Empire Comfort Systems VFSR-16-3 - Manuals

Page 6 14008-0-0403 GENERAL INFORMATION This is an unvented gas-fired heater. It uses air (oxygen) from theroom in which it is installed. Provisions for adequate combustionand ventilation air must be provided. Keep room area clear and free from combustible materials,gasoline and other flammable vapo...

Page 7 14008-0-0403 PROVISIONS FOR ADEQUATE COMBUSTION & VENTILATION AIR Minimum Dimensions For Solid Fuel Burning FireplacesUL127 Factory Built Fireplaces (Figure 2) Model A B C D VFSV-16 18" 11 1/2" 24" 18" VFSR-16 18" 11 1/2" 24" 18" VFSV-18 17" 14" 28&...

Page 8 14008-0-0403 Sidewall & Ceiling Clearances (Figure 3) Figure 3 The sides of the fireplace opening must be 6" from any combustiblewall. The ceiling must be at least 36" (for the 16" log) and 41" (for 18",24" and 30" logs) from the fireplace opening. Mantel Clear...

Page 9 14008-0-0403 FIREPLACE PREPARATION • Turn off gas supply to fireplace or firebox. • Have the fireplace floor and chimney professionally cleaned to removeashes, soot, creosote or other obstructions.Have this cleaning performed annually after installation. • Seal any fresh air vents or ash clea...

Page 11 14008-0-0403 GAS SUPPLY Check all local codes for requirements, especially for the size andtype of gas supply line required. Recommended Gas Pipe Diameter Pipe Length Schedule 40 Pipe Tubing, Type L (Feet) Inside Diameter Outside Diameter Nat. L.P. Nat. L.P. 0-10 1/2" 3/8" 1/2" 3...

Page 13 14008-0-0403 Flames from the pilot (rear right back side of the pan burner) aswell as the main flame should be visually checked as the log setis installed. In normal operation at full rate after 10 to 15 minutes, the flameappearance should be sets of yellow flames. NOTE: all flames will be r...

Page 14 14008-0-0403 HI/LOREGULATOR CONTROLKNOB PIEZOIGNITOR FOR YOUR SAFETY READ BEFORE LIGHTING WARNING: If you do not follow these instructions exactly, a fire or explosion may result causing property damage, personal injury or loss of life. A. This appliance has a pilot which must be lighted by ...

Page 16 14008-0-0403 Figures 15 and 18 show a correct pilot flame pattern. The correctflame will be blue and will extend beyond the thermocouple. Theflame will surround the thermocouple just below the tip. A slightyellow flame may occur where the pilot flame and main burnerflame meet. Figures 16 and...

Page 17 14008-0-0403 Annual inspection and cleaning by your dealer or qualifiedservice technician is recommended to prevent malfunctionand/or sooting. TURN OFF HEATER AND ALLOW TO COOL BEFORECLEANING.Remove logs, handling carefully by holding gently at each end.Gloves are recommended to prevent skin...

Page 18 14008-0-0403 WIRING Label all wires prior to disconnection when servicing controls.Wiring errors can cause improper and dangerous operation. Verifyproper operation after servicing. 16", 18", 24" and 30" Gas Logs (Millivolt) thermopile is selfpowered gas valve and does not req...

Page 19 14008-0-0403 If the gas quality is bad, your pilot may not stay lit, the burners may produce soot and the heater may backfire when lit. If the gas quality orpressure is low, contact your local gas supplier immediately. 1. When ignitor button is pressed, there is no spark at ODS/pilot.a. Igni...

Page 20 14008-0-0403 Index Part No. Number Description COMMON PARTS 1 15425 REAR LOG SUPPORT (16) 1 15426 REAR LOG SUPPORT (18) 1 15427 REAR LOG SUPPORT (24) 1 15428 REAR LOG SUPPORT (30) 2 11285 BURNER SUPPORT - LEFT (16) 2 11376 BURNER SUPPORT - LEFT(18,24,30) 3 11273 GRATE (2 REQ’D) (16) 3 11370 ...

Page 21 14008-0-0403 PARTS VIEW Parts can be ordered only through your service person or dealer. For best results, the service person or dealer should order parts through the distributor.Parts can be shipped directly to the service person/dealer. All parts listed in the Parts List have a Part Number...