Enterasys Networks C2RPS-POE - Manuals

Enterasys Networks C2RPS-POE – Manual in PDF format online.

Manuals:

Manual

Manual Enterasys Networks C2RPS-POE

Summary

Page 3 - Notice; Documentation

i Notice Enterasys Networks reserves the right to make changes in specifications and other information contained in this document and its web site without prior notice. The reader should in all cases consult Enterasys Networks to determ...

Page 4 - Regulatory Compliance Information

ii Regulatory Compliance Information Federal Communications Commission (FCC) Notice This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and ...

Page 5 - VCCI Notice

iii Electromagnetic Compatibility (EMC) This product complies with the following: 47 CFR Parts 2 and 15, CSA C108.8, 89/336/EEC, EN 55022, EN 61000 ‐ 3 ‐ 2, EN 61000 ‐ 3 ‐ 3, EN 55024, AS/NZS CISPR 22, VCCI V ‐ 3. Compatibilidad Electromágnetica (EMC) Este...

Page 6 - Declaration of Conformity

iv Declaration of Conformity Application of Council Directive(s): 89/336/EEC73/23/EEC Manufacturer’s Name: Enterasys Networks, Inc. Manufacturer ’s Address: 50 Minuteman Road Andover, MA 01810 USA European Representative Address: Enterasys Networks, Ltd. Nexus House, Newb...

Page 7 - Firmware License Agreement

v Enterasys Networks, Inc. Firmware License Agreement BEFORE OPENING OR UTILIZING THE ENCLOSED PRODUCT, CAREFULLY READ THIS LICENSE AGREEMENT. This document is an agreement (“Agreement”) between the end user (“You”) and Enterasys Networks, Inc. on beha...

Page 9 - AUDIT

vii 8. AUDIT RIGHTS. You hereby acknowledge that the intellectual property rights associated with the Program are of critical value to Enterasys and, accordingly, You hereby agree to maintain complete books, records and accounts showing (...

Page 11 - Contents; About this Guide

ix Contents About this Guide Using This Guide ................................................................................................................................. xiStructure of This Guide .....................................................................................................

Page 12 - Tables

x Tables 1-1 Powered Device (PD) PoE Power Classifications..................................................................1-3 2-1 Contents of N-POE Chassis Carton .......................................................................................2-2 2-2 C2RPS-POE Status LED Indications and Rec...

Page 13 - Using This Guide; Chapter 1; Introduction; Chapter 2; Installation; Appendix A; Specifications

SecureStack C2 Installation Guide xi About this Guide This guide provides an overview, installation and troubleshooting instructions, and specifications for the Enterasys SecureStack C2RPS ‐ POE power supply, which can provide a redundant power source ...

Page 14 - Using the SecureStack C2 Manual Set; SecureStack; The C2RPS-POE power supply does not support non-PoE compliant

Using the SecureStack C2 Manual Set xii About this Guide Using the SecureStack C2 Manual Set Other manuals have been developed for the SecureStack C2 PoE switch devices that can be connected to the C2RPS ‐ POE power supply for power redundancy. The Sec...

Page 15 - Conventions Used in This Guide; Elektrischer Gefahrenhinweis:

Conventions Used in This Guide SecureStack C2 Installation Guide xiii Conventions Used in This Guide The following conventions are used in this guide: Note: Calls the reader’s attention to any item of information that may be of special importance. Caution: Contains information essentia...

Page 17 - This; Power Classifications and Deployment

SecureStack C2 Installation Guide 1-1 1 Introduction This chapter provides the following information: For information about... Refer to page... C2RPS-POE Overview 1-2 C2RPS-POE Status LED 1-2 Power Classifications and Deployment 1-2 Getting Help 1-4

Page 18 - Figure 1; Status LED; Table 1; LED status indicator

C2RPS-POE Overview 1-2 Introduction C2RPS-POE Overview The purpose of the C2RPS ‐ POE is to provide power backup to an Enterasys SecureStack C2 PoE ‐ compliant stackable switch. If for some reason the switch looses power from its internal pow...

Page 19 - Figure 1-2 Example of a C2RPS-POE Power Configuration

Power Classifications and Deployment SecureStack C2 Installation Guide 1-3 The number of PDs that can be supported by the connected SecureStack PoE switch can be estimated by adding up the maximum power requirement of each connected PD accordin...

Page 20 - Getting Help; World Wide Web

Getting Help 1-4 Introduction The SecureStack PoE switch has six of its PoE/data ports connected to PDs with the following Class ratings: • One does not support PoE (no power) • One has no Class rating (Defaults to Class 0, 12.95 Wa...

