Page 2 - SAFETY WARNING
TABLE OF CONTENTS • PLEASE READ AND SAVE INSTRUCTIONS SAFETY WARNING 2 • OPERATING INSTRUCTIONS 3-4 • • PEDESTAL INSTALLATION 5 • BRICK INSTALLATION • MODEL 1000 6 • MODEL 1600 INSERT 7 • MODEL 2100 8 • FREESTANDING INSTALLATION 9-10 • MOBILE HOME INSTALLATION 11 • FIREPLACE INSERT INSTALLATION 12 •...
Page 3 - OPERATING INSTRUCTIONS; FOR MAXIMUM EFFICIENCY:
OPERATING INSTRUCTIONS STARTING: Place crumpled paper on the stove floor and cover with kindling. Open the draft fully and ignite. Hold the door slightly a jar for a few minutes and then close tightly. After the wood is burning brightly add more dry wood and, when the fire is hot, use the draft cont...
Page 4 - FAILURE TO INSPECT AND CLEAN YOUR CHIMNEY
DISPOSAL OF ASHES: If you let the ashes accumulate two or three inches on the floor they tend to burn themselves up. Open the small trap door located on the floor of the unit. Push the ashes that have accumulated into the hole were the ashes would drop into the ash pan. Ensure that the trap door is ...
Page 5 - PEDESTAL AND LEG INSTALLATION; PEDESTAL
PEDESTAL AND LEG INSTALLATION Please read and understand these instructions before installing ash pan and leg option. Failure to follow these instructions carefully could cause personal injury or property damage. All screws are pre installed on the base of the unit. PEDESTAL • Remove the bricks from...
Page 6 - MODEL 1000 BRICK PLACEMENT:; REMOVE CEILING BRICKS AND CLEAN ABOVE THEM ONCE A
MODEL 1000 BRICK PLACEMENT: COMPLETE THE STOVE AND SMOKE PIPE INSTALLATION BEFORE PLACING THESE BRICKS. 1. Place the bottom layers of the sides and back of the firebox. 2. Place the floor bricks. The spaces between the bricks will soon fill with ashes. 3. Finish the sides and back ready to accept th...
Page 7 - MODEL 1600 BRICK PLACEMENT:
MODEL 1600 BRICK PLACEMENT: COMPLETE THE STOVE AND SMOKE PIPE INSTALLATION BEFORE PLACING THESE BRICKS. 1. Place the bottom layers of the sides and back of the firebox. 2. Place the floor bricks. The spaces between the bricks will soon fill with ashes. 3. Finish the sides and back ready to accept th...
Page 8 - MODEL 2100 BRICK PLACEMENT:
MODEL 2100 BRICK PLACEMENT: COMPLETE THE STOVE AND SMOKE PIPE INSTALLATION BEFORE PLACING BRICKS. 1. Place the bottom layers of the sides and back of the firebox. 2. Place the floor bricks. The spaces between the bricks will soon fill with ashes. 3. Finish the sides and back ready to accept the top,...
Page 9 - FREESTANDING; DO NOT CONNECT THIS UNIT TO A
FREESTANDING INSTALLATION: CHIMNEY: Vent the stove into a clean, lined, approved masonry chimney in good condition, conforming to local building codes or a listed 6” factory built chimney suitable for use with solid fuels and conforming to, ULC-S629 in CANADA or UL-103HT in the U.S.A.. Connect the s...
Page 10 - TO INSTALL A LISTED, FACTORY BUILT CHIMNEY.
OUTSIDE AIR: Pedestal rear A 4” (10.16 cm) fresh air adapter kit is available. This adapter can be installed either on the back pedestal or through the floor under the pedestal. Place the 1/4” mesh screen between the fresh air adapter and the body of the pedestal. (AS SHOWN) NOTE: Fresh air connecti...
Page 11 - MOBILE HOME INSTALLATION; DO NOT INSTALL IN A MOBILE HOME SLEEPING ROOM.
