Roof Roof radiation shield (if required) Minimum air space in accordance with chimney manufacturer. Wall support Chase (optional) Insula...

Page 25 - ” or “; Consult the chimney connector manufacturer and

25 Installation M ASONRY C HIMNEY I NSTALLATION - F REESTANDING : DO NOT CONNECT THIS UNIT TO A CHIMNEY FLUE SERVING ANOTHER APPLIANCE. A non-combustible floor protector is required under all freestanding units; refer to “ C LEARANCES T O C OMBUSTIBLES - 1200 F REESTANDING ” or “ C LEARANCES T O C O...

Page 26 - The existing damper; SPECIAL REQUIREMENTS:

Floor Protection Combustible Floor Masonry Fireplace Rain Cap Steel Plate or Flashing Rigid Stainless Steel Liner Damper Removed or Fastened Open Clean-out tee Chimney Support and Clamp Clean-out cover Flexible Stainless Steel Section Stainless Steel Connector Pipe Listed Liner Stove pipe must end h...

Page 27 - WARNING: DO NOT INSTALL IN A MOBILE HOME SLEEPING ROOM.; THE STRUCTURAL INTEGRITY

27 At least 3 feet (914 mm) Hearthpad Floor Pedestal Woodstove Optional fan Outside air connection through wall or floor Double wall pipe Ceiling support Ceiling Spark arrestor cap Roof flashing Roof Radiation Shield Insulated chimney Bolt stove to floor Figure 28: Freestanding installation into mob...

Page 28 - professional installer.; before installing the unit. Refer to “

Installation M ASONRY F IREPLACE I NSTALLATION - I NSERT : Unless you are experienced, we recommend installation by your dealer or a professional installer. It is recommended that you install the decorative plates (if purchased) into the shrouds before installing the unit. Refer to “ I NSTALLATION O...

Page 30 - USA O

30 Installation Figure 33: Attaching removable flue. Figure 34: Leveling leg. S URROUND P ANEL S EALED I NSTALLATION F OR USA O NLY - I NSERT : Before starting this type of installation refer to I NSTALLATION - M ASONRY F IREPLACE I NSTALLATION - I NSERT for additional information. For clearances re...

Page 31 - A B; NOTE

31 Installation I NSTALLATION U SING A B LOCK -O FF P LATE F OR USA O NLY - I NSERT : If this unit is to be installed into a masonry fireplace or a zero-clearance fireplace with a direct connection you must install a non-combustible seal-off device such as a block-off plate or damper adapter. By ins...

Page 33 - side of the back of the firebox.

Installation M ODEL 1200 B RICK P LACEMENT : COMPLETE THE STOVE AND SMOKE PIPE INSTALLATION BEFORE PLACING THESE BRICKS. 1. Place the three (3) full size bricks along each side of the firebox and one (1) full size brick on either side of the back of the firebox. 2. To place the floor bricks, lay the...

Page 35 - DO NOT USE DOOR IF GLASS IS BROKEN.

35 Installation D OOR I NSTALLATION : Please inspect all components for damage. If damage has occurred, please contact the courier company, dealer, or distributor and have components repaired or replaced before installation. Remove the door from the packaging. Inspect the door assembly for damage. 1...

Page 36 - DO NOT

C ERAMIC B AFFLE I NSTALLATION : 1. Remove the front secondary air tube by placing a screwdriver (any style except flat head) into one of Left Ceramic Baffle Right Ceramic Baffle Figure 45: Installation of Ceramic Baffle. �� ...

Page 38 - Remove the shroud from the unit (refer to “

Figure 50: Changing decorative plate. Installation R EMOVAL O F T HE S HROUDS - I NSERT : 1. If the surround panel is installed, remove it by lifting the panel straight up then out. 2. For the right shroud, twist the handle on the air control clockwise to remove it from the rod. 3. Pull unit forward...

Page 40 - Parts List

Parts List Referance Number Description Part Number 1 120°F (49°C) Ceramic Fan Temperature Sensor EC-001 2 Domestic power cord - 115V EC-042 Convection Blower - 115V (Freestanding) EC-069 3 Fan Controller with Knob - 115V EF-045 4 Door Gasket - 7 feet (2.13m) EF-168 Fresh Air Kit EF-186 5 One Leg - ...

Page 42 - Parts Diagram - Freestanding

Parts Diagram - Freestanding 31 30 34 35 29 28 33 32 15 17 19 18 46 25 44 4 27 7 9 26 14 2 1 6 17 21 20 23 22 24 43 45 8 16 K od ia k -F re es ta nd in g C om po ne nt s O ct ob er 20 04 42

Page 44 - Parts Diagram - Fireplace Insert; Common parts are shown in

Parts Diagram - Fireplace Insert 49 15 53 54 47 8 50 48 51 52 54 42 2 3 K od ia k -F ire pl ac e In se rt C om po ne nt s O ct ob er 20 04 Common parts are shown in Parts Diagram - Freestanding. 44

Page 45 - Warranty; Sherwood Industries Ltd. Limited Lifetime Warranty; years of unequalled performance and quality.; How the Warranty Works

45 Warranty Sherwood Industries Ltd. Limited Lifetime Warranty Sherwood Industries Ltd. is the manufacturer of the Enviro line of heating products. At Sherwood industries, our commitment to the highest level of quality and customer service is the most important thing we do. Each Enviro stove is buil...

Page 46 - description of the problem.; Exclusions and Limitations:; per our warranty service fee reimbursement schedule.

Warranty 6. If the problem is not covered by the Limited Warranty, the customer will be responsible for all repair costs, as well as all storage, shipping and the cost of removing and re-installing the stove. 7. If you are not satisfied with the service provided by the Enviro dealer, write to Sherwo...

Page 48 - Installation Data Sheet; INSTALLER’S SIGNATURE:

48 Installation Data Sheet The following information must be recorded by the installer for warranty purposes and future reference. NAME OF OWNER: _________________________________________ ADDRESS: _________________________________________ _________________________________________ ___________________...