Page 21 - Required Tools; Solamente personal calificado debe realizar procedimientos de; Installationen sollten nur durch ausgebildetes und

SecureStack C2 Installation Guide 2-1 2 Installation This chapter provides the installation instructions to install all the components of a C2RPS ‐ POE. To correctly install the C2RPS ‐ POE, follow the order of information listed below. Required Tools ...

Page 22 - Unpacking the C2RPS-POE; Table 2-1 Contents of N-POE Chassis Carton

Unpacking the C2RPS-POE 2-2 Installation Unpacking the C2RPS-POE To unpack the C2RPS ‐ POE, proceed as follows: 1. Open the box and remove the packing material protecting the devices. 2. Verify the contents of each carton and compare the contents s...

Page 23 - Installing the Rubber Feet; Bottom, Rubber Feet Placement; Locations to install the rubber feet (4 locations)

Installing the C2RPS-POE on a Flat Surface SecureStack C2 Installation Guide 2-3 Installing the Rubber Feet To install the rubber feet, refer to Figure 2 ‐ 1 and proceed as follows: 1. Place the C2RPS ‐ POE on its back on a sturdy flat surface to gain ...

Page 24 - Guidelines for Installation; Figure 2-2 Area Guidelines for C2RPS-POE; Para asegurar una buena ventilación y evitar que el sistema se

Installing the C2RPS-POE on a Flat Surface 2-4 Installation Guidelines for Installation Locate the C2RPS ‐ POE within 152 cm (5 ft) of its power source and on a surface as shown in Figure 2 ‐ 2 . If the switch is being installed as a standalone ...

Page 25 - Rack Mounting the C2RPS-POE; Guidelines for Rackmount Installation; electronic equipment.

Rack Mounting the C2RPS-POE SecureStack C2 Installation Guide 2-5 Rack Mounting the C2RPS-POE To install the switch in a 19 ‐ inch rack, you need: • Two rackmount brackets and mounting screws (rackmount kit) shipped with the switch. • Four user ‐ supplied ...

Page 26 - Attaching Brackets and Installing in Rack; Figure 2-3 Attaching the Rackmount Brackets; Rails of 19-inch rack

Rack Mounting the C2RPS-POE 2-6 Installation Attaching Brackets and Installing in Rack Proceed as follows to install the switch into a 19 ‐ inch rack: 1. Attach the rackmount brackets to the switch, as shown in Figure 2 ‐ 3 , using the eight M3 x 6 m...

Page 27 - Connecting C2RPS-POE Cable and AC; Status LED Indications and Recommended Actions; Solid

Connecting C2RPS-POE Cable and AC Power Cord SecureStack C2 Installation Guide 2-7 Connecting C2RPS-POE Cable and AC Power Cord The C2RPS ‐ POE is connected to the SecureStack PoE switch using a C2RPS ‐ POE cable, as follows: 1. Connect one end of the C2RPS ‐ ...

Page 28 - Getting; AC power plug

Connecting C2RPS-POE Cable and AC Power Cord 2-8 Installation If you need additional help, contact Enterasys Networks. Refer to “ Getting Help ” on page 1 ‐ 4 for instructions. Figure 2-5 C2RPS-POE Cable Figure 2-6 Power Connector on C2RPS-POE (rear view) 1 AC power p...

Page 29 - Figure 2-7 C2RPS-POE Cable and AC Power Cord Connections; Switch device

Connecting C2RPS-POE Cable and AC Power Cord SecureStack C2 Installation Guide 2-9 Figure 2-7 C2RPS-POE Cable and AC Power Cord Connections If you need additional help, contact Enterasys Networks. Refer to “ Getting Help ” on page 1 ‐ 4 for instructions. 1 Switch device...

Page 31 - C2RPS-POE Specifications; DC Output

SecureStack C2 Installation Guide A-1 A Specifications This appendix provides information about the following: Enterasys Networks reserves the right to change the specifications at any time without notice. C2RPS-POE Specifications The following sections de...

Page 32 - C2RPS-POE Redundant Power Supply Output Connector; Figure A; Physical; Dimensions; Environmental; Operating Temperature; Item

C2RPS-POE Redundant Power Supply Output Connector A-2 Specifications C2RPS-POE Redundant Power Supply Output Connector For pin location and function, refer to Figure A ‐ 1 and Table A ‐ 2 , respectively. Figure A-1 C2RPS-POE Redundant Power Supply Connector Pin Locations Physic...

Page 33 - Compliance Standards; Table A; Pin Number

Compliance Standards SecureStack C2 Installation Guide A-3 Compliance Standards The C2RPS ‐ POE meets the safety and electromagnetic compatibility (EMC) requirements listed in Table A ‐ 3 : Table A-2 C2RPS-POE Redundant Power Supply Connector Pin Functions Pin Number Function...