MOBILE HOME INSTALLATION SPECIAL REQUIREMENTS: Pedestal models 1000 and 1600 are approved for mobile homes. All freestanding installation requirements on the preceding page plus the following must be met: VENTING: In Canada: Any ULC-629 listed chimney system with the accompanying double wall vent co...
Page 12 - MODEL 1600 INS FIREPLACE INSERT; REQUIRED CLEARANCES TO COMBUSTIBLES FROM INSERT:
MODEL 1600 INS FIREPLACE INSERT Unless you are experienced, we recommend installation by your dealer or a professional installer. Install only in a masonry fireplace at least 25” (635 mm) wide, 22” (560 mm) high and 14” (356 mm) deep with an approved lined chimney at least 15 ft (4.6 m) high, both o...
Page 13 - HOW IT WORKS
HOW IT WORKS SPECIFICATIONS: MODEL 1000 MODEL 1600 MODEL 1600fpi MODEL 2100 WIDTH X DEPTH 24 X 21” (.61 X .53 M) 24 X 25.5” (.61 X ..64 M) 24 X 25.5” (.61 X ..64 M) 24 X 30” (.61 X .76 M) HEIGHT ON PEDESTAL 33 “ (.83 M) 33 “ (.83 M) N/A 33 “ (.83 M) HEIGHT OF BODY 22” (.56 M) 22” (.56 M) 22” (.56 M)...
Page 14 - DOOR INSTALLATION
DOOR INSTALLATION Remove the door from the packaging. Inspect the door assembly for damage. DO NOT USE DOOR IF GLASS IS BROKEN. Place the door assembly on the two hinge pins mounted on the body of the unit. Open and close the door, applying pressure down, to ensure the door assembly is properly seat...
Page 15 - OPTIONAL FAN INSTALLATION; CAUTION; WIRING DIAGRAM
OPTIONAL FAN INSTALLATION The appliance when installed, must be electrically connected and grounded in accordance with local codes or in the absence of local codes, with the current CSA C22.1 CANADIAN ELECTRICAL CODE. Part 1, SAFETY STANDARDS FOR ELECTRICAL INSTALLATIONS, or THE NATIONAL ELECTRICAL ...
Page 17 - PARTS AND ACCESSIORIES
PARTS AND ACCESSIORIES PLEASE CONTACT YOUR LOCAL ENVIROFIRE DEALER WHEN REPLACEMENT PARTS ARE REQUIRED. EF-163 WOOD STOVE PAINTED DOOR EF-164 WOOD STOVE GOLD DOOR EF-165 1600 FPI PANEL SET (REGULAR) EF-166 1600 FPI PANEL SET (OVERSIZE) EF-167 FAN KIT (1000, 1600, 2100, (FREESTANDING ONLY) EF-168 DOO...
Page 18 - WARRANTY; WHEN FILING A WARRANTY CLAIM PLEASE COMPLETE THE FOLLOWING; WEB SITE ADDRESS
WARRANTY Because of our high standards Sherwood Industries Ltd. can offer a *Lifetime Warranty on all it’s wood products. Covered under this warranty are Cabinet Sides, Tops, Pedestals, Surround Panels, Removable Air Channel, and Chassis. These steel components are covered against manufacture’s defe...
Page 19 - WOOD STOVE
SET OF FOUR (4) LEGS W/ ASH PAN EF 1000 PAINTED -EFW 250 GOLD -EFW 251 NICKEL- EFW 252 EF 1600-2100 PAINTED- EFW-265 GOLD- EFW-267 NICKEL- EFW-269 SPRING HANDLE GOLD 10-006 NICKEL 10-007 GLASS W/ TAPE 10-000 CAST DOOR W/ GLASS PAINTED EFW-258 GOLD EFW-259 NICKEL EFW-260 DOOR HANDLE ASSEMBLY 10-001 S...